-
Chauvet DERBY X - page 1
3000 N 29 th Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084 – ( 954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com Derby X ™ Snapshot OK on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave Autoswitching Transformer Replaceable Fuse User Serviceable Duty Cycle USER MANUAL ...
-
Chauvet DERBY X - page 2
T ABLE OF C ONTENTS 1. Before You Begin ........................................................................................................ 3 What is included ................................................................................................................ 3 Unpacking Instructions ................................................ ...
-
Chauvet DERBY X - page 3
1. B EFORE Y OU B EGIN What is included ¾ 1 x Derby X™ ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fixture, ca refully unpack the carton, check the contents to ensure that all parts are present, and h ave been received in goo d condition. Notify the shipper immediately and retain packing mate ...
-
Chauvet DERBY X - page 4
Safety Instructions Please read these instructions carefully, w h ich includes important information about the installation, usag e and maintenance of this product. • Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also re ceive thi s instruction bo oklet. • Always make sure that you ...
-
Chauvet DERBY X - page 5
2. I NTRODUCTION Features • 8-channel DMX-512 LE D derby effect • Blackout/static/strobe • Individual cont rol of red, green an d blue LEDs within each clu ster (6 total) • Built-in autom ated pro grams via DMX • Built-in sound activated programs via master/slave or DMX Additional Features • Mount multiple units togeth er with adjustabl ...
-
Chauvet DERBY X - page 6
3. S ETUP Fuse Replacement Disconnect the power cord before replacin g a fuse an d alwa y s re p lace with the same t yp e fuse. The fuse is located inside this compartment. Remove using a flat head screwdriver. With a flat head screwdriver we dge the fuse holder out of its housing. Remove the damaged fuse from its holder and replace with exact sam ...
-
Chauvet DERBY X - page 7
CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR c onn ector on the other end. CO MM O N DMX + DMX - INPUT OUTPUT 1 3 2 1 Termination reduces signal er rors. To avoid signal transmission problems and interference, it is al ways advisable to connect a D MX signal terminator. 1 3 2 Resistance 120 ohm 1/4w between pi ...
-
Chauvet DERBY X - page 8
Master/Slave Fixture Linking 1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture. 2. Connect the end of the cable coming from the first fixture which will have a ( f emale) 3 pin connector to the input connector of t he next fixture co ns isting of a (male) 3 pin connector. Then, p ...
-
Chauvet DERBY X - page 9
S t acking The Derby X™ may be “stacked” by using m ultiple fixtures and the optional bracket (XBRACKET). This bracket may be ordered from CHAUVET. The bracket kit will ship with 2pcs bracket (as sh own below) and will include 4 screw s for attaching it to the bottom of the fixture. • Note: When you are installing this bracket, you must use ...
-
Chauvet DERBY X - page 10
4. O PERATING I NSTRUCTIONS Operation Stand-Alone Mode (Sound-Active): This mode allows a single uni t to run to t he beat of the music, or the unit will auto ch ange in Auto Mode. 1) Set all di ps witches position to the Off position. Mode Dipswitches Sound Active 10 = Off 2) T he unit will react to the low frequencies of music via the internal mi ...
-
Chauvet DERBY X - page 11
DMX Channel Values Channel Value Functio n 1 000 Ù 010 011 Ù 045 046 Ù 080 081 Ù 115 116 Ù 150 151 Ù 185 186 Ù 220 221 Ù 255 Cluster Control No Function Red Green Blue Red/Green Red/Blue Green/Blue Red/Green/Blue 2 3 4 5 6 7 000 Ù 010 011 Ù 255 Strobe No Function Strobe 0%~100% 8 000 Ù 010 011 Ù 024 025 Ù 038 039 Ù 052 053 Ù 066 067 ...
-
Chauvet DERBY X - page 12
SETTING THE STARTING ADDRESS This DMX mode enables the use of a un iversal DMX contr oller device. Each fixture requires a "start address" from 1 to 512. A fixture requiring o ne or mo re channels for control begins to read the data on the channel indicated by the start address . For example, a fixture that uses 6 DMX channe ls and was ad ...
-
Chauvet DERBY X - page 13
DMX QUICK REFERENCE CHART DMX Address Quick Reference Chart Dip Switch Position DMX DIP SWITCH SET #9 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 0=OFF #8 0 0 0 0 1 1 1 1 0 0 0 0 1 1 1 1 1=ON #7 0 0 1 1 0 0 1 1 0 0 1 1 0 0 1 1 X=OFF or ON #6 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 #1 #2 #3 #4 #5 0 0 0 0 0 32 64 96 128 160 192 224 256 288 320 352 384 416 448 480 1 0 0 ...
-
Chauvet DERBY X - page 14
Blow-out Diagram 3 6 Description Part Number 1 Master PCB P172 ‐ DERBYX 2 Electronic Transformer P140 ‐ DERBYX 3 Case cover P111 ‐ DERBYX 4 LED PCB P222 ‐ DERBYX 5 Front Lens P150 ‐ DERBYX 6 Bracket knob P111 ‐ DERBYX 7 Power ...
-
Chauvet DERBY X - page 15
General Troubleshooting Symptom(s) Possible Solution(s) 1 or more LED’s are not illuminating Clean the fixture regularly to avoid any such failure. This fixture is convection cooled, which m ean s that if the surface is kept clean and free of debris, then proper cooling will be allo wed to o ccur An LED may have failed, resulting in an open circu ...
-
Chauvet DERBY X - page 16
Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S. A.) Support (Email): tech@chauvetlighting.c om Telephone: (954) 929-11 15 - (Press 4) Fax: (954) 929-5560 - (Attention: Service) Website: http://www.chauvetlighting.com 5. A PPENDIX DMX Primer There are 512 channels i n a DMX-512 connection. Ch annels may be assigned ...
-
Chauvet DERBY X - page 17
General Maintenance To maintain optimum performance and mi nimize wear fixtures should be clea ned frequently. Usage and environment are cont ri buting factors in determining frequenc y. As a general rule, fixtures s hou ld be cleaned at least t wice a month. Dust build up reduces light output performance and can caus e over heating. T his can le a ...
-
Chauvet DERBY X - page 18
Notes ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ ____________________________________________________ ...
-
Chauvet DERBY X - page 19
Technical Specifications WEIGHT & DIMENSIONS Length..................................................................................................... 11.9 in (302 mm) Width ......................................................................................................... 15 in (382 mm) Height .......................................... ...
-
Chauvet DERBY X - page 20
3000 N 29 Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com th Derby X™ User Manual 20 7/14/2008 1:27 PM ...
Do you have a question concerning Chauvet DERBY X?
Use the form below
If you did not solve your problem by using a manual Chauvet DERBY X, ask a question using the form below. If a user had a similar problem with Chauvet DERBY X it is likely that he will want to share the way to solve it.