English dropdown-ico

Manual Arcam C31

18 pages 1.38 mb
Download

Go to site of 18

Summary
  • Arcam C31 - page 1

    Pr e Amplier C3 1 Pow er Amplier P3 5 Pow er Amplier P 1 ...

  • Arcam C31 - page 2

    C31/P35/P1 E-2 C31/P35/P1 E-3 English Sa f et y gu i de l in es Important safety instructions These products are designed and manufactured to meet strict quality and safety standards. However , y ou should be aware of the following installation and oper ation precautions: 1. Take heed of warnings and instructions Y ou should read all the safety and ...

  • Arcam C31 - page 3

    C31/P35/P1 E-2 C31/P35/P1 E-3 English U si ng t hi s h a nd boo k Thank you for buying this quality Arcam product. This handbook covers the following items: < C31 pre-amplier; < P35 power amplier; < P1 power amplier . This handbook is intended to give you all the information you need to install and use these products. The C31 is d ...

  • Arcam C31 - page 4

    C31/P35/P1 E-4 C31/P35/P1 E-5 English Positioning the unit < Place your ampli er on a level,  rm surface. < Avoid placing the unit in direct sunlight or near sources of heat or damp. < Ensure adequate ventilation. Do not place the unit in an enclosed space such as a bookcase or cabinet as both of these will impede air- ow through ...

  • Arcam C31 - page 5

    C31/P35/P1 E-4 C31/P35/P1 E-5 English Recording loops The C31 is equipped with two recording loops, for use with recording devices (such as cassette decks, MiniDisc players, VCR ’s etc.) 7 TAPE/PROC RECORD OUT – Connect these output sockets to the input sockets of y our recording device (usually labelled RECORD or IN ). 8 TAPE/PROC PLAY IN – ...

  • Arcam C31 - page 6

    C31/P35/P1 E-6 C31/P35/P1 E-7 English U si ng y o u r C3 1 p r e - a mp l i er Switching the C31 on The power button bm switches the unit on and off; alternatively , the unit can be switched in and out of stand-by mode by pressing the 2 button on the remote control handset. The power light (next to the “C31 Pre-Ampli er” text) indicates t ...

  • Arcam C31 - page 7

    C31/P35/P1 E-6 C31/P35/P1 E-7 English Recording an audio source The C31 allows listening to and recording from the same source, or listening to one source whilst recording another . The signal to be recorded is sent to both the TAPE and VCR output sockets. Selecting the source for recording The recording outputs can be congured in two ways: 1. t ...

  • Arcam C31 - page 8

    C31/P35/P1 E-8 C31/P35/P1 E-9 English Con  g u rin g y ou r C 3 1 p re - a m pl i er Introduction The C31 allows you to customise various features of the ampli er to  t your system. Use this diagr am to help you navigate through the av ailable con guration options. In the diagram below , the ENTER and SELECT buttons from the front pa ...

  • Arcam C31 - page 9

    C31/P35/P1 E-8 C31/P35/P1 E-9 English U si ng t he rem o te co nt rol NOTE: Remember to install the two AAA batteries supplied before trying to use your remote control. Do not place anything in front of the FMJ badge on the top left of the C31 (where the IR receiver is located), or the remote control may not work. CR-389 Remote Control The CR -389 ...

  • Arcam C31 - page 10

    C31/P35/P1 E-10 C31/P35/P1 E-11 English I nsta ll a tio n : P 3 5 a nd P 1 po w er a m pl i  er s Positioning your power ampli er < Place your ampli er on a  rm, level surface. < Avoid placing the unit in direct sunlight or near sources of heat or damp. < Ensure adequate ventilation. Do not place the your ampli er in an encl ...

  • Arcam C31 - page 11

    C31/P35/P1 E-10 C31/P35/P1 E-11 English Amplier Gain Switch (P1) This switch is to allow the gain of the P1 amplier to be changed to suit your system requirements. With the switch in, the gain is set to standard ARCAM gain of 31.5dB. This is the normal setting, which allows the P1 to be used in systems where there are other ARCAM power ampli? ...

  • Arcam C31 - page 12

    C31/P35/P1 E-12 C31/P35/P1 E-13 English Connecting loudspeakers Wiring strategies There are three different wiring strategies that can be employ ed to connect your ampli er to your speakers. The choice will be limited by what your speak ers can support. < Single wiring Single wiring is the conventional wiring method of running a single cable ...

  • Arcam C31 - page 13

    C31/P35/P1 E-12 C31/P35/P1 E-13 English Bi-amping Bi-amping requires the use of a two ampli ers per channel: either two P35’ s or four P1’s in a stereo system. One P35 (or two P1’ s) is/are used to drive the high-frequency (treble) speakers, the other is used for the lower (bass) frequencies. For the P35’s, connect one P35 to the speaker ...

  • Arcam C31 - page 14

    C31/P35/P1 E-14 C31/P35/P1 E-15 English U si ng y o u r po w er a m pl i er P35 Power Ampli er: Front panel P1 Power Ampli er: Front panel P35 Power Ampli er: Front panel P35 POWER AMPLIFIER SP1 SP2 POWER P1 Power Ampli er: Front panel P1 POWER AMPLIFIER POWER POWER button Switches the unit on and off . The light indicates the status ...

  • Arcam C31 - page 15

    C31/P35/P1 E-14 C31/P35/P1 E-15 English T echn i cal s peci ca ti on s Continual improvement policy Arcam has a policy of continual improvement for its products. This means that designs and specications are subject to change without notice. C31 P35 P1 Continuous power output (20Hz—20kHz at 0.5% THD), per channel Both channels, 8Ω, 20Hz— ...

  • Arcam C31 - page 16

    C31/P35/P1 E-16 C31/P35/P1 E-17 English R em ot e - con trol cod es The following tables give the IR -commands accepted by the C31. Power commands Menu navigation commands Command Decimal Code Command Decimal Code Power toggle 16–12 UP 16–32 Power-on 16–123 DOWN 16–33 Power-off 16–124 SELECT 16–37 ENTER 16–87 Source selection commands ...

  • Arcam C31 - page 17

    C31/P35/P1 E-16 C31/P35/P1 E-17 English T r o u bl esh oo ti n g If you are having trouble with your amplier , check the following items. No sound Check the following: < Both the pre- and power-ampliers are switched on. < The pre-amp. is not muted (indicated on the C31 by “Muted” being shown on the front -panel). < The selected s ...

  • Arcam C31 - page 18

    PEMBROKE AVENUE, WATERBEACH, CAMBRIDGE CB5 9QR, ENGLAND www .arcam.co.uk Issue 1 SH163 ...

Manufacturer Arcam Category Stereo Amplifier

Documents that we receive from a manufacturer of a Arcam C31 can be divided into several groups. They are, among others:
- Arcam technical drawings
- C31 manuals
- Arcam product data sheets
- information booklets
- or energy labels Arcam C31
All of them are important, but the most important information from the point of view of use of the device are in the user manual Arcam C31.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Arcam C31, service manual, brief instructions and user manuals Arcam C31. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Arcam C31.

Similar manuals

A complete manual for the device Arcam C31, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Arcam C31 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Arcam C31.

A complete Arcam manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Arcam C31 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Arcam C31, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Arcam C31, that we can find in the current document
3. Tips how to use the basic functions of the device Arcam C31 - which should help us in our first steps of using Arcam C31
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Arcam C31
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Arcam C31 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Arcam C31?

Use the form below

If you did not solve your problem by using a manual Arcam C31, ask a question using the form below. If a user had a similar problem with Arcam C31 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)