English dropdown-ico

Manual Harman HK 990

18 pages 2.19 mb
Download

Go to site of 18

Summary
  • Harman HK 990 - page 1

    Int egr at ed a mpl ifie r HK 990 Owner’s Manual ...

  • Harman HK 990 - page 2

    T able of Contents HK 9 9 0 2 SAFETY INSTRUCTIONS 3 INTRODUCTION AND FEA TURES 4 FRONT P ANEL CONTROLS AND FUNCTIONS 5 REAR P ANEL CONNECTIONS 6 REMOTE CONTROL 8 REMOTE CONTROL FUNCTION LIST 10 SETUP INSTRUCTIONS 11 Input Setup 11 Speaker Setup 12 EzSet/EQ Setup 12 Level Setup 13 OPERA TING INSTR UCTIONS 14 Listening 14 Recording 14 TROUBLESHOOTING ...

  • Harman HK 990 - page 3

    Safety Instructions HK 9 9 0 3 Important Safety Instructions Read these instructions. 1 . Keep these instructions. 2 . Heed all warnings. 3 . Follow all instructions. 4 . Do not use this apparatus near water . 5 . Clean only with a dry cloth. 6 . Do not block any ventilation openings. Install in accordance with the manufacturer’ s instructions. 7 ...

  • Harman HK 990 - page 4

    4 HK 9 9 0 Introduction Congratulations on your choice of the Harman Kardon ® HK 990 Integrated Amplifier . In order to obtain the best performance from this integrated amplifier , please be sure to read this owner’s manual and use your integrated amplifier only in accordance with its instructions. In terms of ra w po wer , the HK 990 is the ...

  • Harman HK 990 - page 5

    5 HK 9 9 0 Controls and Functions 1 Power indicator: This LED will illuminate in amber when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn white. 2 System power control: Press this button to turn on the HK 990; press it again to turn the unit off (to Standby). ...

  • Harman HK 990 - page 6

    6 HK 9 9 0 Connections 0 Right Speaker output, System 2. 1 Right Speaker output, System 1. 2 RS-232 connector for possible future PC update, plus Update switch. 3 Input jacks for one or two subwoofer signals from external surround processor . 4 Output jacks for two subwoofers. 5 Digital Coaxial output jack for digital recording. Also permits digita ...

  • Harman HK 990 - page 7

    7 HK 9 9 0 Connections Connecting Other Components Make sure your amplifier and other components are turned off. 1. Connect each component’s output/play jacks to the corresponding input jacks on the 2. back of your amplifier and, if available, the component’s input/record jacks to the output jacks of the H K 990. Use the white, black or gray ...

  • Harman HK 990 - page 8

    8 HK 9 9 0 Remote Control Independent Remote Control The system remote of the HK 990 can control the amplifier , compa tible tuners, CD players and CD recorders. The Remote In jack of units without an integra ted IR receiver must be connected to the amplifier’s Remote Control Output jack so tha t the system remote control can operate them. Impo ...

  • Harman HK 990 - page 9

    9 HK 9 9 0 Remote Control HK 990 Remote Control Functions Device On/Off : Press these two buttons to s witch on and off a (Harman Kardon) device selected with the Mode button or selected by pressing its System On source button (in both cases, the System On device button lights up). System Off : Press to switch off the entire system (the HK 990 and ...

  • Harman HK 990 - page 10

    10 HK 9 9 0 Remote Function List Button name HK 990 CD player T uner CDR T ape TV , Processor , Phono, Aux Device On (Selected device) On On On On On - Device Off (Selected device) Off Off Off Off Off - System Off (All devices off) Off Off Off Off Off Off Amp Amp select Amp select Amp select Amp select Amp select Amp select Processor Processor inpu ...

  • Harman HK 990 - page 11

    11 HK 9 9 0 Setup Instructions HK 990 – Setup Here are the factory settings of the HK 990 stereo integrated amplifier: Source listen: CD • Source record: CD • Processor input: analog unbalanced • CD input: analog unbalanced • T uner input: analog unbalanced • Aux input: analog unbalanced • CDR input: digital coaxial 1 • T ape input ...

  • Harman HK 990 - page 12

    12 HK 9 9 0 Setup Instructions Audio Mode The HK 990 can handle analog as well as digital signals. It can process any input in the digital domain to equalize the signal and tailor the sound to the loudspeakers and room acoustics, once either the EzSet / EQ or the Manual Bass Management has been set up (see below). Y ou choose the method and the pro ...

  • Harman HK 990 - page 13

    13 HK 9 9 0 Setup Instructions c) Once the sweeps are performed without error , the display will show “Filter Design, please wait…” During this process, the filter parameters are computed and written into the DSP flash memor y . When this is done, the system goes to Step 4. d) “Place mic at 60cm in front of the left speaker” appears in ...

  • Harman HK 990 - page 14

    14 HK 9 9 0 Operating Instructions Listening to Y our CD Player , T ape Deck, T uner or Other Source Press the Power switch 1. 2 to turn on the amplifier . The power indicator lights white and the protection circuitry checks for short circuits or other problems for a few seconds before sound output. Press “Speaker 1” to hear loudspeakers conne ...

  • Harman HK 990 - page 15

    15 HK 9 9 0 T roubleshooting T roubleshooting This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So if you ha ve a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon service center . If the problem is... Make sure that... No ...

  • Harman HK 990 - page 16

    HK 9 9 0 16 Specifications Specifications Continuous average power per channel (FTC), 20Hz – 20kHz, both channels driven: 150 watts @ <0.03% THD (8 ohms) 300 watts @ <0.3% THD (4 ohms) Dynamic power (1HF , 1kHz tone burst): 220 watts (8 ohms) 440 watts (4 ohms) High instantaneous current capability (HCC): ±200 amps Power bandwidth @ half-r ...

  • Harman HK 990 - page 17

    ...

  • Harman HK 990 - page 18

    Harman Consumer, Inc. 8500 Balboa Boulevard, Northridge, CA 91329 USA 516.255.4545 (USA only) Made in P.R.C. © 2010 Harman International Industries, Incorporated. All rights reserved. Features, specifications and appearance are subject to change without notice. Harman Kardon is a trademark of Harman International Industries, Incorporated, register ...

Manufacturer Harman Category Car Amplifier

Documents that we receive from a manufacturer of a Harman HK 990 can be divided into several groups. They are, among others:
- Harman technical drawings
- HK 990 manuals
- Harman product data sheets
- information booklets
- or energy labels Harman HK 990
All of them are important, but the most important information from the point of view of use of the device are in the user manual Harman HK 990.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Harman HK 990, service manual, brief instructions and user manuals Harman HK 990. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Harman HK 990.

Similar manuals

A complete manual for the device Harman HK 990, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Harman HK 990 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Harman HK 990.

A complete Harman manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Harman HK 990 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Harman HK 990, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Harman HK 990, that we can find in the current document
3. Tips how to use the basic functions of the device Harman HK 990 - which should help us in our first steps of using Harman HK 990
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Harman HK 990
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Harman HK 990 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Harman HK 990?

Use the form below

If you did not solve your problem by using a manual Harman HK 990, ask a question using the form below. If a user had a similar problem with Harman HK 990 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)