English dropdown-ico

Manual Packard Bell W7

18 pages 1.95 mb
Download

Go to site of 18

Summary
  • Packard Bell W7 - page 1

    Packard Be ll EasyNote W7 Se ries (Dragon SN) Disassembl y Manual ...

  • Packard Bell W7 - page 2

    0 Table of C ontents Overv iew 1 Disassem bl y Inst ructions 1 Reassem bly Instructions 1 Required Too ls 1 Hazardous V oltage 2 Avoid E l ectrostat ic Discharge 2 Pow er Supply Un it 2 Battery and AC A dapter 4 Rem oving the Hard D isk Drive 4 Bottom Panel 5 CPU, V GA M odul e and Heat Sink 6 Top Cove r 7 Rem oving the LCD Pane l Assem bly 9 Disas ...

  • Packard Bell W7 - page 3

    1 Overview This docum ent contains step-by-step disass em bly i nstructions for the Easy Note W 7 (Dragon SN) chass i s. The instruct ions are illust rated w here n ecessary w ith im ages of the part that is be ing rem oved or d isassem bl e d. Packard Bell rese rves the right to m ake changes to the chass is without not i ce. Disassembly Instructi ...

  • Packard Bell W7 - page 4

    2 Hazardous Vol tage There is hazar dous voltage p resent inside the com puter when it is connect ed to an AC supply, even w hen the com puter’ s pow er sw itch i s off. Ex posure to hazardous vo ltage could cause person al injury. To avoid risk of injury, contac t an Auth orized Servic e Provide r for proper (un) insta llation of optiona l hardw ...

  • Packard Bell W7 - page 5

    3 WAA R SCHUWING Zorg er voor dat a lle verbind in gen v an en naar de com puter (stroom, m ode m, netw erk, etc) verbroken w orden voordat de behu izing geopend wordt. Zet de com puter nooit aan als de behuizin g geopend is. AVVERT ENZ A Prim a di rim uovere il coperch io del tela io , as s icur ars i che i l sis t em a sia scollegato da ll’ ali ...

  • Packard Bell W7 - page 6

    4 Battery a nd AC Adapter To rem ove the battery, d o as follow s: 1. Turn off the com puter. 2. Disconn ect the AC ad apter. 3. Rem ove the batte ry. Removing the Hard Disk Drive To rem ove the hard disk d rive, perform the follow in g steps: 1. Remove two screws (2 xA) from the HDD cove r (as sh ow n in Fig. 1). 2. Rem ove the HDD cover. 3. Rem o ...

  • Packard Bell W7 - page 7

    5 Bottom Panel Perform the follow ing steps to remove the bott om panel: 1. Rem ove nine screw s (9xA) and take aw ay the bottom panel. 2. Rem ove the m e m ory m odule. 3. Lift out th e TV Tuner M i n i-PCI card from its slot. 4. Disconn ect the antenna cable and the tw o data cables. 5. Disconnec t the TV Tuner d ata cables from the mainboard. 6. ...

  • Packard Bell W7 - page 8

    6 7. Remove the screw s (2xA) from the m ode m . 8. Release the ground cable and tak e aw ay the m ode m . 9. Disconnect the m odem cable from the m ode m. CP U, V GA Module an d Heat S ink To rem ove the heat s in k from the CPU and th e VGA M obi le PC I Express M odul e (MX M) follow the steps below : 1. Disconnect the CPU fan cab l e. 2. Rem ov ...

  • Packard Bell W7 - page 9

    7 6. Re m ove the screw from the VGA m odul e (1xT). 7. Pull the VGA m odul e out of the MXM slot. 8. Unlock the CPU socket an d rem ove the CPU. Top Cover Rem ove the top cover by f ollow in g the steps b elow: 1. Slide the button bar to the left to unlock it. 2. Disconnect the m ul t imedia keybo ard flat cab le and take aw ay the button bar. 3. ...

  • Packard Bell W7 - page 10

    8 6. Disconnect the touchpad f l at cab l e. 7. Re m ove the two hi ng e covers. 8. Disconnect the lid switch conn ector. 9. Rem ove the screw (1xD) and rem ove the lid sw itch unit. Fig. 1 0 Removi ng the keyboa rd flat cabl e . Fig. 1 1 Di sconnect i ng t ouchp ad flat cable Fig. 1 2 The hi nge covers. Fig. 1 3 Li d sw i tc h and hi nges. ...

  • Packard Bell W7 - page 11

    9 Removing the LC D Panel Asse mbly Follow the steps below to remove the LCD pa nel : 1. Disconnect the two LCD connectors. 2. Release the W ireless antenna ca ble. 3. Rem ove the screws (4xF) from the hinges (see Fig. 13). 4. Take away the LCD assem bl y. Disassembling the LCD Panel Assembly To disassem ble the LCD pan el, fo llow the steps be low ...

  • Packard Bell W7 - page 12

    10 Fig. 1 5 LCD di sp lay panel . 10. Disconnect the inverter backlight connector. Fig. 1 6 LCD i nverter backli ght connecter. 11. Rem ove the lower support ing bracket. 12. Take aw ay the LCD display panel and inverter board. 13. Disconn ect the LCD cab le from the inverter b oard. 14. Disconnect the LCD cab le f rom the back of th e LCD display ...

  • Packard Bell W7 - page 13

    11 15. Rem ove the screws (3x D, 1xA) from the l eft L CD bracket. The sam e goes for the right bracke t. Fig. 1 8 LCD di sp lay cabl e. 16. Take away the top, left and right bracket from the LCD display pane l. 17. Rem ove the screws (2xD) holding the w ireles s antenna and take away the antenna. Fig. 1 9 W irel ess antenna. ...

  • Packard Bell W7 - page 14

    12 Optical Di sk Drive To rem ove the optica l disk dr ive, fo llow the steps be lo w : 1. Remove the screws (2xB) and push t he opt i cal d isk d rive out of i ts bay. Fig. 2 0 The sc re ws o f the op ti cal di sk dr i ve. 2. Rem ove the screw s (2xK) from the side ODD bracket and remove it. 3. Rem ove the screw s (2xK) from the rear ODD bracket a ...

  • Packard Bell W7 - page 15

    13 Bottom Base Asse mbly Disassem bl e the bottom base assembly as fo llows: 1. First remove the screw s (4XA) from the top cover. 2. Then rem ove the screws (4xJ). No te: Mak e su re tha t du ring re -as se mbl y the c lips o f the top co ve r loc k i nto plac e be fore fas tenin g the scre ws. 3. Turn over th e un it a nd r em ove the screw s (18 ...

  • Packard Bell W7 - page 16

    14 4. Re m ove the screws from the rear (2x B). 5. Remove bottom cover from base assem bl y. 6. Disconnect the s ubwoofer conn ector. 7. Rem ove the screws (2x G) and lift out the s ubw oofer assem bl y. 8. Re m ove the rubber stab ili z ers (2x M) fro m the subwoofer assem bl y. 9. Re m ove the screw (1xB) from the m odem connector board. 10. Disc ...

  • Packard Bell W7 - page 17

    15 8. Take away the m ain board. 9. Partially rem ove the foil over the to uchpad. 10. Disconnect the touchpad cable. 11. Remove the screws (3xB) and rem ove the heat plate. 12. Push out the touchpa d assem bly. Fig. 2 6 The mai n board and speake rs . Fig. 2 7 The touch pad connec tor. Fig. 2 8 Removi ng the heat pl ate. ...

  • Packard Bell W7 - page 18

    16 Notice The inform ation in this guide is subj ect to cha nge without notice. This guide c ontains inform atio n protect ed by copyr ig ht. No part of th is guide m ay be photocop ied or reproduc ed in any f orm or by any m eans without pr ior w ritten cons ent from NEC Computers Intern ational BV. NEC COM PUT ERS INTERNATIONAL BV SHALL NOT BE LI ...

Manufacturer Packard Bell Category Laptop

Documents that we receive from a manufacturer of a Packard Bell W7 can be divided into several groups. They are, among others:
- Packard Bell technical drawings
- W7 manuals
- Packard Bell product data sheets
- information booklets
- or energy labels Packard Bell W7
All of them are important, but the most important information from the point of view of use of the device are in the user manual Packard Bell W7.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Packard Bell W7, service manual, brief instructions and user manuals Packard Bell W7. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Packard Bell W7.

Similar manuals

A complete manual for the device Packard Bell W7, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Packard Bell W7 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Packard Bell W7.

A complete Packard Bell manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Packard Bell W7 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Packard Bell W7, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Packard Bell W7, that we can find in the current document
3. Tips how to use the basic functions of the device Packard Bell W7 - which should help us in our first steps of using Packard Bell W7
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Packard Bell W7
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Packard Bell W7 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Packard Bell W7?

Use the form below

If you did not solve your problem by using a manual Packard Bell W7, ask a question using the form below. If a user had a similar problem with Packard Bell W7 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)