English dropdown-ico

Manual Kettler Bicycle

15 pages 2.14 mb
Download

Go to site of 15

Summary
  • Kettler Bicycle - page 1

    P edelec Operating Instructions P edelec handleiding Pédélec manuel ...

  • Kettler Bicycle - page 2

     2 Introduction ( GB ) Dear Customer , congratulations on the purchase of your new KETTLER Pedelec Cycle. These instructions will help you to operate and maintain your Pedelec. Please read them carefully before using your cyc le and familiarise yourself well with the functioning of the system. Please also read the notes in the enclosed KETTLER g ...

  • Kettler Bicycle - page 3

     3 Contents Introduction 2 T able of contents 3 General diagram 4 Charging the battery 5 - 6 Operation and control 7 Assistance mode / range 8 T echnical data 9 - 12 Care and maintenance 13 T roubleshooting 14 Guarantee / general notes 15 ...

  • Kettler Bicycle - page 4

     4 P edelec General Diagram Pedelec General Diagram 1. Operating unit 2. Motor unit with power sensor on bottom bracket 3. Batter y 4. Battery lock 5. Charging unit a b e c d ...

  • Kettler Bicycle - page 5

     5 Charging the Battery Before using it for the first time, the battery must be charged for a t least four hours. When deli- vered, the battery is in the uncharged sta te and is in sleeping mode. The batter y can be charged in any state i.e. at any charge level. Removing the batter y T o charge the batter y , it first has to be removed from the ...

  • Kettler Bicycle - page 6

     6 Note: 1. The length of the charging process depends on the capacity and the level of the charge. 2. Charge the batter y at room temperature only . As soon as the ambient tempera ture of the batter y is less than 0° or more than 40° the batter y cannot be charged and the charging unit remains in standby mode. 3. Please observe the safety not ...

  • Kettler Bicycle - page 7

     7 Operation and Control Operating Unit The operating unit is for switching the system on and off, selecting the desired assistance level and displaying the amount of charge remaining in the batter y . Switching on Press the Power button on the operating unit on your handlebars. All the LEDs light up for 2 seconds. Important: Do not put any pres ...

  • Kettler Bicycle - page 8

     8 Assistance Mode, Range Selecting degree of assistance With the Mode button on the operating unit you can select one of three different assistance modes at an y time. Press the Mode button until you arrive at the mode you require. The best amount of assistance and the consequent range of the batter y depend on a number of factors which are bes ...

  • Kettler Bicycle - page 9

     9 Motor Bottom-bracket motor Brushless DC motor Power output: 250 W Weight: approx. 3.5 kg Control by means of frictionless magnetic torque sensor Overload When the motor is overloaded, the LEDs on the opera ting unit flash in the following pattern Overheating When the motor is overheated, the LEDs on the operating unit flash in the following p ...

  • Kettler Bicycle - page 10

     10 T echnical Data Battery Batter y power: 260 Wh, 26 V 10 Ah, removable and rechargeable T ype: Panasonic lithium, ions, manganese Model: Li-ion batter y Ni-Li NKY224B01 10 Ah Charging time: approx. 3 h., initial charge 4 h. Weight: 2.4 kg Accumulator status At the side of the batter y there is a display which indicates the charge status and t ...

  • Kettler Bicycle - page 11

     11 T echnical Data Battery Sleeping Mode In its original state and at the first start-up the ba ttery is in sleeping mode. F or this reason the batter y has to be fully charged before it is used for the first time. If the charge level drops below 50% and it is not charged for more than two weeks, it goes into sleeping mode automatically . The s ...

  • Kettler Bicycle - page 12

     12 T echnical Data Charging Unit The charging unit type NKJ38 is supplied with the cyc le. Weight of charging unit: 530 g Power supply: 220 V (50 Hz) AC Power: 62 W A charging unit is supplied with the cyc le. T o charge it, take the unit out of the box and remove the plastic foil. Failure to remove the foil may cause damage to the unit through ...

  • Kettler Bicycle - page 13

     13 Care and Maintenance Inspection Follow the instructions in the enc losed KETTLER Instructions for Assembly and Operation T yre Pressure The tyre pressure has an important influence on the performance of the Pedelec. T o ensure that the range of the batter y is not a ffected, ensure that the tyre pressure is always between 3 and 4 bar . Check ...

  • Kettler Bicycle - page 14

     14 T roubleshooting Do not attempt to repair the electric drive system, control system or batter y . F or any necessar y service or repair work, always contact your KETTLER dealer who has the necessary informa tion and expertise to carry out repairs. Reset: Errors in the sensor torque measurement In case of incorrect measurement by the torque s ...

  • Kettler Bicycle - page 15

     15 Guarantee / Gener al Notes Battery Batteries are subject to wear and tear . It is therefore normal for the capacity of the batter y to decline with increasing age, use, and frequenc y of charging. For other guarantee provisions, please refer to the KETTLER Instructions for Assembly and Operation. Ground clearance Because of the position of t ...

Manufacturer Kettler Category Bicycle

Documents that we receive from a manufacturer of a Kettler Bicycle can be divided into several groups. They are, among others:
- Kettler technical drawings
- Bicycle manuals
- Kettler product data sheets
- information booklets
- or energy labels Kettler Bicycle
All of them are important, but the most important information from the point of view of use of the device are in the user manual Kettler Bicycle.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Kettler Bicycle, service manual, brief instructions and user manuals Kettler Bicycle. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Kettler Bicycle.

Similar manuals

A complete manual for the device Kettler Bicycle, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Kettler Bicycle by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Kettler Bicycle.

A complete Kettler manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Kettler Bicycle - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Kettler Bicycle, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Kettler Bicycle, that we can find in the current document
3. Tips how to use the basic functions of the device Kettler Bicycle - which should help us in our first steps of using Kettler Bicycle
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Kettler Bicycle
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Kettler Bicycle in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Kettler Bicycle?

Use the form below

If you did not solve your problem by using a manual Kettler Bicycle, ask a question using the form below. If a user had a similar problem with Kettler Bicycle it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)