Manual Bunn IC3B

9 pages 0.2 mb
Download

Go to site of 9

Summary
  • Bunn IC3B - page 1

    IC3 & IC3B ON HALF OFF FULL START READY ON HALF OFF FULL START READY INST ALLA TION & OPERA TING GUIDE BUNN-O-MA TIC CORPORA TION POST OFFICE BO X 3227 SPRINGFIELD , ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 T o ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Progra ...

  • Bunn IC3B - page 2

    Page 2 10792 080112 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal ser vers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor . 2) All ...

  • Bunn IC3B - page 3

    Page 3 INTRODUCTION This equipment will brew a batch of fresh coffee into an awaiting vessel and dispense at approximately room tempera- ture to conserve ice. The brewer is only for indoor use on a sturdy counter or shelf and requires a minimum of 33 inches of clearance above the counter . USER NOTICES The notices on this brewer should be kept in g ...

  • Bunn IC3B - page 4

    Page 4 Electrical Hook-Up CAUTION – Improper electrical installation will damage electronic components. 1. An electrician must provide electrical service as specified. 2. Remove the top lid and rotate the control thermostat knob fully counter clockwise to the “OFF” position and reinstall the top lid. 3. Remove the rear trunk panel, feed the ...

  • Bunn IC3B - page 5

    Page 5 PLUMBING REQUIREMENTS This brewer must be connected to a cold water system with operating pressure between 30 (207 kPa) and 90 psi (620 kPa) from a 1 ⁄ 2 " or larger supply line. A shut-off valve should be installed in the line before the brewer . Install a regulator in the line when pressure is greater than 90 psi(620 kPa) to reduce ...

  • Bunn IC3B - page 6

    Page 6 10792 050405 INITIAL SET -UP 1. Remove the top lid from the brewer . 2. Rotate the control thermostat knob fully counterclockwise to the “OFF” position and replace the top lid. 3. Insert an empty funnel into the funnel rails. 4. Place an empty dispenser on the brewer base. Be prepared to empty the dispenser during these initial steps. 5. ...

  • Bunn IC3B - page 7

    Page 7 ADJUSTING BREW VOLUMES CAUTION - Disconnect the power source from the brewer prior to the removal of any panel for the replacement or adjustment of any component. NOTE: Prior to setting or modifying batch sizes, check that the brewer is connected to water supply , the tank is properly filled, and a funnel and server are in place. 1. Modifyi ...

  • Bunn IC3B - page 8

    Page 8 10792 072408 OPERA TING CONTROLS A. Lighted On/Off Switch ON - Placing the switch in the lighted upper position allows the start switch to activate a brew cycle. OFF - Placing the switch in the lower position stops the brew cycle. Stopping a brew cycle after it has been started will not stop the flow of water into the funnel until the tank ...

  • Bunn IC3B - page 9

    Page 9 FULL/HALF SW 4 2 READY INDICA TOR SW . & THERMOS TAT SCHEMA TIC WIRING DIAGRAM IC3 BLK BLK GRN TA NK HEA TER RED 10793.0000B 01/07 ©1994 BUNN-O-MA TIC CORPORA TION 120/208 VOL TS AC OR 120/240 VOL TS AC 3 WIRE + GND SINGLE PHASE BLU BLK WHI/RED WHI/YEL WHI/ORA 1 BREW TIMER 3 5 WHI/GRN SOL BLK WHI WHI BLU WHI/RED WHI/RED ST ART SW ON/OFF ...

Manufacturer Bunn Category Beverage Dispenser

Documents that we receive from a manufacturer of a Bunn IC3B can be divided into several groups. They are, among others:
- Bunn technical drawings
- IC3B manuals
- Bunn product data sheets
- information booklets
- or energy labels Bunn IC3B
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bunn IC3B.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bunn IC3B, service manual, brief instructions and user manuals Bunn IC3B. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bunn IC3B.

Similar manuals

A complete manual for the device Bunn IC3B, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bunn IC3B by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bunn IC3B.

A complete Bunn manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bunn IC3B - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bunn IC3B, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bunn IC3B, that we can find in the current document
3. Tips how to use the basic functions of the device Bunn IC3B - which should help us in our first steps of using Bunn IC3B
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bunn IC3B
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bunn IC3B in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bunn IC3B?

Use the form below

If you did not solve your problem by using a manual Bunn IC3B, ask a question using the form below. If a user had a similar problem with Bunn IC3B it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)