-
Velodyne VX-10 - page 1
Audio/Video Subwoofer VX-10 Owner's Manual Velodyne Acoustics, Inc. 345 Digital Drive Morgan Hill, CA 95037 408.465.2800 voice 408.779.9227 fax 408.779.9208 service fax Web Site: www.velodyne.com Technical e-mail: techhelp@velodyne.com Service e-mail: service@velodyne.com Product e-mail: help@velodyne.com "It delivered room-shaking bass a ...
-
Velodyne VX-10 - page 2
Caution: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. The lighting flash with arrowhead symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of suffici ...
-
Velodyne VX-10 - page 3
Vorsicht : Zur Vermeidung von Gefahr durch elektrischen Schlag, Deckel (oder Rückwand) nicht abnehmen. Produkt enthält keine Anwenderteile. Reparatur und Wartung nur von qualifiziertem Fachpersonal vornehmen lassen. Das Blitzsymbol dient als Hinweis auf unisolierte „gefährliche Spannungen“ innerhalb des Gehäuses, deren Werte eine Berührung ...
-
Velodyne VX-10 - page 4
Attention: Afin d’éviter tout risque d’électrocution, ne pas enlever le boitier (ou partie arrière de l’enceinte). Aucune pièce ne doit être manipulée par l’utilisateur . P our tout entretien, vous référer à un personnel de service qualifié. Le symbol de l’éclair avec la flèche sert à avertir l’utilisateur de la présence d ...
-
Velodyne VX-10 - page 5
Congratulations! Congratulations on your purchase of a Velodyne subwoofer system. This system represents the state of the art in home audio reproduction and will provide you with years of listening pleasure when properly cared for. Read and follow this instruction manual to insure safe and proper system connection and operation. Caution! Please obs ...
-
Velodyne VX-10 - page 6
Product Features • 10" (8.5" piston diameter) subwoofer with 2.0" high-temp voice coil and 40 ounce motor structure • Adjustable (50 to 200Hz) low-pass crossover • Line-level (RCA) inputs • Speaker-level inputs and outputs with spring loaded terminals • Signal sensing auto turn on/off • Variable volume control • Selecta ...
-
Velodyne VX-10 - page 7
Regardless of where you install your Velodyne subwoofer, it must remain in an upright position (woofer facing forward). Using, shipping, or otherwise storing the subwoofer in any other position for an extended period of time may result in damage to the unit not covered by warranty. The VX-10 is magnetically shielded to reduce the amount of stray ma ...
-
Velodyne VX-10 - page 8
Low-pass crossover - 50 to 200Hz All inputs sum the left and right channels together, with the resulting signal passing through an adjustable low-pass crossover before being amplified. The crossover control allows you to adjust the upper limit of the subwoofer's frequency response from 50 to 200Hz. The subwoofer's response will begin roll ...
-
Velodyne VX-10 - page 9
11 ☞ 8 ☞ Figure 1. Rear panel inputs, output and operational layout. Figure 2a. Line-level subwoofer connection diagram. Speaker Line-level Connections When installed in this fashion the satellite speakers will be crossed over at 80Hz. This removes the lower bass from your amplifier and speakers, enabling them to do a better job reproducing hig ...
-
Velodyne VX-10 - page 10
9 ☞ 10 ☞ Operational References (see Figure 1, Page 8) A SPEAKER LEVEL INPUT terminals Connect these input terminals to the speaker output terminals of your amplifier or receiver. B SPEAKER LEVEL OUTPUT terminals The speaker-level signal to the front speakers is output from these terminals. C LINE INPUT jacks Connect these jacks to the LINE OUT ...
-
Velodyne VX-10 - page 11
9 ☞ 10 ☞ Operational References (see Figure 1, Page 8) A SPEAKER LEVEL INPUT terminals Connect these input terminals to the speaker output terminals of your amplifier or receiver. B SPEAKER LEVEL OUTPUT terminals The speaker-level signal to the front speakers is output from these terminals. C LINE INPUT jacks Connect these jacks to the LINE OUT ...
-
Velodyne VX-10 - page 12
11 ☞ 8 ☞ Figure 1. Rear panel inputs, output and operational layout. Figure 2a. Line-level subwoofer connection diagram. Speaker Line-level Connections When installed in this fashion the satellite speakers will be crossed over at 80Hz. This removes the lower bass from your amplifier and speakers, enabling them to do a better job reproducing hig ...
-
Velodyne VX-10 - page 13
Low-pass crossover - 50 to 200Hz All inputs sum the left and right channels together, with the resulting signal passing through an adjustable low-pass crossover before being amplified. The crossover control allows you to adjust the upper limit of the subwoofer's frequency response from 50 to 200Hz. The subwoofer's response will begin roll ...
-
Velodyne VX-10 - page 14
Regardless of where you install your Velodyne subwoofer, it must remain in an upright position (woofer facing forward). Using, shipping, or otherwise storing the subwoofer in any other position for an extended period of time may result in damage to the unit not covered by warranty. The VX-10 is magnetically shielded to reduce the amount of stray ma ...
-
Velodyne VX-10 - page 15
14 ☞ The following conditions require service by a qualified technician: 1 . The power cord has become damaged. 2 . The unit does not appear to operate normally or exhibits a marked change in performance. 3 . The unit has been exposed to water. 4 . Some part of the cabinet or circuitry is physically damaged. SPECIFICATIONS VX-10 Cabinet Design Ba ...
-
Velodyne VX-10 - page 16
Congratulations! Congratulations on your purchase of a Velodyne subwoofer system. This system represents the state of the art in home audio reproduction and will provide you with years of listening pleasure when properly cared for. Read and follow this instruction manual to insure safe and proper system connection and operation. Caution! Please obs ...
-
Velodyne VX-10 - page 17
Attention: Afin d’éviter tout risque d’électrocution, ne pas enlever le boitier (ou partie arrière de l’enceinte). Aucune pièce ne doit être manipulée par l’utilisateur . P our tout entretien, vous référer à un personnel de service qualifié. Le symbol de l’éclair avec la flèche sert à avertir l’utilisateur de la présence d ...
-
Velodyne VX-10 - page 18
Vorsicht : Zur Vermeidung von Gefahr durch elektrischen Schlag, Deckel (oder Rückwand) nicht abnehmen. Produkt enthält keine Anwenderteile. Reparatur und Wartung nur von qualifiziertem Fachpersonal vornehmen lassen. Das Blitzsymbol dient als Hinweis auf unisolierte „gefährliche Spannungen“ innerhalb des Gehäuses, deren Werte eine Berührung ...
-
Velodyne VX-10 - page 19
Caution: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. The lighting flash with arrowhead symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of suffici ...
-
Velodyne VX-10 - page 20
Audio/Video Subwoofer VX-10 Owner's Manual Velodyne Acoustics, Inc. 345 Digital Drive Morgan Hill, CA 95037 408.465.2800 voice 408.779.9227 fax 408.779.9208 service fax Web Site: www.velodyne.com Technical e-mail: techhelp@velodyne.com Service e-mail: service@velodyne.com Product e-mail: help@velodyne.com "It delivered room-shaking bass a ...
Do you have a question concerning Velodyne VX-10?
Use the form below
If you did not solve your problem by using a manual Velodyne VX-10, ask a question using the form below. If a user had a similar problem with Velodyne VX-10 it is likely that he will want to share the way to solve it.