-
Electrolux CHDE 3160 - page 1
DE 3160 CHDE 3160 Cooker Hood Operating and Installation Instructions ...
-
Electrolux CHDE 3160 - page 2
55 Contents Safety warnings 5 6 For the user 5 6 For the installer 5 6 Description of the Appliance 5 8 Extractor version 5 8 Filter V ersion 5 9 Control Panel 6 0 Maintenance and care 6 1 Metal grease filter 6 1 Open the metal grease filter 6 1 Charcoal filter 6 2 Changing the light bulb 6 3 What to do if 6 4 Special accessories 6 5 T echnical ass ...
-
Electrolux CHDE 3160 - page 3
56 Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep fry ...
-
Electrolux CHDE 3160 - page 4
57 • National and regional building regulations impose a number of restrictions on using hoods and fuel-burning appliances connected to a chimney , such as coal or oil room-heaters and gas fires, in the same room. • Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is vent ...
-
Electrolux CHDE 3160 - page 5
58 A B Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter . • Y ou will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version • In this version fumes are extracted to the ...
-
Electrolux CHDE 3160 - page 6
59 E E E Filter V ersion • The air is filtered through a charcoal filter and returned to the kitchen. • Y ou will need an original AEG charcoal filter for the recirculation function. (Available from your local AEG Service Force Centre). • Remove the grease filters, first pull the handles upwards, then extract the filter outwards. Fig. 3 . • ...
-
Electrolux CHDE 3160 - page 7
60 Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappea ...
-
Electrolux CHDE 3160 - page 8
61 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. • Never insert pointed objects in the motor ’ s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. • Only ever clean t ...
-
Electrolux CHDE 3160 - page 9
62 Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • T o do this you will need an original AEG charcoal filter (available from your local Service Force Centre). • The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 12 months und ...
-
Electrolux CHDE 3160 - page 10
63 W arning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe th ...
-
Electrolux CHDE 3160 - page 11
64 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply . Check that a fan speed has been selected The cooker hood is not working Check that: ef fectively .. The fan speed is set high enough for the ...
-
Electrolux CHDE 3160 - page 12
65 Special accessories* Charcoal filter KLF60/80 E-Nr . 610 899 421 * Not available in UK, please contact your local Service Force Centre. T echnical assistance service (not for UK) Y ou are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fa ...
-
Electrolux CHDE 3160 - page 13
66 T echnical Specifications Model: DE 3160 - CHDE 3160 Dimensions: (in cm): Height 40 Width 59 ,9 Depht 27 Maximum absorbed power: 200 W Motor absorption: 120 W Lighting: 2 x40 W Length of the cable: 150 cm Mounting accessories included 1 Flange Ø 100 mm 1 Flange Ø 120 mm 2 Hooks 2 rails 1 Deflector 2 W ashers 4 wood-screws 5 x 45 mm 4 W all plu ...
-
Electrolux CHDE 3160 - page 14
67 Electrical connection (NOT FOR UK) Safety warnings for the electrician Before connecting the appliance to the power supply , check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary t ...
-
Electrolux CHDE 3160 - page 15
68 Installing the hood between cupboards with hanging rails • Remove the grease filters. Fig. 6 . • T ake off the visor G. Fig. 13 . • Mount the two hanging rails directly underneath the edge of the cupboard using three screws 4,5 x 16 mm in each rail. Distance from first hole to front edge of the cupboards sides must be 153 mm. Fig. 8 . • ...
-
Electrolux CHDE 3160 - page 16
69 Installing the hood to the wall It is possible to fix the hood in position, if necessary , by only attaching it to the rear wall. Proceed as follows: • Drill four Ø 8mm holes on the wall as indicated. Fig. 10 . • Insert the four wall plugs supplied into these holes. • Screw the two mountings hooks P into the top two wall plugs. Fig. 1 1 . ...
-
Electrolux CHDE 3160 - page 17
70 • Fix the base spacer M to the wall with the two screws R 5x45 provided using either the long or the short arm, depending on the depht of the side cupboards. Do not tighten the screws fully . Fig. 1 1 . • Fix the hood to the wall by means of the two hooks P previously mounted, but first move the upper brackets S so that the front panel of th ...
-
Electrolux CHDE 3160 - page 18
71 • Draw a line with a pencil on the middle of the internal side of the furnituture door . Fig. 14. • Fit the visor upon the internal side of the furniture door so that the line previously marked on it, is visible through the two triangles holes located on the mid upper and lower side of the visor , having care to respect the distance from the ...
-
Electrolux CHDE 3160 - page 19
AEG Hausger ä te GmbH Postfach 1036 D-90327 N ü rnberg http:// www .aeg.hausgeraete.de http ://www .aeg.co.uk © Copyright by AEG LI1SCB Ed. 07/02 ...
Do you have a question concerning Electrolux CHDE 3160?
Use the form below
If you did not solve your problem by using a manual Electrolux CHDE 3160, ask a question using the form below. If a user had a similar problem with Electrolux CHDE 3160 it is likely that he will want to share the way to solve it.