English dropdown-ico

Manual Pentair 75

24 pages 0.94 mb
Download

Go to site of 24

Summary
  • Pentair 75 - page 1

    1 Rev . F 1-22-04 P/N 471 105 FOR YOUR SAFETY - READ BEFORE OPERA TING W arning: If you do not follow these instructions exactly , a fire or explosion may result, causing property damage, personal injury or loss of life. Call (800) 831-7133 for additional free copies of these instructions. Do not store or use gasoline or other flammable vapors and ...

  • Pentair 75 - page 2

    2 P/N 471 105 Rev . F 1-22-04 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Pentair 75 - page 3

    3 Rev . F 1-22-04 P/N 471 105 Introduction MiniMax ® 75 & 100 ABOVEGROUND POOL AND SP A HEA TERS Congratulations on your purchase of a MiniMax 100 high performance heating system. Proper installation and service of your new heating system and correct chemical maintenance of the water will ensure years of enjoyment. The MiniMax 100 is a compact ...

  • Pentair 75 - page 4

    4 P/N 471 105 Rev . F 1-22-04 SAFETY RULES 1. Spa or hot tub water temperatures should never exceed 104 °F (40 °C). A temperature of 100 °F (38 °C) is considered safe for a healthy adult. Special caution is suggested for young children. 2. Drinking of alcoholic beverages before or during spa or hot tub use can cause drowsiness which could lead ...

  • Pentair 75 - page 5

    5 Rev . F 1-22-04 P/N 471 105 FOR YOUR SAFETY : READ BEFORE LIGHTING A. This heater is equipped with an ignition device which automatically lights the main burner . Do not try to light the main burner by hand. B. BEFORE OPERA TING smell all around the heater area for gas. Be sure to smell next to the floor because some gas is heavier than air and w ...

  • Pentair 75 - page 6

    6 P/N 471 105 Rev . F 1-22-04 LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above. 2 . Set the thermostat to the lowest setting. 3 . T urn off all electric power to the heater . 4 . Remove the control access door . 5 . Push in the gas control valve slightly and turn clockwise to "OFF"; see Figure 2. 6. The knob cannot be turn ...

  • Pentair 75 - page 7

    7 Rev . F 1-22-04 P/N 471 105 HEA TER OPERA TION GENERAL The MiniMax 100 DSI employs a microprocessor based Direct Spark Ignition (DSI) system to light the main burner and therefore has no pilot. The ignition circuit operates at 24 V AC and requires that line voltage 1 15/230 be supplied to the heater . The MiniMax 100 MV (Millivolt) requires no ex ...

  • Pentair 75 - page 8

    8 P/N 471 105 Rev . F 1-22-04 Failure to Light- Lockout 1. Should the main burner fail to light, or flame is not detected during the trial-for-ignition (TFI) period the control will go into lockout and the valve will be turned off immediately . 2. Recovery from lockout requires a manual reset by resetting the thermostat or turning off the ON/OFF sw ...

  • Pentair 75 - page 9

    9 Rev . F 1-22-04 P/N 471 105 Proper Electrode Location Proper location of the ignition electrode assembly is important for optimum and safe system performance. The electrode assembly should be located as noted in Figure 6. The electrode assembly is NOT field repairable and must be replaced if damaged. Service Checks Symptom Cause/Cure 1. Dead A. M ...

  • Pentair 75 - page 10

    10 P/N 471 105 Rev . F 1-22-04 Maintenance It is recommended that you check the following items at least every six months and at the beginning of every swimming season. 1. Examine the venting system. Make sure there are no obstructions in the flow of combustion and ventilation air . 2. V isually inspect the main burner and the pilot burner flame (o ...

  • Pentair 75 - page 11

    11 Rev . F 1-22-04 P/N 471 105 CHEMICAL BALANCE POOL AND SP A W A TER Y our Pentair Pool Products pool heater was designed specifically for your spa or pool and will give you many years of trouble free service provided you keep your water chemistry in proper condition. Three major items that can cause problems with your pool heater are improper pH, ...

  • Pentair 75 - page 12

    12 P/N 471 105 Rev . F 1-22-04 Installation Instructions IMPOR T ANT NOTICE: These installation instructions are designed for use by qualified personnel only , trained especially for installation of this type of heating equipment and related components. Some states require installation and repair by licensed personnel. If this applies in your state ...

  • Pentair 75 - page 13

    13 Rev . F 1-22-04 P/N 471 105 PRESSURE SWITCH The pressure switch will keep the circuit open when the pump is not on and operating. When the filter pump turns on, the pressure switch closes the circuit and the heater will operate. When the heater is installed below water level of a spa or pool, adjustment of the pressure switch may be required. Fo ...

  • Pentair 75 - page 14

    14 P/N 471 105 Rev . F 1-22-04 Installation (contd.) W A TER CONNECTIONS QUICK-FLANGE II INST ALLA TION INSTRUCTIONS Figure 12. FOR 1½ SCHEDULE 40 CPVC or ABS PIPE or SCHEDULE 80 PVC (you may adapt to SCH 40 PVC 12 inches beyond the Quick Flange II) (1½ in. npt x 1½ in. CPVC/ABS slip male adaptor may be required ) 1. Insert 2 in. rubber gaskets ...

  • Pentair 75 - page 15

    15 Rev . F 1-22-04 P/N 471 105 GAS CONNECTIONS REGULA TED MANIFOLD PRESSURE TEST 1. Attach the manometer to the heater jacket. 2. Shut off the main gas valve. 3. Remove 1/8" NPT plug on the outlet side of the valve and screw in the fitting from the manometer kit. 4. Connect the manometer hose to the fitting. 5. Fire the heater . 6. The manomet ...

  • Pentair 75 - page 16

    16 P/N 471 105 Rev . F 1-22-04 VENTILA TION OUTDOOR INST ALLA TION This heater is certified by International Approval Services (AGA & CGA) for outdoor installation. If the heater is installed in very cold areas proper precau- tions are needed for freeze protection. The heater must be placed in a suitable area on a level, noncom- bustible surfac ...

  • Pentair 75 - page 17

    17 Rev . F 1-22-04 P/N 471 105 INDOOR INST ALLA TION The installation of venting system should conform with the latest edition of ANSI Z223.1, the National Fuel Gas Code, and/or in Canada, CAN/CGA-B149.1 or .2 or applicable provision of the local codes. All products of combustion and vent gases must be completely removed to the outside atmosphere t ...

  • Pentair 75 - page 18

    18 P/N 471 105 Rev . F 1-22-04 Installation - V entilation (contd.) Fig. 18. Draft Hood. VENT TEST Use the following steps to perform a quick check of your venting installation. Allow the heater to operate for 15 minutes. Close the doors in the room, then strike a wooden match and blow out the flame. Hold the smoking match next to the draft hood; s ...

  • Pentair 75 - page 19

    19 Rev . F 1-22-04 P/N 471 105 Installation (contd.) MiniMax 100 Electronic Direct Spark Ignition Wiring Diagram THERMAL FUSE HI LIMIT SW. PRESSURE SW. WATER THERMOSTAT ON/OFF SW. IGNITER SPARK MODULE GAS VALVE MiniMax 100 ELECTRONIC WIRING DIAGRAM CODE OR SUPERCEDING LOCAL (WIRING) CODES. INTERCONNECTING WIRING TO APPLIANCE MUST CONFORM TO THE NAT ...

  • Pentair 75 - page 20

    20 P/N 471 105 Rev . F 1-22-04 TROUBLESHOOTING - GENERAL Possible Cause Remedy Heater will not come on Automatic ignition system fails Check if electrical connections are correct and securely fastened – If YES, call serviceman. Pump not running Place pump in operation Pump air locked Check for leaks Filter dirty Clean filter Pump strainer clogged ...

  • Pentair 75 - page 21

    21 Rev . F 1-22-04 P/N 471 105 PARTS LIST ITEM DESCRIPTION QTY. P/ N 1* Indoor Draft Hood Kit consisting of: 1 4 7 1 1 8 7 Indoor Draft Hood (471 198) and items 2 & 3 1A Outdoor T op 1 471213 2* Indoor T op (Cover) 1 471075 3* Indoor Stack Adaptor 1 471214 4 Middle T op 1 471069 5 Flue Collector 1 471059 6 Return Header 1 471096 7 Bolt 3/8 x 16 ...

  • Pentair 75 - page 22

    22 P/N 471 105 Rev . F 1-22-04 EXPLODED VIEW 33 14 13a ...

  • Pentair 75 - page 23

    23 Rev . F 1-22-04 P/N 471 105 NOTES ...

  • Pentair 75 - page 24

    24 P/N 471 105 Rev . F 1-22-04 Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 SAVE THESE INSTRUCTIONS. ...

Manufacturer Pentair Category Swimming Pool Heater

Documents that we receive from a manufacturer of a Pentair 75 can be divided into several groups. They are, among others:
- Pentair technical drawings
- 75 manuals
- Pentair product data sheets
- information booklets
- or energy labels Pentair 75
All of them are important, but the most important information from the point of view of use of the device are in the user manual Pentair 75.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Pentair 75, service manual, brief instructions and user manuals Pentair 75. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Pentair 75.

Similar manuals

A complete manual for the device Pentair 75, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Pentair 75 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Pentair 75.

A complete Pentair manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Pentair 75 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Pentair 75, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Pentair 75, that we can find in the current document
3. Tips how to use the basic functions of the device Pentair 75 - which should help us in our first steps of using Pentair 75
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Pentair 75
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Pentair 75 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Pentair 75?

Use the form below

If you did not solve your problem by using a manual Pentair 75, ask a question using the form below. If a user had a similar problem with Pentair 75 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)