-
JVC UX-V9MD - page 1
REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD For Customer Use: Enter belo w the Model No . and Serial No . which are located either on the rea r , bot- tom or side of the cabine t. Retain this information for ...
-
JVC UX-V9MD - page 2
G-1 W arnings, Cautions and Other s Caution — switch! Disconnect the mains plug to shut the power off completely . The s witch in any position does not disconnect the mains line . The pow er can be remote controlled. CA UTION T o reduce the r isk of electrical shocks, fire , etc.: 1 Do not remov e screws , cov ers or cabinet. 2 Do not expose this ...
-
JVC UX-V9MD - page 3
1 Thank you for purchasing the JVC Micro Component System. We hope it will be a valued addition to your home, giving you years of enjoyment. Be sure to read this instruction manual carefully before operating your new stereo system. In it you will find all the information you need to set up an d use the system. If you have a query that is not answer ...
-
JVC UX-V9MD - page 4
2 ■ ■ Getting Started Make sure that you have all of the following items, which are supplied with the System. Power Cord (1) AM Loop Antenna (1) Remote Control (1) Batteries (2) FM Wire Antenna (1) If any of these items are missing, contact your dealer immediately. Match the polarity (+ and –) on the batter ies with the + and – markings in ...
-
JVC UX-V9MD - page 5
3 CAUTION: Make all connections before plugging the System into an AC power outl et. Rear Panel of the Unit Using the Supplied Wire Antenna Using the Coaxial Type Conn ector (Not Supplied) A 75-ohm antenna with coaxial type connector (IEC or DIN45 325) should be connected to the FM 75-ohm COAXIAL terminal. If reception is poor, connect the outdoor ...
-
JVC UX-V9MD - page 6
4 CAUTION: Make all connections before plugging the System into an AC power outl et. For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System. 1. Open each of the terminals and insert the speaker wires firmly, then close the termin als. 2. Connect the red ( + ) and black (–) wires of the right side ...
-
JVC UX-V9MD - page 7
5 Unplug the cap and connect an (not supplied) optical digital cord between the System’s OPTICAL DIGITAL IN (AUX2) terminal and t he out- put terminal of the CD player, etc. You can listen to the digital input signal from the CD player, etc. Firmly insert the supplied AC power cord into the AC inlet on the back of the Unit. CAUTIONS : • ONLY US ...
-
JVC UX-V9MD - page 8
6 ■ ■ Common Operations VOLUME CLOCK TIMER/ SNOOZE MD REC AHB PRO PRESET TUNING SLEEP REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD MD TUNER CD CD OPEN / CLOSE MD EJECT PHONES T APE / AUX BAND STANDBY / ON ...
-
JVC UX-V9MD - page 9
7 You can reinforce the bass sound to maintain rich, full bass at low volume (you can use this effect only for playback): To get the effect, press the AHB (Active Hyper Bass) PRO but- ton. The “BASS” indicator lights up on the display. To cancel the effect, press the button again. The “BASS” indicator goes out. You can control the tone by c ...
-
JVC UX-V9MD - page 10
8 ■ ■ Using the Tuner VOLUME CLOCK TIMER/ SNOOZE MD REC AHB PRO PRESET TUNING SLEEP REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD MD TUNER CD CD OPEN / CLOSE MD EJECT T APE / AUX BAND DOWN UP MULTI CONTROL ...
-
JVC UX-V9MD - page 11
9 ■ 4. Press the UP , DOWN, >, or < button within 5 seconds to select the pr eset number . UP or > button: Increases the preset number by 1. DOWN or < button: Decreases the preset number by 1. • When the > or < button is kept pressing, the preset number changes rapidly. ■ 5. Press the SET button within 5 sec onds. “STORED? ...
-
JVC UX-V9MD - page 12
10 ■ ■ Using the CD Player MD TUNER CD CD OPEN / CLOSE MD EJECT TAPE / AUX BAND DOWN UP MULTI CONTROL STANDBY/ON PHONES REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD SET < PROGRAM REPEAT RANDOM UP > ...
-
JVC UX-V9MD - page 13
11 To stop pl aying the CD, press the 7 button. The following information for the CD is displayed. To stop playing and remove the CD, press the CD OPEN/ CLOSE 0 button on the Unit or CD 0 button on the Remote Con- trol to open the CD cover. To pause, press the CD #¥8 button. The playback time blinks on the display. To cancel pause, press the same ...
-
JVC UX-V9MD - page 14
12 ■ ■ Using the MD Player (Listening to an MD) REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD REPEAT RANDOM UP > DOWN MD #8 Track number, Playing time, Preset number ¢ 4 Repeat indicator PROGRAM 7 < ...
-
JVC UX-V9MD - page 15
13 To Select a Track or Passage within a Track —————————————— During playback, press the 4 or ¢ (< or >) button to select the track you want. The selected track starts playing. • Press the ¢ button once to skip to the beginning of the next track. • Press the 4 button to skip to the beginning of the track be- ...
-
JVC UX-V9MD - page 16
14 ■ ■ Recording onto an MD VOLUME CLOCK TIMER/ SNOOZE MD REC AHB PRO PRESET TUNING SLEEP REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD MD TUNER CD CD OPEN / CLOSE MD EJECT PHONES T APE / AUX BAND ST ANDBY ...
-
JVC UX-V9MD - page 17
15 • You can also start recording by pressing the MD REC b ut- ton and then the MD #¥8 button. ■ When you record a signal from a DAT through the AUX2 ter- minal, two track numbers (track marks) are added for one track. This is not fault. Join both tracks using the Join function. (See page 18.) ■ 5. Press the 7 button to stop r ecording. “U ...
-
JVC UX-V9MD - page 18
16 ■ ■ Using the MD Player (Editing) In addition to its recording and play functions, the MD Player comes with editing functions. You can divide, join, move, or era se the recorded tracks in the MD as required. Also, you can give a disc title to the MD and track titles to the tracks in the MD. Dividing tracks (DIVIDE function) This involves add ...
-
JVC UX-V9MD - page 19
17 ■ Use the Remote Control to carry out this function. ■ 1. Insert an MD to be edited with its label side up. ■ 2. Press the MD #8 button and then 7 button to set the function to MD. The track numbers and total playback time are displayed. ■ 3. Press the EDIT/TITLE button until “DIVIDE ?” is displayed. The “EDIT” indicator appears ...
-
JVC UX-V9MD - page 20
18 ■ Use the Remote Control to carry out this function. ■ 1. Insert an MD to be edited with its label side up. ■ 2. Press the MD #8 button. • You can also perform this function in Stop mode. ■ 3. Press the EDIT/TITLE bu tton until “JOIN ?” is displayed. The “EDIT” indicator appears on the display. DIVIDE = JOIN = MOVE = ERAS E = A ...
-
JVC UX-V9MD - page 21
19 ■ 2. Press the MD #8 button. • You can also perform this function in Stop mode. ■ 3. Press the EDIT/TITLE button until “ERASE ?” is displayed. The “EDIT” indicator appears on the display. DIVIDE = JOIN = MOVE = ERAS E = ALL ERASE = DISC TITLE* = TI TLE = (Back to the beginning) *: Displayed in Stop mode only. ■ 4. Press the SET b ...
-
JVC UX-V9MD - page 22
20 ■ 5. Input a pre ferred title (up to 64 charac- ters). Use the following buttons to input a title. [Title editing buttons an d their functions] (see below) Example: When input the title “N(space)1” 1. Display the letter N to be input. • Press the > button until the letter N is displayed. OR • Press the DOWN button until “KLMNO” ...
-
JVC UX-V9MD - page 23
21 ■ ■ Using External Equipment REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEA T BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD MD TUNER CD CD OPEN / CLOSE MD EJECT PHONES T APE / AUX BAND ST ANDBY / ON DOWN UP MUL TI CONTROL TAPE/AUX TAPE/AUX You can li ...
-
JVC UX-V9MD - page 24
22 ■ ■ Using the Timers VOLUME PRESET TUNING CLOCK SLEEP TIMER/ SNOOZE MD REC AHB PRO REMOTE CONTROL RM-RXUV 9 MD DIMMER SLEEP DISPLAY FM MODE TAPE / AUX AHB PRO AUTO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL EDIT / TITLE CHARA UP SET DOWN TUNER BAND MD VOLUME CD MD TUNER CD CD OPEN / CLOSE MD EJECT PHONES TAPE / AUX BAND STANDBY / ON ...
-
JVC UX-V9MD - page 25
23 ■ 5. Setting the volume level. 1. Press the TIMER/SNOOZE button on the Unit. The volume level set by the previous timer setting blinks on the display. 2. Press the ¢ or 4 button to select the volume level. -- : The current volume level will be used. 0 to 50 : When the timer is turned on, the Volume will be automatically se t to the select ed ...
-
JVC UX-V9MD - page 26
24 ■ ■ Information on MDs (Minidiscs) This is a new digital audio disc format: it has a diameter of 64 mm and enables up to 80 minutes of playback and recording. The cartridge The diameter of the disc itself is 64 mm, smaller than a CD single. The disc sits inside a 68 ✕ 72 mm cartridge, which also being pocket size, makes minidiscs extremely ...
-
JVC UX-V9MD - page 27
25 ■ ■ MD (Minidisc) Messages ■ ■ Minidisc Limitations The minidisc records information in an original format that differs from that of conventional cassette tapes or DATs. Since the re are some lim- itations with this recording format, the following types of conditions may arise. These conditions are not malfunctions. Message Meaning Actio ...
-
JVC UX-V9MD - page 28
26 ■ ■ Rules of Digital Dubbing The following rules regarding copyright exist for dubbing to MDs from CDs or DATs through digital terminals. SCMS (Serial Copy Management System) Minidiscs can record clear sound with low loss of quality from CDs or DATs through each component’s digital input/output termin al. However, minidiscs are set up so t ...
-
JVC UX-V9MD - page 29
27 ■ ■ Troubleshooting • If you are having a problem with your System, check this list for a possible solution before calling for service. • If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your dealer , for service. Symptom P ossible Cause Action No sound ...
-
JVC UX-V9MD - page 30
28 ■ ■ Specifications Amplifier Output Power 36 W (18 W + 18 W) at 4 ohms (Max.) 28 W (14 W + 14 W) at 4 ohms (10% THD) Input Sensitivity/Impedance (1 kHz) LINE IN (AUX1) 500 mV/65 kohms Optical In (AUX2) –24 dBm - –15 dBm Output Sensitivity /Impedance (1 kHz ) LINE OUT 500 mV/4.3 kohms Speaker terminals 4 - 16 ohms Phones 16 ohms - 1 kohms ...
-
JVC UX-V9MD - page 31
VICT OR COMP ANY OF JAP AN, LIMITED EN 0699MNMCREJSC UX-V9MD(A)-Back cover.fm Page 1 Tuesday, June 15, 1999 2:34 PM ...
Do you have a question concerning JVC UX-V9MD?
Use the form below
If you did not solve your problem by using a manual JVC UX-V9MD, ask a question using the form below. If a user had a similar problem with JVC UX-V9MD it is likely that he will want to share the way to solve it.