English dropdown-ico

Manual Enviro 828 DV.FS.

25 pages 1.42 mb
Download

Go to site of 25

Summary
  • Enviro 828 DV.FS. - page 1

    SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY THIS MANUAL IS PRINTED ON RECYCLED PAPER 8 2 8 By SHERWOOD INDUSTRIES LTD. Direct Vent OWNERS MANUAL Installation And Operating Instructions For Models: 828 MH (MOBILE HOME) 828 DV. FS. (Freestanding) 828 DV. INS. (Insert) WARNING If the information in this manual is not followed exactly ...

  • Enviro 828 DV.FS. - page 2

    SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" ROOM HEATER, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: • All "ENVIROGAS" gas-fired appliances must be installed in accordance with these instructions. Carefully read all the instructions in th is manual first. Consult the building authority havi ...

  • Enviro 828 DV.FS. - page 3

    TABLE OF CONTENTS 1 Code A pproval s ............................................................................................................. ..............................3 S pecificat ions ........................................................................................................... ....................................3 2 Dimens ...

  • Enviro 828 DV.FS. - page 4

    2 . DIMENSIONS AND CLEARANCES TO COMBUSTIBLES FIREPLACE INSERT: The stove can only be installed in a so lid fuel burning fireplace . Mantle pillar to stove 10” Stove top to 8” wide mantle 12” Minimum firebox size W 26” x H 20” x D 20” (NOTE; standard size shown – optional 33”H x 46”W available) FREESTANDING: Side wall to stove 10& ...

  • Enviro 828 DV.FS. - page 5

    ZERO CLEARANCE BOX ASSEMBLY; First take the kit from the box and place the surround panels as ide so as not to damage the panels. There will also be a bag of screws, nuts and bolts in the box. The bottom section of the kit will have tw o 3 inch square boxes mounted to t he bottom. First attach the bottom to the back with the screw s provided, t he ...

  • Enviro 828 DV.FS. - page 6

    3. DECIDING WHERE TO LOCATE YOUR STOVE FREESTANDING: • Locate the stove in a large and open room that is centrally located in the hous e. This will optimize heat circulation and comfort. • The stove should be located out of traffic, away from furniture and draperies and should have sufficient access for its safe operation and maintenance. • T ...

  • Enviro 828 DV.FS. - page 7

    FIREPLACE INSERT • Carefully clean the fireplace and flue before in stalling the stove. Failure to do so ma y result in fumes or dirt being blown i nto the room or insert and may cause a fire leading to death or serious injury. • If you are installing the optional fan ki t, (see Installing Fan Kit) do so now . • If the fireplace has a dropped ...

  • Enviro 828 DV.FS. - page 8

    5. INSTALLING BURNER CONTROL ASSEMBLY Remove the controls from box, che ck for shipping damage. Remove burner tray from controls (one scr ew on each side between burners). Open door. Remove grate rod by pu lling up at each end. Remove the 2 screws behind the grate and one screw on each side of control opening in firebox. Extend flex gas line and pl ...

  • Enviro 828 DV.FS. - page 9

    2. Place the log with Burnt Area forward on log supports. Locate the log by matching the bottom pegs to the receiving holes in rear log supports. 3. Close door securely 7. ELECTRICAL REQUIREMENTS T he ENVIROGAS 828 Series w ill operate wit hout an external electrical pow er supply. This model has a Millivolt gas control which uses the pilot flame t ...

  • Enviro 828 DV.FS. - page 10

    8. GAS LINE CONNECTION AND TESTING WA RNING: Only persons licensed to w ork w ith gas piping can make the gas connections to this appliance. This appliance is equipped with a 3/8” stainless steel flex line from the valve. This line ma y be routed through the hole in the rear of the pedestal, or on inserts, routed through the fire box sides. An ad ...

  • Enviro 828 DV.FS. - page 11

    9. AIR SHUTTER ADJUSTMENT • There is a separate venturi air shutter for each burner • The venturies have been set for installation at sea level to 4,500 ft. • To adjust for higher altitudes : Remove the access cover plate, loosen the air shutter locking screws w ith a long screw driver. Rotate the air shutters to the correct setting. The flam ...

  • Enviro 828 DV.FS. - page 12

    10. VENTING VENT TERMINATION CLEARANCES A= Clearance above grade, ve randah, porch, deck, or [balcony (*12 inches (30cm) minimum] B= Clearance to window or door that may be opened [*12 inches (30cm) minimum] C= Clearance to permanently closed w indow [minimum 12 inches (30cm) recommended to prevent condensation on window ] D= Vertical clearance to ...

  • Enviro 828 DV.FS. - page 13

    These models have been tested and certified for use with SIMPSON DURAVENT DIRECT VENT TYPE "GS" PIPE FOR GAS STOVE. Kits are available for vertical venting or horizontal ve nting. It is recommended that a bead of RTV High Temperature Silicone be applied to each vent joint before installation. A MINIMUM VERTICAL LENGTH OF 24" TO THE F ...

  • Enviro 828 DV.FS. - page 14

    When planning your installation, it w ill be necessary to select the proper length of vent pipe fo r y our particular requirements . It is important to note when passing thr ough a wall, the max imum allowable w all thickness is 10-inches (254mm), 1 ½ inches clearance to combustibles must be maintained. Select the amount of vertical rise desired f ...

  • Enviro 828 DV.FS. - page 15

    STEP 7. Slide the decorative wall thimble up to the wall su rface and attach with the screws provided. Apply decorative brass or chrome trim if desired. FIG-14. FIG. 11 FIG. 12 FIG-13 FIG-14 NOTES: (1) The four wood screws provided should be replaced with th e appropriate fasteners for stucco, brick, concrete, or other types of siding. (2) For buil ...

  • Enviro 828 DV.FS. - page 16

    VERTICAL INSTALLATION STEP 1. Check the instructions for required clearances (air spaces) to combustibles w hen passing through ceilings, walls, roofs, enclosures, attic rafters , or other nearby combustibl e surfaces. Do not pack air spaces w ith insulation. STEP 2. Set the gas appliance in the desired loca tion. Drop a plumb bob dow n from the ce ...

  • Enviro 828 DV.FS. - page 17

    NOTES: (1) If an offset is necessary in the attic to avoid obstruc tions, it is important to support the vent pipe every 3 feet, to avoid excessive stress on the elbows, and possible separation. Wall straps are available for this purpose. FIG- 18 (2) When ever possible, use 45 ° degree elbows instead of 90 ° degree elbows. The 45 ° degree elbow ...

  • Enviro 828 DV.FS. - page 18

    CATHEDRAL CEILING INSTALLATION Step 1. Follow installation steps 1 and 2 under Vertical Termination. Step 2. Using the plumb bob, mark the centerline of the venting system on the ceiling and drill a small hole through the ceiling and roof at this point. From the roof, locate the drill hole and mark the outline of the Cathedral Ceiling Support Box. ...

  • Enviro 828 DV.FS. - page 19

    11. MOBILE HOME FUEL CONVERSION To conve rt from Propane to Natural Gas or v ise-versa 1. Disconnect the unit from the gas supply. 2. Open the door and remove the logset. 3. Remove the burner tray (2 screw s) and the burner control assembly by removing the 8 screw s holding it into the unit. 4. Remove the control panel from the control assembly 5. ...

  • Enviro 828 DV.FS. - page 20

    12. OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIO NS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE , PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot that must be lit by hand by following these instructions exactly. B) BEFORE LIGHTING smell al ...

  • Enviro 828 DV.FS. - page 21

    13. MAINTENANCE AND TECHNICAL Periodically check to ensure that your "Direct Vent" sy stem is clear. Periodically check the pilot and burner. Check to see that all the burner ports are clean and clear. Check the pilot head for blockage. Check to ensure the pilot flame is blue wi th small yellow tips. OPENING THE DOOR Caution door is hot w ...

  • Enviro 828 DV.FS. - page 22

    14. TROUBLE SHOOTING Problem Possible Cause Solution Spark will not light the pilot after repeated pressing of spark ignitor Defective piezo ignitor Check connections to ignitor -If ignitor connections are good but there is no spark-replace ignitor Broken spark electrode -Check for broken ceramic insulation replace, electrode if broken Mis-aligned ...

  • Enviro 828 DV.FS. - page 23

    15. PARTS AND ACCESSORIES Service Parts available from your local Envirogas Dealer. PA RT # DESCRIPTION 828-001 Convection Blower 828-002 Heyco Strain Relief 828-003 2-Speed Fan Switch 828-004 Eurosit Manually Regulated Valve, Natural Gas 828-005 Eurosit Manually Regulated Valve, Liquid Propane 828-006 Pilot with Ignitor Electrode, Natural Gas 828- ...

  • Enviro 828 DV.FS. - page 24

    16. WARRANTY Sherwood Industries Ltd. offers a *Lifetime Warranty on this gas product. The lifet ime warranty covers the appliance for a period of seven years from the date of installation. This warranty applies only to the original owner in the original location Covered under the lifetime warranty are Cabinet Sides, Tops, Pe destals, Surround Pane ...

  • Enviro 828 DV.FS. - page 25

    17. INSTALLATION DATA SHEET The installer for warranty purposes and future re ference must record the following information. Envirogas Models: 828.DV. FS. (Freesta nding) Direct Vent Room Heater 828 DV. INS. (Insert) 828 DV. MH. (Mobile Home) N ame of Owner: __________________________________________ Address: _______________________________________ ...

Manufacturer Enviro Category Fire Pit

Documents that we receive from a manufacturer of a Enviro 828 DV.FS. can be divided into several groups. They are, among others:
- Enviro technical drawings
- 828 DV.FS. manuals
- Enviro product data sheets
- information booklets
- or energy labels Enviro 828 DV.FS.
All of them are important, but the most important information from the point of view of use of the device are in the user manual Enviro 828 DV.FS..

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Enviro 828 DV.FS., service manual, brief instructions and user manuals Enviro 828 DV.FS.. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Enviro 828 DV.FS..

Similar manuals

A complete manual for the device Enviro 828 DV.FS., how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Enviro 828 DV.FS. by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Enviro 828 DV.FS..

A complete Enviro manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Enviro 828 DV.FS. - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Enviro 828 DV.FS., FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Enviro 828 DV.FS., that we can find in the current document
3. Tips how to use the basic functions of the device Enviro 828 DV.FS. - which should help us in our first steps of using Enviro 828 DV.FS.
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Enviro 828 DV.FS.
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Enviro 828 DV.FS. in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Enviro 828 DV.FS.?

Use the form below

If you did not solve your problem by using a manual Enviro 828 DV.FS., ask a question using the form below. If a user had a similar problem with Enviro 828 DV.FS. it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)