Manual SWR Sound 350x

20 pages 0.59 mb
Download

Go to site of 20

Summary
  • SWR Sound 350x - page 1

    350x OWNER’S MANUAL SWR • CORONA, CA • USA ...

  • SWR Sound 350x - page 2

    IMPORTANT SAFETY INSTRUCTIONS CAUTION: TO REDUCE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER OR BACK. NO USER-SERVICE- ABLE P ARTS INSIDE. PLEASE REFER TO A QUALIFIED SERVICE TECHNICIAN. A. Read Instructions: All safety and operation instr uctions should be read befor e the product is operated. B. Retain Instructions: The safety and operating i ...

  • SWR Sound 350x - page 3

    INTRODUCTION Congratulations on your pur chase of the SWR 350x Bass Amplifier! Y ou now own the cor nerstone amp of SW R’s world-r enowned Pr ofessional Line of products for bassists. A little histor y : The SWR 350x is an upgraded version of the Bass 350, a model we’ve of fer ed for over ten years as a simple and straightfor w a r d solution f ...

  • SWR Sound 350x - page 4

    Note: Please take a moment to verify that the following items wer e included in your SWR 350x packaging: AC Cable, User Guide, SubW ave Activator Footswitch, 1/4" to 1/4" Footswitch Cable, SWR Catalog. 350X • FRONT PANEL FEATURES • Dual independent input jacks compatible with both passive and active instr uments • P r eamp Gain cont ...

  • SWR Sound 350x - page 5

    Sensitivity (full output under clipping, 8 ohms load, 100 Hz): Passive Input Jack: 38 millivolts Active Input Jack: 60 millivolts Power Amplifier (Ef fects Retur n Jack “in”): 5 volts Input Impedance Passive/Active Input: 800k Ohms Active Input: 60k Ohms Ef fects Retur n: 27k Ohms Output Impedance Ef fects Send: 100 Ohms T uner Send: 100 Ohms X ...

  • SWR Sound 350x - page 6

    Impor tant: The minimum total impedance when operating the 350x is 2 ohms. This means you can safely use: a) A single 8 ohm cabinet b) A single 4 ohm cabinet c ) T wo 8 ohm cabinets (total: 4 ohms) d) T hr ee 8 ohm cabinets (total: 2.6 ohms) e ) Two four ohm cabinets (total: 2 ohms) ** **Running the amplifier constantly at 2 ohms, while technically ...

  • SWR Sound 350x - page 7

    amp clip circuit for this r eason. Active Input Jack The Active input jack should be used with instr uments having a built-in (on boar d) p r eamp or other sound sour ces that will pr oduce output levels gr eater than 1 volt RMS. The number of bass manufactur ers has in creased significantly over the years, and it’s impossible to tr y and keep tr ...

  • SWR Sound 350x - page 8

    This r emains tr ue up to about the “2 o’clock” position. This position – a favorite for many users – brings out both the low end fundamentals and crisp highs and, at the same time, adds a little lower midrange to help cu t through the band. However, if you go fur ther clockwise and past the 2:00 position, selected mids will star t to dro ...

  • SWR Sound 350x - page 9

    long as your speaker cabinet can handle the peak levels. Adjust the controls slowly , and use com- mon sense. Midrange Contr ols Y our 350x comes equipped with two dif fer ent contr ols for setting the amount of midrange pr esent: one for boosting and cutting the level of midrange, and another for setting the specific midrange fr equency that will ...

  • SWR Sound 350x - page 10

    Activating or Defeating the Limiter Cir cuit Y ou may either activate or defeat the Limiter cir cuit via the Ef fects Blend contr o l, w hich doubles as an on/of f switch for the Limiter. The “In” position activates the Limiter Circuit, and is the default setting as shipped from the factor y . T o defeat the Limiter , simply pull “out” on t ...

  • SWR Sound 350x - page 11

    350x OWNER’S MANUAL • 9 Balanced Output jack is the same as when in the DIRECT position, with one impor tant exception: the SubW ave™ is pr esent. What’s the benefit of this setting? W e’ve found that most people who use ef fects pedals pr efer to use them in front of the amplifier . In other w o r ds, they r un their bass into the ef fec ...

  • SWR Sound 350x - page 12

    XLR Gr ound/Lift Switch Sometimes connecting to cer tain mixing boar ds or studio consoles with non-standar d XLR wiring can cause a gr ound loop. Y our 350x has a push-button switch for lifting the gr ound on the Balanced (XLR) Output. (It af fects no other outputs.) Pushing on the switch will change the mode of operation. When the switch is in th ...

  • SWR Sound 350x - page 13

    Ef fects Send This jack’s primar y function is to send a post-EQ-and-SubW ave™ signal to an exter nal ef fects device for use in the 350x Ef fects Loop. However , it can also be used as: 1. A line level output for use in conjunction with an additional (slave) power amp—such as SWR’s Power 750. 2. An unbalanced output suitable for r ecor din ...

  • SWR Sound 350x - page 14

    SPEAKER OUTPUT SECTION This section of the manual will deal with the pr oper connection of speaker cabinets to the power amplifier in the 350x. Some of this gr ound has alr eady been covered in the “Getting Star ted – Connecting Y our Speaker Cabinets” section in the beginning of the manual. This is meant to supplement that section and provid ...

  • SWR Sound 350x - page 15

    One 8 ohm enclosure + one 8 ohm enclosur e = 4 ohms total impedance One 4 ohm enclosure + one 4 ohm enclosur e = 2 ohms total impedance One 8 ohm enclosure + one 4 ohm enclosur e = 2.6 ohms total impedance Her e’s another for mula: T o figure out the total impedance of two or mor e cabinets of equal value hooked up in parallel, divide the impedan ...

  • SWR Sound 350x - page 16

    Only SPEAKER CABLE of 18 gauge or heavier (the heavier the cable, the lower the gauge) should be used to connect your 350x to your speaker system. Do not use shielded instr ument cable to connect your ampli - fier to your speaker enclosur e, as this can r esult in inter mittent power loss, cause your amp to oscillate and damage itself and/or your s ...

  • SWR Sound 350x - page 17

    Line Fuse (A/C or Mains Fuse) This fuse is pr ovided to pr otect the inter nal electr onics against power sur ges, etc. It also pr otects the unit against itself should one of the inter nal components fail. If this fuse should open, repl ace it with the same type of fuse and rating. Do not defeat the purpose of this featur e by using a higher rated ...

  • SWR Sound 350x - page 18

    A FEW WORDS CONCERNING HEAT One of the most asked questions about our amplifiers is why they tend to get war mer than other amps. The chassis of your amplifier can get quite war m during nor mal usage. This is especially tr ue if you are operating your 350x at a 2 or 2.6 ohm total impedance. This is because these low impedances ar e intr o- ducing ...

  • SWR Sound 350x - page 19

    Aura l Enhancer Frequency Lev el Treble Midrange 0 0 0 500 +15 -15 200 800 min max +15 -15 +15 -15 Aura l Enhancer Frequency Lev el Treble Midrange 0 0 0 500 +15 -15 200 800 min max +15 -15 +15 -15 Aura l Enhancer Frequency Lev el Treble Midrange 0 0 0 500 +15 -15 200 800 min max +15 -15 +15 -15 Aura l Enhancer Frequency Lev el Treble Midrange 0 0 ...

  • SWR Sound 350x - page 20

    350x LIMITED WARRANTY The 350x fr om SWR is war ranted to the original consumer pur chaser for TWO YEARS fr om the date of pur chase against defects in materials and workmanship, pr ovided that it is purchased from an Authorized SWR dealer. This war ranty applies only to pr oducts pur chased in the USA or Canada. This war ranty is VOID if the unit ...

Manufacturer SWR Sound Category Stereo Amplifier

Documents that we receive from a manufacturer of a SWR Sound 350x can be divided into several groups. They are, among others:
- SWR Sound technical drawings
- 350x manuals
- SWR Sound product data sheets
- information booklets
- or energy labels SWR Sound 350x
All of them are important, but the most important information from the point of view of use of the device are in the user manual SWR Sound 350x.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals SWR Sound 350x, service manual, brief instructions and user manuals SWR Sound 350x. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product SWR Sound 350x.

Similar manuals

A complete manual for the device SWR Sound 350x, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use SWR Sound 350x by users. Manuals are usually written by a technical writer, but in a language understandable to all users of SWR Sound 350x.

A complete SWR Sound manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual SWR Sound 350x - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the SWR Sound 350x, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the SWR Sound 350x, that we can find in the current document
3. Tips how to use the basic functions of the device SWR Sound 350x - which should help us in our first steps of using SWR Sound 350x
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with SWR Sound 350x
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of SWR Sound 350x in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning SWR Sound 350x?

Use the form below

If you did not solve your problem by using a manual SWR Sound 350x, ask a question using the form below. If a user had a similar problem with SWR Sound 350x it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)