Manual Tanaka AST-210

21 pages 0.67 mb
Download

Go to site of 21

Summary
  • Tanaka AST-210 - page 1

    Owner’ Owner’ Owner’ Owner’ Owner’ s Man s Man s Man s Man s Man ual ual ual ual ual Model Numbers: AST-210, AST-5000 AST-210, AST-5000 AST-210, AST-5000 AST-210, AST-5000 AST-210, AST-5000 A A A A A UT UT UT UT UT O-ST O-ST O-ST O-ST O-ST AR AR AR AR AR T TRIMMERS T TRIMMERS T TRIMMERS T TRIMMERS T TRIMMERS P/N 27344 Date 04-19-01 Suppli ...

  • Tanaka AST-210 - page 2

    www.tanakapowerequipment.com 1 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Before using this unit: • Read the operator’s manual carefully. • Check that the cutting equipment is correctly assembled and adjusted. • Start the unit and check the carburetor adjustment. See “Maintenance”. WARNING Read, understand and follow all w ...

  • Tanaka AST-210 - page 3

    www.tanakapowerequipment.com 2 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Blade thrust may occur when the spinning blade contacts a solid object in the critical area. A dangerous reaction may occur causing the entire unit and operator to be thrust violently. This reaction is called BLADE THRUST. As a result, the operator may lose cont ...

  • Tanaka AST-210 - page 4

    www.tanakapowerequipment.com 3 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 1. What is what ? Since this manual covers several models, there may be so me difference between pictures and your unit. Use the instructions that apply to your unit. ...

  • Tanaka AST-210 - page 5

    www.tanakapowerequipment.com 4 custsvc@tanaka-ism.com Owner’s Manual AST-210 , AST-5000 2. Warnings and safety instructions. Operator Safety • Always wear a safety face shield or goggles. • Always wear heavy, long pant s, boo ts and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair so it is above sh ...

  • Tanaka AST-210 - page 6

    www.tanakapowerequipment.com 5 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 NOTE! W h e n i t i s h a r d t o i n s e r t d r i v e s h a f t u p t o t h e m a r k e d p o sition on the drive shaft tube, turn drive shaft by the cutter mounting end clockwise or counterclockwise. Tighten tube locking bolt lining up the hole in the shaft t ...

  • Tanaka AST-210 - page 7

    www.tanakapowerequipment.com 6 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Throttle wire/stop cord (AST-210) Connect stop cord connectors. (Fig. 1-4) Connect throttle wire end to carburetor. (Fig. 1-5) Installation of handle (Fig. 1-2, 2B) Attach the handle to the drive shaft tube with the angle towards the engine. Adjust the location ...

  • Tanaka AST-210 - page 8

    www.tanakapowerequipment.com 7 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 When using a trimmer head (2) with two-piece type blade guard, attach the guard extension to the blade guard. (Fig. 1-7) Then locate the guard above the angle transmission. (Fig. 1-7B) NOTE! If your unit has guard location label on drive shaft tube, follow the i ...

  • Tanaka AST-210 - page 9

    www.tanakapowerequipment.com 8 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 4. Operating procedures Fuel (Fig. 2-1) WARNING! The trimmer is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel. Fuel • Always use branded 89 octane unleaded gas ...

  • Tanaka AST-210 - page 10

    www.tanakapowerequipment.com 9 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Starting (Fig. 2-2, 2B) CAUTION! Before starting, make sure the cutting attachment does not touch anything. The battery is not fully charged at the factory. It is necessary to charge it fully before operation. Please fo llow "Charging Procedures". 1 .D ...

  • Tanaka AST-210 - page 11

    www.tanakapowerequipment.com 10 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 If the engine does not start: 1. If the engine starts but does not co ntinue to run, repeat steps 1 to 5. 2. If the starter does not make any no ise, repeat the charging procedures. (Optional)(AST-250) 3. To start the unit with the recoil starter, if so equippe ...

  • Tanaka AST-210 - page 12

    www.tanakapowerequipment.com 11 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Cutting (Fig. 2-4, 4B, 4C, 4D) • When cutting, operate engine at over 6500 rpm. Extended use at a slow speeds may wear the clutch prematurely. • Cut grass from right to left. • Blade thrust may occur when the spinning blade contacts a solid object in the ...

  • Tanaka AST-210 - page 13

    www.tanakapowerequipment.com 12 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Air filter (Fig. 3-2, 2B) The air filter must be cleaned from dust and dirt in order to avoid: • Carburetor malfunctions. • Starting problems. • Engine power reduction. • Unnecessary wear on the engine parts. • Abnormal fuel consumption. Clean the air ...

  • Tanaka AST-210 - page 14

    www.tanakapowerequipment.com 13 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 NOTE! If element is hard due to excessive dirt buildup, replace it. Drain all fuel from fuel tank and pull fuel filter line from tank. Pull filter element out of holder assembly and rinse element in warm water with detergent. Rinse thoroughly until all traces o ...

  • Tanaka AST-210 - page 15

    www.tanakapowerequipment.com 14 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Flexible drive shaft (Fig. 3-5) Flexible drive shaft should be removed and lubricated with a good quality lithium grease every 20 hours. To remove the flexible shaft, first remove screw (1), loosen bolt (2) and remove the gear case then pull the shaft out of th ...

  • Tanaka AST-210 - page 16

    www.tanakapowerequipment.com 15 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Battery Removal (AST-5000) 1.Separate drive shaft from engine and throttle wire (1) from throttle trigger. Disconnect couplers (2). (Fig. 3-7) 2. Remove four screws (4), which are re taining fan case cover (3). (Fig. 3-8) 3. Bind the female coupler with long no ...

  • Tanaka AST-210 - page 17

    www.tanakapowerequipment.com 16 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Maintenance schedule Below you will find some general maintenance instructions. For further information please contact your Tanaka service dealer. Daily maintenance • Clean the exterior of the unit. • Check that the harness is undamaged. • Check the blade ...

  • Tanaka AST-210 - page 18

    www.tanakapowerequipment.com 17 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 6. Optional Installation of free disk set (optional) (Fig. 4-1, 1 B) 1) Disassemble free disk (7) from the free disk set by loosening three bolts (8). 2) Place blade (3) as shown in drawing. Disk fixing bolt (4) is left-hand threaded ' Use special care to ...

  • Tanaka AST-210 - page 19

    www.tanakapowerequipment.com 18 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 7. Specifications Note : Sound levels are calculated as the time-weighted energy total under various working conditions with the following time distribution : ½ idling, ½ racing. * All data subject to change without notice. ...

  • Tanaka AST-210 - page 20

    www.tanakapowerequipment.com 19 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 Declaration of conformity D6claration de conformit6 Dichiarazione di conformita Konformitiitserkliirung Declaraci6n de conformidad Konformitetsdeklaration Tanaka Kogyo Co., Ltd., 3-4-29 Tsuda num a, Narashino, Chiba, Japan AST-210, AST-5000 Declare under our so ...

  • Tanaka AST-210 - page 21

    www.tanakapowerequipment.com 20 custsvc@tanaka-ism.com Owner’s Manual AST-210,AST-5000 IMPORTANT NOTICE THIS INFORMATION IS FOR THE US AND CANADIAN MARKETS ONLY. • To reduce the risk of injury from loss of control, never use a metal blade on a curved shaft grass trimmer. • Never use a metal blade on any brushcutter without barrier bar or bicy ...

Manufacturer Tanaka Category Trimmer

Documents that we receive from a manufacturer of a Tanaka AST-210 can be divided into several groups. They are, among others:
- Tanaka technical drawings
- AST-210 manuals
- Tanaka product data sheets
- information booklets
- or energy labels Tanaka AST-210
All of them are important, but the most important information from the point of view of use of the device are in the user manual Tanaka AST-210.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Tanaka AST-210, service manual, brief instructions and user manuals Tanaka AST-210. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Tanaka AST-210.

Similar manuals

A complete manual for the device Tanaka AST-210, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Tanaka AST-210 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Tanaka AST-210.

A complete Tanaka manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Tanaka AST-210 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Tanaka AST-210, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Tanaka AST-210, that we can find in the current document
3. Tips how to use the basic functions of the device Tanaka AST-210 - which should help us in our first steps of using Tanaka AST-210
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Tanaka AST-210
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Tanaka AST-210 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Tanaka AST-210?

Use the form below

If you did not solve your problem by using a manual Tanaka AST-210, ask a question using the form below. If a user had a similar problem with Tanaka AST-210 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)