Manual FMI VF48H(I)(R)

20 pages 1.71 mb
Download

Go to site of 20

Summary
  • FMI VF48H(I)(R) - page 1

    IF FIREPLACE IS TO BE INST ALLED DIRECTL Y ON ANY COMBUSTIBLE MA TERIAL, A HEARTH SP ACER IS REQUIRED. SA VE THIS BOOK This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that will enable you to obtain re- placement parts or accessory items when needed. Keep it with your ...

  • FMI VF48H(I)(R) - page 2

    www .fmiproducts.com 122272-01D 2 W ARNING: Improper installation, adjustment, altera- tion, service or maintenance can cause injury , property damage or loss of life. Refer to this manual for assis-        ...

  • FMI VF48H(I)(R) - page 3

    www .fmiproducts.com 122272-01D 3 SPECIFICA TIONS MODELS F48H(I)(R) AND VF48H(I)(R) SQUARE CHASE-TOP TERMIN AT ION ROUND TOP TERMIN AT ION 33.5" 48" 60.625" 42.375" 30.31" PLANT ATION FIREPLACE WITH HEARTH SP ACER (REQUIRED FOR COMBUSTIBLE FLOORS) 24" 14.375" 30" 0.625" 15.625" 8.875" 7.625&quo ...

  • FMI VF48H(I)(R) - page 4

    www .fmiproducts.com 122272-01D 4 INST ALLA TION SELECTING FIREPLACE LOCA TION T o determine the safest and most efcient location for the replace, you must take into consideration the following guidelines: 1. The location must allow for proper clear - ances (see Figures 1 and 2). 2. Consider a location where the replace will not be aff ect ...

  • FMI VF48H(I)(R) - page 5

    www .fmiproducts.com 122272-01D 5 HEARTH EXTENSION A hearth extension projecting a minimum of 20" in front of and a minimum of 12" beyond each side of the replace opening is required to protect combustible floor construction in front of the replace. Fabricate a hearth extension using a material which meets the following specicati ...

  • FMI VF48H(I)(R) - page 6

    www .fmiproducts.com 122272-01D 6 Figure 6 - Lineal Gain LINEAL GAIN P ART NO. DESCRIPTION GAIN (IN) 48" Plantation Fireplace 66 1 / 2 " 12-12DM 12-12HT Pipe Section 10 5 / 8 " 18-12DM 18-12HT Pipe Section 16 5 / 8 " 24-12DM 24-12HT Pipe Section 23 5 / 8 " 36-12DM 36-12HT Pipe Section 34 5 / 8 " 48-12DM 48-12HT Pipe Se ...

  • FMI VF48H(I)(R) - page 7

    www .fmiproducts.com 122272-01D 7 INST ALLA TION Continued USING ELBOW OFFSETS (30E-12DM) 1. T o achieve desired of fset, you may install combinations of 12", 18", 24", 36" and 48" length of double wall pipe (see of fset chart and Figure 7). OFFSET CHART (22-50 FT . SYSTEM HEIGHT) Figure 7 - T ypical Offset T erminations Re ...

  • FMI VF48H(I)(R) - page 8

    www .fmiproducts.com 122272-01D 8 INST ALLA TION Continued Figure 9 - Elbow Offset B A Screws FIRESTOP SP ACERS (FS-10) Firestop spacers are required at each point where chimney penetrates a floor space. Their purpose is to establish and maintain required clearance between chimney and combustible materials. When pipe passes through a framed opening ...

  • FMI VF48H(I)(R) - page 9

    www .fmiproducts.com 122272-01D 9 INST ALLA TION Continued FLASHING INST ALLA TION (V6F-10DM OR V12F-10DM) Determine ashing to be used with roof open - ing chart. Slide ashing over pipe until base is at against roof. Repl ace as many shin gles as needed to cover exposed area and ashing base. Secure in position by nailing through shingle ...

  • FMI VF48H(I)(R) - page 10

    www .fmiproducts.com 122272-01D 10 10 FOOT RULE All ue gas outlet chimney terminations must extend a minimum of 3 feet in height above highest point where it passes through the roof and mus t be at least 2 fe et above hig hes t point of the roof that is within a horizontal distance of 10 feet (see Figure 17). INST ALLA TION Continued FINISHING F ...

  • FMI VF48H(I)(R) - page 11

    www .fmiproducts.com 122272-01D 11 INST ALLA TION Continued CAUTION: All gas piping and connections must be tested for leaks after the installation is c om pl et ed . Af te r e ns ur in g that the gas valve is on, apply soap and water solution to all conn ecti ons and joints. Bubb les forming show a leak. Correct all leaks at once. DO NOT USE AN OP ...

  • FMI VF48H(I)(R) - page 12

    www .fmiproducts.com 122272-01D 12 INST ALLA TION Continued HERRINGBONE BRICK INST ALLA TION F 049 F 049 F 049 F 049 F 049 F 049 F 049 F 049 F 049 F055 F052 S033 or S005 S020 S006 S020 S020 S020 S020 S020 S020 S020 S020 S020 S020 S032 S016 S015 FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL FULL ...

  • FMI VF48H(I)(R) - page 13

    www .fmiproducts.com 122272-01D 13 INST ALLA TION Continued LEFT REFRACTOR Y RED IVOR Y QTY FULL (1 12140-02) FULL (1 12140-06) 21 F049R F049W 9 F050R F050W 1 F052R F052W 1 F054R F054W 1 F055R F055W 1 S005R S005W 1 S006R S006W 1 S012R S012W 1 S015R S015W 1 S016R S016W 1 S020R S020W 11 S031R S031W 3 S032R S032W 1 S033R S033W 1 S034R S034W 1 S035R S0 ...

  • FMI VF48H(I)(R) - page 14

    www .fmiproducts.com 122272-01D 14 INST ALLING SCREEN 1. Mount scr een rod bra ckets on le ft a nd right side of rebox with #8 x 1/2" screws provided (see Figure 21, page 15). 2. Slide round end of screen rod into rings at top of screen. Attach one push-on nut to end of rod before attaching last ring of screen. 3. Insert round end of rod in ...

  • FMI VF48H(I)(R) - page 15

    www .fmiproducts.com 122272-01D 15 INST ALLA TION Continued Figure 22 - Securing Door Rails to Fireplace Bottom Rail (Use as a T emplate before Drilling) Concrete Screws T op Rail Drill Holes into Bricks Remove Screws then Replace to Secure T op Rail Figure 21 - Installing Fireplace Screen Ring Screen Push On Nut Screen Rod Bracket Smoke Shelf Scre ...

  • FMI VF48H(I)(R) - page 16

    www .fmiproducts.com 122272-01D 16 Figure 24 - Installing Doors Figure 25 - Adjusting Bi-Fold Doors INST ALLA TION Continued Bottom Retaining Clip Slide T op Pin Into T op Retaining Clip Spring Clip Side Front Face Partially Opened Door OPERA TION AND MAINTENANCE GLASS DOORS Glass doors are optional with replace. When replace is in operation, ...

  • FMI VF48H(I)(R) - page 17

    www .fmiproducts.com 122272-01D 17 IMPORT ANT : The glass must be allowed to warm slowly and evenly . Such materials as pitch/wax laden logs, very dry mill end lumber and large amounts of paper or cardboard boxes can create an excessively hot re and should not be burned in this replace. Always keep the re well back from the doors and never ...

  • FMI VF48H(I)(R) - page 18

    www .fmiproducts.com 122272-01D 18 TECHNICAL SERVICE Y ou may have further questions about in - stallation, operation, or troubleshooting. I f s o , c o n t a c t F M I P R O D U C T S , L L C a t 1-866-328-4537. When calling please have your mo del and se ria l nu mbe rs of y our hea ter ready . Y ou can also visit our web site at www .fmiproducts ...

  • FMI VF48H(I)(R) - page 19

    www .fmiproducts.com 122272-01D 19 REPLACEMENT AND A CCESSOR Y P ARTS Continued SQUARE CHASE-TOP TERMINA TION - STL-12D ROUND TOP TERMINA TIONS RL T -12D AND RL T -12HT OPTIONAL ASH LIP KIT (BRICKS) AL48 - Red Brick AL48I - Ivory Brick OPTIONAL HEARTH SP ACER HS48 24" ROUND WOODNOOK - DHR-24 SCREEN - 1 181 15-01 ROD - 1 10146-02 PUSH-ON NUT - ...

  • FMI VF48H(I)(R) - page 20

    122272-01 Rev . D 01/10 2701 S. Harbor Blvd. Santa Ana, CA 92704 1-866-328-4537 www .fmiproducts.com ...

Manufacturer FMI Category Indoor Fireplace

Documents that we receive from a manufacturer of a FMI VF48H(I)(R) can be divided into several groups. They are, among others:
- FMI technical drawings
- VF48H(I)(R) manuals
- FMI product data sheets
- information booklets
- or energy labels FMI VF48H(I)(R)
All of them are important, but the most important information from the point of view of use of the device are in the user manual FMI VF48H(I)(R).

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals FMI VF48H(I)(R), service manual, brief instructions and user manuals FMI VF48H(I)(R). Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product FMI VF48H(I)(R).

Similar manuals

A complete manual for the device FMI VF48H(I)(R), how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use FMI VF48H(I)(R) by users. Manuals are usually written by a technical writer, but in a language understandable to all users of FMI VF48H(I)(R).

A complete FMI manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual FMI VF48H(I)(R) - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the FMI VF48H(I)(R), FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the FMI VF48H(I)(R), that we can find in the current document
3. Tips how to use the basic functions of the device FMI VF48H(I)(R) - which should help us in our first steps of using FMI VF48H(I)(R)
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with FMI VF48H(I)(R)
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of FMI VF48H(I)(R) in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning FMI VF48H(I)(R)?

Use the form below

If you did not solve your problem by using a manual FMI VF48H(I)(R), ask a question using the form below. If a user had a similar problem with FMI VF48H(I)(R) it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)