English dropdown-ico

Manual Audiovox AX-200

8 pages 0.03 mb
Download

Go to site of 8

Summary
  • Audiovox AX-200 - page 1

    128-6993 1 of 8 3 Button Remote Security System with Stage Shock Sensor & Starter Disable Model AX-200 Owner ’s Manual FEA TURES :  2 Three Button Code Hopping RF Transmitters  Three Channel Code Learning Receiver (capable of accepting 4 transmitters)  Selectable Manual Override Mode  Remote Panic in all modes  Protected V alet ...

  • Audiovox AX-200 - page 2

    128-6993 2 of 8 NOTE: Y our system has the option of using a siren, the vehicle horn, or both for the sounding device. Where the siren is referenced below , the horn or both may in fact chirp, or beep. ARMING THE SYSTEM - ACTIVE 1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid. 2. Press and release the ARM butt ...

  • Audiovox AX-200 - page 3

    128-6993 3 of 8 Page 3 PROTECTION WHILE THE SYSTEM IS ARMED  Opening any protected door , hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, rema ...

  • Audiovox AX-200 - page 4

    128-6993 4 of 8 Page 4 button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock. 1. As you approach the vehicle, press and hold the ARM / DISARM button on the keychain transmitter for 2 seconds.  The dash mounted LED turns off. If passive arming was selected during the instal ...

  • Audiovox AX-200 - page 5

    128-6993 5 of 8 Page 5 valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational. T o use the valet mode, the system must first be disarmed either by using your keychain transmitter , or by operating the manual override sequence. 1. From the disarmed condition, turn the ignition key ...

  • Audiovox AX-200 - page 6

    128-6993 6 of 8 NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Custom Code Programming Example: T o Change the code from the factory preassigned code of 1 1 to “52” you would do the following: ...

  • Audiovox AX-200 - page 7

    128-6993 7 of 8 1. Turn the ignition key on then off. 2. Within 10 seconds, press and release the valet push button switch three times. 3. If the chirps were on before you started, then you will hear 2 chirps indicating they have been turned off. If the chirps were off before you started, then you will hear one chirp indicating they have been turne ...

  • Audiovox AX-200 - page 8

    128-6993 8 of 8 © Audiovox Electronic Corp. 150 Marcus Blvd., Hauppauge, N.Y . 11788 128-6993 AX-200 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INTRUSION ZONE 3 2 FLASH...P AUSE = INTRUSION ZONE 2 1 FLASH...P AUSE = INTRUSION ZON ...

Manufacturer Audiovox Category Remote Starter

Documents that we receive from a manufacturer of a Audiovox AX-200 can be divided into several groups. They are, among others:
- Audiovox technical drawings
- AX-200 manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox AX-200
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox AX-200.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox AX-200, service manual, brief instructions and user manuals Audiovox AX-200. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox AX-200.

Similar manuals

A complete manual for the device Audiovox AX-200, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox AX-200 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox AX-200.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox AX-200 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox AX-200, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox AX-200, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox AX-200 - which should help us in our first steps of using Audiovox AX-200
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox AX-200
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox AX-200 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox AX-200?

Use the form below

If you did not solve your problem by using a manual Audiovox AX-200, ask a question using the form below. If a user had a similar problem with Audiovox AX-200 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)