English dropdown-ico

Manual AstroStart VSS-113

18 pages 0.34 mb
Download

Go to site of 18

Summary
  • AstroStart VSS-113 - page 1

    –– VSS-113 S ECURITY SYSTEM FEATURING K EYLESS ENTR Y O WNER ’ S M ANUAL ® 2006 A STROFLEX E LECTRONICS ...

  • AstroStart VSS-113 - page 2

    © 2006 Astroflex Electronics – All rights reserved Table of contents What is included ...................................................................................................................................................................... 1 Important information ...................................................................... ...

  • AstroStart VSS-113 - page 3

    What is included  One control module  A pair of three-button transmitters  A Stinger® Doubleguard® dual-stage shoc k sensor (on-board the control module)  The Revenger® Soft Chirp® six-tone programmable siren  Blue status LED indicator light  A push-button Valet button  Failsafe® Starter Kill ready circuitry (may require e ...

  • AstroStart VSS-113 - page 4

    Transmitter functions The system uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any transmitter button to any system function. The transmitter initially comes programmed with Standard Configuration, but may also be customized by an authorized dealer. The buttons in all of the instructions in t ...

  • AstroStart VSS-113 - page 5

    P ASSIVE ARMING The system also can be programmed to arm itself automatically (called passive arming). If the system is programmed for passive arming, it will auto matically arm 30 seco nds after the ignition is turned off and the system “sees” you leave the vehicle by opening and closing a door. Whenever the system is in its 30-second passive- ...

  • AstroStart VSS-113 - page 6

     Press a fourth time within five seconds: The sir en chirps four times followed by a long chirp. Zones 2 and 4 are now bypassed.  Press a fifth time within five seconds: The siren chirps five times followed by a long chirp. All input zones, except the ignition, are now bypassed.  Continued pressing of will begin the Multi-Level Security Ar ...

  • AstroStart VSS-113 - page 7

    D ISARMING WITHOUT A TRANSMITTER This feature allows you to disarm the security syst em without the remote tr ansmitter should it be lost or damaged. In order to disarm the system without a remote transmi tter, you must have the vehicle’s ignition key and know where the Valet button is located. Be sure to check with the installer for the location ...

  • AstroStart VSS-113 - page 8

    security system will not arm, even with the remo te transmitter, but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit Valet ® Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet ® switch within 10 seconds. To enter or exit Valet Mode using the transmi ...

  • AstroStart VSS-113 - page 9

    © 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 7 Doors and ignition are covered by NPC ® differently; if the alarm is tr iggered by an open door or ignition on cycle for three full cycles, the doors will be bypassed until the trigger ceases. Note : Arming and disarming the system does not reset this function! The only ways to reset a byp ...

  • AstroStart VSS-113 - page 10

    © 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 8 S YSTEM STATUS CHIRPS The siren will chirp when arming/disarming the syst em. The pattern of chirps will audibly report the system’s status as described below. Action Number of Chirps Description Arm 1 System armed Arm 1 (3 second delay), 1 System armed with zone active Disarm 2 System di ...

  • AstroStart VSS-113 - page 11

    Code hopping Both the receiver and transmitters use mathematic al formulas called algorithms to change their codes each time the transmitter is used. This te chnology has been developed to increase the security of the unit. The control unit knows what the next codes sh ould be. This helps to keep the transmitter “in sync” with the control unit ...

  • AstroStart VSS-113 - page 12

    © 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 10 Power saver mode Your system will automatically enter Power Save r Mode while armed or in Valet Mode, after a long period of time in which no operation has been performed. This lowers the current draw to the vehicle’s battery. Power Saver Mode ta kes over under the following conditions: ...

  • AstroStart VSS-113 - page 13

    © 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 11 been left ajar when leaving the vehicle. Fo rced passive arming ensures that the security system will be armed in every situation. Note : When the system passively arms after on e hour, the entry point that has been left open, and anything connected to the same zone, is bypassed and cannot ...

  • AstroStart VSS-113 - page 14

    Installation options The system has many options that may require ex tra parts and labor. Some of the possibilities are listed here.  Progressive unlocking : In most cars with electric powe r door locks, the system can be configured so that when the system is disarmed , only the driver’s door unlocks. A seco nd press of the button unlocks the ...

  • AstroStart VSS-113 - page 15

    vehicle, the system will trigger as the door is open ed and closed. This is how the system works to combat intersection carjacking. To protect against parking lot carjacking, arm the VRS ® before leaving the vehicle. The system will now trigger au tomatically the next time you or anyone drives the vehicle. This helps to protect the vehicle if some ...

  • AstroStart VSS-113 - page 16

    If the system has entered the triggered sequence (siren has begun chirping), pressing the disarm button of the transmitter will not disarm VRS ® . To disarm the VRS ® during a VRS ® trigger sequence: 1. Turn the ignition on. 2. Press the Valet switch the pre-programmed number of times to disarm the VRS ® system. Note: If the VRS® system has be ...

  • AstroStart VSS-113 - page 17

    © 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 15 Trigger or Triggered Sequence : This is what happens when the alarm “goes off” or “trips”. The triggered response of your system consists of the siren sounding and parking light flashing for the programmed duration. Valet Switch : A small push-button switch mounted some where insid ...

  • AstroStart VSS-113 - page 18

    REFERENCE GUIDE T O ARM AND LOCK (1) USING YOUR R EMOTE You can lock the doors, and arm the system by pressing the button on your transmitter for one second. When the system arms, you will hear a short siren s ound, or chirp, and the parking lights will fla sh once. If the vehicle’s power door locks have been co nnect ed to the system, the doors ...

Manufacturer AstroStart Category Automobile Alarm

Documents that we receive from a manufacturer of a AstroStart VSS-113 can be divided into several groups. They are, among others:
- AstroStart technical drawings
- VSS-113 manuals
- AstroStart product data sheets
- information booklets
- or energy labels AstroStart VSS-113
All of them are important, but the most important information from the point of view of use of the device are in the user manual AstroStart VSS-113.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals AstroStart VSS-113, service manual, brief instructions and user manuals AstroStart VSS-113. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product AstroStart VSS-113.

Similar manuals

A complete manual for the device AstroStart VSS-113, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use AstroStart VSS-113 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of AstroStart VSS-113.

A complete AstroStart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual AstroStart VSS-113 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the AstroStart VSS-113, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the AstroStart VSS-113, that we can find in the current document
3. Tips how to use the basic functions of the device AstroStart VSS-113 - which should help us in our first steps of using AstroStart VSS-113
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with AstroStart VSS-113
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of AstroStart VSS-113 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning AstroStart VSS-113?

Use the form below

If you did not solve your problem by using a manual AstroStart VSS-113, ask a question using the form below. If a user had a similar problem with AstroStart VSS-113 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Beatriz Páramo

Buenos días necesitaría descargar el manual, pero en castellano