English dropdown-ico

Manual NAD C165BEE

14 pages Not applicable
Download

Go to site of 14

Summary
  • NAD C165BEE - page 1

    ENGLISH FRANÇAIS ESP AÑOL IT ALIANO DEUTSCH NEDERLANDS SVENSK A РУС СКИЙ ® O wner ’ s Manual C 16 5 B E E St ere o Prea m p li  e r ...

  • NAD C165BEE - page 2

    SA VE THESE INSTR UCTIONS FOR LA TER USE. FOLL OW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE A UDIO EQUIPMENT . 1 Read instructions - All the safety and operating instructions should be read befor e the product is operated. 2 Retain instructions - T he safety and operating instructions should be retained for futur e reference . 3 Heed W arnings - ...

  • NAD C165BEE - page 3

    19 Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualied service personnel under the following conditions: a) When the power-supply cord or plug is damaged . b) If liquid has been spilled, or objects have fallen into the product. c) If the product has been exposed to rain or water . d) If the product ...

  • NAD C165BEE - page 4

    NOTES ON ENVIRONMENT AL PRO TECTION At the end of its useful life, this pr oduct must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user ’ s manual and packaging, point this out. The materials can be reused in accordan ...

  • NAD C165BEE - page 5

    INTRODUCTION GET TING ST ARTED UNP A CKING AND SETUP WHA T’S IN THE BOX Packed with your C 165BEE y ou will nd: • The SR 8 remote contr ol with 2 (two) AA batteries • This owner’s manual • A detachable AC power cor d SA VE THE P ACKA GING Please save the box and all of the packaging in which your C 165BEE arrived. Should you move or ot ...

  • NAD C165BEE - page 6

    IDENTIFICA TION OF C ONTROLS FRONT P ANEL 1 ST ANDBY BUTTON: With the rear panel POWER switch set to ON position, press this button to switch ON the C 165BEE fr om standby mode. The Standby LED indicator will turn from amber t o blue. Pressing the ST ANDBY button again turns the unit back to standby mode. The C 165BEE can also be switched ON from s ...

  • NAD C165BEE - page 7

    1 MC L OADS (R1, R2, R3): If you are using a Moving Coil (MC) cartr idge, set this switch to a r esistive load that closely approximates the value specied in the MC cartr idge (this is usually specied in the MC cartr idge). In general, use the lowest resistance f or low output cartr idges and high resistance f or medium output car tridges. F ...

  • NAD C165BEE - page 8

    12 T APE MONIT OR IN/OUT: C onnections for analog recording and playback to a secondary audio tape recorder of any type. Using twin RCA-to-RCA leads, connect to the left and r ight “ Audio Output ” of the tape machine to the T APE MONITOR IN sockets for playback and tape monitoring. Connect the left and right “ Audio I nput” of the tape mac ...

  • NAD C165BEE - page 9

    19 POWER SWIT CH: The POWER switch supplies the master AC mains power for the C 165BEE. When this switch is at ON position, the C 165BEE is in standby mode as shown by the amber status condition of the standby LED . T oggle the front panel’ s ST ANDBY button to switch ON the C 165BEE or back to standby mode. If you intend not to use the C 165BEE ...

  • NAD C165BEE - page 10

    USING THE SR 8 REMO TE C ONTROL The SR 8 remote contr ol handset handles the key func tions of the C 165BEE as well as other NAD Stereo Receivers, Integrat ed Ampliers and Preampliers . I t has additional controls to r emotely operate NAD CD Players , AM/FM T uners and dedicated AM/F M/DAB T uners. It will operate up to a distance of 23ft (7m ...

  • NAD C165BEE - page 11

    8 VOL [ ]: Press [ ] button to increase or decrease the loudness level. Release the button when the desired level is reached . For NAD Receivers , the VFD will also sho w “ Volume Up ” or “ Volume Down ” while pressing SR 8’ s . The VOL UME buttons do not aect recordings made using the T APE output but will aect the signal going to ...

  • NAD C165BEE - page 12

    CONDITION POSSIBLE CA USES POSSIBLE SOL UTIONS No sound. • Power AC lead unplugged or power not switched ON. • Check if AC lead is plugged in and power switched ON. • T ape Monitor selected. • D e-selec t T ape M onitor mode. • M ute on. • Switch o Mute. No sound one channel. • Balance control not centered. • Center Balance contr ...

  • NAD C165BEE - page 13

    OVERALL SPECIFICA TIONS LINE LEVEL INPUT Input impedance (R and C ) 100 kΩ+ 320 pF Input sensitivity 158 mV (ref . 500 mV out) Maximum input signal >9 V Signal/Noise ratio, A- weighted >108 dB (ref . 500 mV in 500 mV out, volume set to unity gain) >106 dB (ref . 2V out, V olume maximum) Channel Separation >80 dB (ref. 1 kHz/10 kHz) Fr ...

  • NAD C165BEE - page 14

    ww w .NADelectronics.com ©2014 NAD ELECTRONICS INTERNA TIONAL A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission ...

Manufacturer NAD Category Receiver

Documents that we receive from a manufacturer of a NAD C165BEE can be divided into several groups. They are, among others:
- NAD technical drawings
- C165BEE manuals
- NAD product data sheets
- information booklets
- or energy labels NAD C165BEE
All of them are important, but the most important information from the point of view of use of the device are in the user manual NAD C165BEE.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals NAD C165BEE, service manual, brief instructions and user manuals NAD C165BEE. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product NAD C165BEE.

Similar manuals

A complete manual for the device NAD C165BEE, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use NAD C165BEE by users. Manuals are usually written by a technical writer, but in a language understandable to all users of NAD C165BEE.

A complete NAD manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual NAD C165BEE - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the NAD C165BEE, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the NAD C165BEE, that we can find in the current document
3. Tips how to use the basic functions of the device NAD C165BEE - which should help us in our first steps of using NAD C165BEE
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with NAD C165BEE
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of NAD C165BEE in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning NAD C165BEE?

Use the form below

If you did not solve your problem by using a manual NAD C165BEE, ask a question using the form below. If a user had a similar problem with NAD C165BEE it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)