English dropdown-ico

Manual Vector VEC1095A

12 pages 0.42 mb
Download

Go to site of 12

Summary
  • Vector VEC1095A - page 1

    SMAR T AUT OMA TIC BA TTER Y CHARGER OWNER’S MANUAL & W ARRANTY INFORMA TION 12 VOL T 2/10/25 AMP WITH 75 AMP ENGINE ST AR T AL TERNA T OR VOL T AGE CHECK AND BA TTER Y RECONDITION FUNCTIONS • IMPOR T ANT SAFETY INSTRUCTIONS • W ARNING – RISK OF EXPLOSIVE GASES W ARNING - RISK OF EXPLOSIVE GASES 1. WORKING IN VICINITY OF A LEAD-ACID BA ...

  • Vector VEC1095A - page 2

    PERSONAL PRECAUTIONS AND SAFETY 1. Another person should be close enough to come to your aid when you work near a lead-acid battery . 2. Fresh water and soap should be nearby in case battery acid contacts skin, clothing, or eyes. 3. Wear eye protection and protective clothing. Avoid touching eyes or skin while working with a battery . If acid parti ...

  • Vector VEC1095A - page 3

    PREP ARING TO CHARGE 1. Determine voltage of battery by referring to car owner's manual. 2. If necessary , remove battery from vehicle to charge, or to clean terminals, always remove grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc. 3. Clean battery terminals. Be careful to keep ...

  • Vector VEC1095A - page 4

    FOLLOW THESE STEPS WHEN BA TTER Y IS INST ALLED OUTSIDE VEHICLE. A SP ARK NEAR BA TTER Y MA Y CAUSE BA TTERY EXPLOSION. TO REDUCE RISK OF A SP ARK NEAR BA TTERY : 1. Check polarity of battery posts for top-mounted battery connectors, the Positive posts (marked POS,P , +) usually has a larger diameter than the Negative battery post (marked NEG, N,-) ...

  • Vector VEC1095A - page 5

    INTRODUCTION AND FEA TURES Thank you for selecting the V ector Model VEC1095A 2/10/25 AMP 12 V olt Smart Battery Charger , with Alternator V oltage Check and Battery V oltage Check functions. With proper care and use, it will give you years of dependable service. This battery charg- er has a high charge rate of up to 25 amps, and low charge rate of ...

  • Vector VEC1095A - page 6

    FIGURE 3A (FRONT VIEW) W ARNINGS: THERE ARE NO USER-SER VICEABLE P ARTS IN THIS CHARGER. DO NOT OPEN THE UNIT! IT MUST BE RETURNED TO POWER ON BOARD FOR PROFESSIONAL TESTING AND REP AIR. OPENING THE UNIT WILL VOID THE MANUF ACTURER'S W ARRANTY . Contact the V ector T echnical Support Department at (954) 584-4446 or toll free: (866) 584-5504 fo ...

  • Vector VEC1095A - page 7

    Below the Digital Display are series of six LEDS that light on the following conditions: WET - Lights when battery type selector is on WET battery type GEL - Lights when battery type selector is on GEL battery type AGM - Lights when battery type selector is on AGM battery type. Float Charge - Lights when automatic charge monitoring is active. This ...

  • Vector VEC1095A - page 8

    CHARGING THE BA TTERY 1. Charger displays circulating pattern when battery and AC power are connected properly . Select battery type and press 2/10/25 AMP button to begin charging at 2 amps rate; the charger sounds a beep and displays charging current. W ARNING: If Charger displays F02, and lights F AUL T indicator , the connection to battery termi ...

  • Vector VEC1095A - page 9

    NOTE: BA TTER Y VOL T AGE button is disabled in Alternator Check mode. AL TERNA TOR VOL T AGE CHECK: will not work in normal charge mode it will only work in the stand-by mode when the LED display is showing “000” or a circulating pattern. P ART 1: No Load (Turn OFF all vehicle’ s accessories): The battery must be fully charged before testing ...

  • Vector VEC1095A - page 10

    TROUBLESHOOTING - F AUL T LED LIT The following conditions may cause the F AUL T CODES to be displayed: • Poor connection to battery (or frame). • Charging too fast - Decrease Charge Rate - Press 2/10/25 AMP button to lower rate. • Charging too slowly - Battery is large and did not complete charging in 24 hours - Press 2/10/25 AMP to charge a ...

  • Vector VEC1095A - page 11

    PERCENT OF CHARGE 75% 50% 25% 0% 2 AMPS 6.5 12 NR NR 10 AMPS 1.8 3.0 4.5 6 25 AMPS 0.8 1.4 2 2.7 * Not recommended The times shown in the chart above are approximate and refer to an average automotive battery . For smaller batteries, the charg e time should be adjusted using the formula shown below and adding 1 hour to the time calculated. T o esti ...

  • Vector VEC1095A - page 12

    W ARRANTY T his limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of V ector Manufacturing, Ltd., regarding this product. There is no other warranty , other than described herein. This V ector Manufacturing, Ltd. product is warranted, to the original purchaser only , to be free of defe ...

Manufacturer Vector Category Automobile Battery Charger

Documents that we receive from a manufacturer of a Vector VEC1095A can be divided into several groups. They are, among others:
- Vector technical drawings
- VEC1095A manuals
- Vector product data sheets
- information booklets
- or energy labels Vector VEC1095A
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vector VEC1095A.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vector VEC1095A, service manual, brief instructions and user manuals Vector VEC1095A. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vector VEC1095A.

Similar manuals

A complete manual for the device Vector VEC1095A, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vector VEC1095A by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vector VEC1095A.

A complete Vector manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vector VEC1095A - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vector VEC1095A, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vector VEC1095A, that we can find in the current document
3. Tips how to use the basic functions of the device Vector VEC1095A - which should help us in our first steps of using Vector VEC1095A
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vector VEC1095A
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vector VEC1095A in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vector VEC1095A?

Use the form below

If you did not solve your problem by using a manual Vector VEC1095A, ask a question using the form below. If a user had a similar problem with Vector VEC1095A it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Johann

Guten Tag, Könnten Sie mir bitte mitteilen, wann, wie oft und welches Service bei Olympia Splendid Issimo pure 12 durchzuführen ist. Vielen Dank. +43650 8311536 MfG Johann Thron