Manual Monarch PLT200

14 pages 2.45 mb
Download

Go to site of 14

Summary
  • Monarch PLT200 - page 1

    Pocket Laser T ach 200 (PL T200) T achometer / Rate Meter / T ot alizer / Timer MONARCH INSTRUMENT Instruction Manual 15 Columbia Drive Amherst, NH 03031-2334 USA Phone: (603) 883-3390 Fax: (603) 886-3300 E-mail: support@monarchinstrument.com Website: www.monarchinstrument.com Printed in the U.S.A. Copyright 2004 Monarch Instrument, all rights rese ...

  • Monarch PLT200 - page 2

    SAFEGUARDS AND PRECAUTIONS W ARNING - This product emits a visible beam of laser light. Avoid exposure to the laser radiation. The use of optical viewing aids (binoculars, for example) may increase the ocular hazard. CAUTION - The laser beam should not be intentionally aimed at people or animals. CAUTION - Use of controls or adjustments or performa ...

  • Monarch PLT200 - page 3

    T ABLE OF CONTENTS T ABLE OF CONTENTS 1 . 0 OVERVIEW ............................................................................. 1 2 . 0 FEA TURE LOCA TIONS ............................................................ 1 3 .0 LCD DISPLA Y SYMBOLS ....................................................... 2 4 .0 PL T200 SPECIFICA TIONS ............... ...

  • Monarch PLT200 - page 4

    1 1. 0 OVERVIEW The Pocket Laser T ach 200 is a precision hand-held multifunction T achometer , Ratemeter , T otalizer and Timer . It is programmable to display directly in Revs, Inches, Feet, Y ards, Miles, Centimeters and Meters or function as a stopwatch or interval timer . Input / output sockets allow for remote sensing and pulse output to exte ...

  • Monarch PLT200 - page 5

    2 3.0 LCD DISPLA Y SYMBOLS On T arget Indicator . Blinks on whenever there is an input signal. Will appear to be solid on at higher frequencies. Low Battery icon. Indicates that the batteries are low and need to be replaced. T imes T en icon. Indicates that the value shown is ten times that which is displayed. Laser Indicator . Red laser is on when ...

  • Monarch PLT200 - page 6

    3 4.0 PL T200 SPECIFICA TIONS Laser Specifications: Classification: Class 3R (per IEC 60825-1 Ed 1.2 2001-8) Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No. 50, dated July 26, 2001. Maximum Laser Output: 3mW Pulse Duration: Continuous Laser W avelength: 650 nm Beam Divergence: < 1.5 m ...

  • Monarch PLT200 - page 7

    4 Contact Specifications (continued): Accuracy: Revs: ±0.05% of reading (RPM) or resolution limit (with no slippage) Linear: ± 0.5% of reading or resolution limit (with no slippage) Contact Measurements Ranges: T ACHOMETER: Revolutions per Minute (RPM) 0.5 to 20,000 RPM Revolutions per Second (RPS) 0.0833 to 333.33 RPS Revolution per Hour (RPH) 3 ...

  • Monarch PLT200 - page 8

    5 Contact Measurements Ranges (continued): RA TES: Wheel Circumference: Y ards per Hour 10cm: 3.281 to 131,233 YPH 12 in: 10.000 to 240,000 YPH Miles per Hour 10 cm: 0.002 to 74.564 MPH 12 in: 0.006 to 136.36 MPH Centimeters per Second 10 cm: 0.084 to 3,333.3 CM/S 12 in: 0.21 to 3,048.0 CM/S Centimeters per Minute 10 cm: 5.000 to 200,000 CM/M 12 in ...

  • Monarch PLT200 - page 9

    Display: 5 x 0.5” (12.7mm) numeric digits plus 5 Alpha-numeric LCD Batteries: 2 “AA” 1.5 V (DC) alkaline included (Note: Batteries are NOT rechargeable.) Battery Life: 30 hours continuous typical with batteries provided External Input: Absolute max: -0.3 V to 5 V (DC) Minimum: low below 1.2 V and high above 2 V (TTL compatible) Edge: Triggers ...

  • Monarch PLT200 - page 10

    7 5.0 PREP ARA TION FOR MEASUREMENT 5. 1 Non-Contact Preparation For Internal operation (Red laser) or External operation using optional Remote Optical Sensor (ROS-Red LED). 5 .2 Direct Contact Preparation For External operation ONL Y using optional Remote Contact Assembly (RCA). 1. Clean Shaft As small as 1/8” wide on side or radius edge 2. Appl ...

  • Monarch PLT200 - page 11

    8 5 .3 Connecting External Sensors Plug sensor into Input socket Tighten screw securely into flat on shaft. Remote Optical Sensor (ROS-P) Install with pin in shaft fully seated in slot. Tighten screw . 2. 10 cm Wheel 3. 12 inch Wheel OR Remote Contact Assembly (RCA) (shown with optional 12 inch wheel)      In S S S S S Infrared Senso ...

  • Monarch PLT200 - page 12

    9 6.0 T ACHometer Mode 6 .1 T ACHometer Setup 1. Turn Power ON 2. Enter Setup Mode 3. Enter selection of Mode 4. Select T ACH Mode 5. Save and advance 6. Enter selection of Units OR Repeat until TACH displayed Last Mode selected is displayed 1 a . T o toggle Lock On/Off RPS , RPM or RPH Last Units selected are displayed Locked On Press and Hold 14 ...

  • Monarch PLT200 - page 13

    NONE , 1 , 2 or 3 OR Repeat until desired decimal places displayed Unit will remember these settings (including lock on/off) even if turned off and back on. OR Repeat until desired Units displayed DONE , then Units selected 10 7. Select Units 8. Save and advance 9. Enter selection of number of decimal places 10. Select decimal places 11. Save and a ...

  • Monarch PLT200 - page 14

    11 Measure Recall Max Recall Min If unit Locked on: Power OFF Min Speed Max Speed Automatic after 90 seconds if unit not Locked on OR Press and hold Lock on 6 .2 T ACHometer Operation Resets Max/Min OR 12 1. Turn Power ON 2. Enter Setup Mode 3. Enter selection of Mode 4. Select RA TE Mode 5. Save and advance OR T oggles between RATE and TOTAL . Sel ...

Manufacturer Monarch Category Automobile Parts

Documents that we receive from a manufacturer of a Monarch PLT200 can be divided into several groups. They are, among others:
- Monarch technical drawings
- PLT200 manuals
- Monarch product data sheets
- information booklets
- or energy labels Monarch PLT200
All of them are important, but the most important information from the point of view of use of the device are in the user manual Monarch PLT200.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Monarch PLT200, service manual, brief instructions and user manuals Monarch PLT200. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Monarch PLT200.

Similar manuals

A complete manual for the device Monarch PLT200, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Monarch PLT200 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Monarch PLT200.

A complete Monarch manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Monarch PLT200 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Monarch PLT200, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Monarch PLT200, that we can find in the current document
3. Tips how to use the basic functions of the device Monarch PLT200 - which should help us in our first steps of using Monarch PLT200
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Monarch PLT200
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Monarch PLT200 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Monarch PLT200?

Use the form below

If you did not solve your problem by using a manual Monarch PLT200, ask a question using the form below. If a user had a similar problem with Monarch PLT200 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (1)

Tony

We are using a laser tach with the Monarch PLT200. The laser is working properly but the display reads "0".