English dropdown-ico

Manual Bunn IMIX-5

14 pages 1.2 mb
Download

Go to site of 14

Summary
  • Bunn IMIX-5 - page 1

    IMIX ® -3 IMIX ® -4 IMIX ® -5 INST ALLA TION & OPERA TING GUIDE BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 T o ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please vi ...

  • Bunn IMIX-5 - page 2

    2 37510 072513 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal ser vers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor . 2) All othe ...

  • Bunn IMIX-5 - page 3

    3 USER NOTICES The notices on this dispenser should be kept in good condition. Replace unreadable or damaged labels. 00831.0000 IMIX-5 (Self Serve) 28328.0010 37510 072513 RELEASE BUTT ON WHEN CUP IS 3/4 FULL H O T L I Q U I D PLACE CUP HERE PLACE CUP HERE PLACE CUP HERE PLACE CUP HERE IMIX-4 (Self Serve) 28328.0012 RELEASE BUTT ON WHEN CUP IS 3/4 ...

  • Bunn IMIX-5 - page 4

    4 INITIAL SET -UP 1. Apply the four non-skid pads from the parts box to the bottom of the legs. 2. Remove the drip tray assembly , drip tray bracket, and splash panel assembly from the parts box. 3. Place a set of key holes in the drip tray bracket over the lower two screws in the panel below the hopper access door; push down gently and tighten scr ...

  • Bunn IMIX-5 - page 5

    5 PLUMBING REQUIREMENTS This dispenser must be connected to a cold water system with operating pressure between 20 and 90 psi (138 to 620 kPa) from a 1⁄2” or larger supply line. A shut-off valve should be installed in the line before the dispenser . Install a regulator in the line when pressure is greater than 90 psi (690 kPa) to reduce it to 5 ...

  • Bunn IMIX-5 - page 6

    6 RINSE TIMER The dispenser is shipped from the factory with the rinse timer disabled. T o enable the rinse timer , refer to Programming the Dispenser and select yes in the “Rinse Alarm ?” screen; set timer to the desired time and exit the programming mode. When enabled, the rinse timer automatically keeps track of the time since the dispenser ...

  • Bunn IMIX-5 - page 7

    7 CLEANING The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all sur - faces on Bunn-O-Matic equipment. Do NOT clean this equipment with a water jet device. 37510 072513 1 x 24h 37254.0003A 02/13 © 2013 BUNN-O-MA TIC CORPORA TION NOTICE The cleaning instructions noted above are for non-dairy sug ...

  • Bunn IMIX-5 - page 8

    8 HOPPER DISPENSE RA TE OF PRODUCT The hopper dispense rates are preset at the factor y . With 22 tooth gear and auger wire, the preset dispense rate is approximately 3 to 5 grams per second. With 30 tooth gear and auger wire, the preset dispense rate is approximately 5 to 7 grams per second. The hopper dispense rates can be individually programmed ...

  • Bunn IMIX-5 - page 9

    9 Adjust tank temperature (190° F maximum) Adjust minimum tank ready temper - ature for lockout (185° maximum) Adjust hopper motor speed for station selected T ANK TEMP XXX° (-) EXIT (+) READY TEMP XXX° (-) EXIT (+) DRINK STRENGTH (-) XX (+) XX° CAL XX° (-) T ank T emp (+) 235 REFILL 155 (-) EXIT (+) CAL WA TER ? PRESS DISPENSE Calibrate temp ...

  • Bunn IMIX-5 - page 10

    10 A. Enter program mode and advance to next menu B. Increment display value positive C. Exit program mode D. Increment display value negative E. Return to previous menu and interrupt dispense PORTION CONTROL MODELS D igital B everag e C ontr ol D igital B everage C ontr ol ST OP PROGRAM HOME SCREEN The screen above will be shown when the dispenser ...

  • Bunn IMIX-5 - page 11

    11 PROGRAMMING CUP SIZES - Portion Control Models The cup size can be programmed in portion control models by “EXAMPLE” or “TIME”. Programming by EX- AMPLE is manually pressing desired dispense button, then releasing when the desired cup size is attained. The time required to fill the cup will be stored in the controller memory when moving ...

  • Bunn IMIX-5 - page 12

    12 DISABLE MESSAGES ? NO EXIT YES Press and release right switch (advance to next menu), “T ANK TEMP XXX°” appears on screen. PROGRAMMING THE DISPENSER (cont.) T ANK TEMP XXX° READY TEMP XXX° (-) EXIT (+) STRENGTH ADJ. ? (-) EXIT (+) EXIT YES ENTER P ASSWORD (-) XXXX (+) CALIBRA TION ? EXIT YES LOCKS/DISABLES ? EXIT YES AUDIBLE ALARM ? NO EX ...

  • Bunn IMIX-5 - page 13

    13 XX° CAL XX° (-) T ank T emp (+) PROGRAMMING THE DISPENSER (cont.) DRINK STRENGTH 1 (-) XX (+) PRESS DISPENSE TO CHECK T ASTE T ASTE 1 OK ? NO YES SET FLA VOR 1 BY T ASTE RECIPE ENTER RECIPE # #.# gm/fluid oz CHANGING V ALUES WILL EFFECT RPM ARE YOU SURE ? NO EXIT YES (B) Adjust hopper motor speed for station for station selected SELECT UNITS ...

  • Bunn IMIX-5 - page 14

    14 PROGRAMMING THE DISPENSER (cont.) LOW POWDER LOCK ? NO EXIT YES DISPENSE LOCKOUT NO EXIT YES RINSE ALARM ? NO EXIT YES HEAD 1 DISABLE ? NO EXIT YES SET P ASSWORD ? (-) XXXX (+) Returns to (G) (page 12) TEST SWITCHES ? Use Switch T o T est TEST HEA TER ? EXIT YES TEST REFILL ? EXIT YES TEST HOT WA TER ? EXIT YES TEST AUGERS ? DISPENSE TO TEST TES ...

Manufacturer Bunn Category Coffeemaker

Documents that we receive from a manufacturer of a Bunn IMIX-5 can be divided into several groups. They are, among others:
- Bunn technical drawings
- IMIX-5 manuals
- Bunn product data sheets
- information booklets
- or energy labels Bunn IMIX-5
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bunn IMIX-5.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bunn IMIX-5, service manual, brief instructions and user manuals Bunn IMIX-5. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bunn IMIX-5.

Similar manuals

A complete manual for the device Bunn IMIX-5, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bunn IMIX-5 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bunn IMIX-5.

A complete Bunn manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bunn IMIX-5 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bunn IMIX-5, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bunn IMIX-5, that we can find in the current document
3. Tips how to use the basic functions of the device Bunn IMIX-5 - which should help us in our first steps of using Bunn IMIX-5
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bunn IMIX-5
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bunn IMIX-5 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bunn IMIX-5?

Use the form below

If you did not solve your problem by using a manual Bunn IMIX-5, ask a question using the form below. If a user had a similar problem with Bunn IMIX-5 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)