English dropdown-ico

Manual Smeg P705VTBE

14 pages 1.62 mb
Download

Go to site of 14

Summary
  • Smeg P705VTBE - page 1

    Contents 18 1. Instructions for safe and proper use ____________________ 19 2. Positioning of hob __________________________________ 20 2.1 Attachment to s upport structure ________________________________________20 3. Electrical co nnection _______________________________ 22 4. Gas connect ion ___________________________________ 23 4.1 Connection ...

  • Smeg P705VTBE - page 2

    Instructions for safe and proper use 19 1. Instructions f or safe and pr oper use THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN IT S ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOL E WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USI NG THE COOKING HOB. ALSO K ...

  • Smeg P705VTBE - page 3

    Instructions for the installer 20 2. P ositioning of hob The following op eration requires building and/or carpentry work so must be carri ed out by a competent tradesman. Installation can be carried out on various materials such as ma sonry, metal, solid wood or plastic laminated wood as lon g as they are heat resistant (T 90°C). 2.1 Attachment t ...

  • Smeg P705VTBE - page 4

    Instructions for the installer 21 Before mounting the device to the unit, lay the provided adhe sive sponge onto the glass surf ace to separate it from the unit. After fixing the provided adhesive spon ge (B) to the glass, mount the device to the unit with the mounting brackets (A) provided with the device itself, as shown in the figure. When fixin ...

  • Smeg P705VTBE - page 5

    Instructions for the installer 22 3. Electrical connection Make sure that the voltag e and capacity of the power line co nform to the data shown on the plate located under the casing. Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same type and conform to the current electri cal syst ...

  • Smeg P705VTBE - page 6

    Instructions for the installer 23 4. Gas connection If the appliance is installed on an oven, the gas pi pe must not be passed along the back of the oven, as this may cause overheating. Connection to the gas mains may be m ade with a rigid copper pipe or with a flexible pipe and conforming to the provisions d efined by standard regulations in force ...

  • Smeg P705VTBE - page 7

    Instructions for the installer 24 4.1 Connection to LPG Use a pressure regulator and m ake the connection to the tank according to the provisions of standard s regulations in force. Make sure that feed pressure conforms to the levels shown in the table in Section “5.2 Regulation for LPG ”. 4.2 V entilation of rooms The hob may be installed only ...

  • Smeg P705VTBE - page 8

    Instructions for the installer 25 5. Adapting to different types of gas Before performing any cleaning or mainte nance work, detach the hob from the electrical socket. The hob has been inspect ed for G20 (2H) natural gas at a pressure of 20 mbar. For functioning with other t ypes of gas t he nozzles m ust be replaced and the primary air adjusted. T ...

  • Smeg P705VTBE - page 9

    Instructions for the installer 26 5.2 Regulation fo r LPG Loosen screw C and push air re gulator D to the bottom. With a 7 mm wrench, remove nozzle E and replace it with the proper one (follow the instructions on the referen ce tables for the type of gas to be used). The torque wren ch setting of the nozzle must not exceed 3 Nm . Regulate the air b ...

  • Smeg P705VTBE - page 10

    Instructions for the installer 27 5.4 Regulation of primary air Referred to distance “ X ” in mm. BURNER G20 20 mbar G30/G31 28/37 mbar Auxiliary 4 open Semi rapid 3 2 Medium rapid 2 2.5 Large rapid 2 2.5 A 2 14 UR B 2 14 To identify the burners on your ho b, refer to the drawi ngs in point “5 .8 Arrangement of burners on ho b “ If after ai ...

  • Smeg P705VTBE - page 11

    Instructions for the installer 28 5.7 Regulation of minim um for LPG To regulate the minimum for LPG, completely tighten (clockwi se) the screw inside or next to the gas tap pin (depending on the model). The diameters of the by-passes for ea ch burner are given in table “5.2 Regulati on for LPG ”. After regulation for a gas other than that insp ...

  • Smeg P705VTBE - page 12

    Instructions for the user 29 6. Description of contr ols 6.1 Fr ont control panel All of the commands and controls for the hob are fou nd on the front panel. MODEL 60 CONTROL PANEL MODEL 70 CONTROL PANEL MODEL 100 CONTROL P ANEL DESCRIPTION OF THE KNOB The flame is lit by pressing the knob and simultaneo usly turning it anticlockwise to the minimum ...

  • Smeg P705VTBE - page 13

    Instructions for the user 30 7. Using the hob Check that the flame cap c rowns, the burner caps and grids are correctly assembled. Pins A of the flame cap crowns must be inserted in housings B of the burner rings, and pins C on the grids must be blocked in their respective housings on the hob. 7.1 Burner lighting with safety de vice Each knob shows ...

  • Smeg P705VTBE - page 14

    Instructions for the user 31 8. Cleaning and maintenance Never use a steam jet to clean the appliance. Before any inter vention, disconnect the power supply of the d evice. 8.1 Cleaning stainless steel To keep the hob in good condition, you should clean it after every use (after it has cooled). 8.1.1 Regular daily cleaning of the hob To clean and p ...

Manufacturer Smeg Category Cooktop

Documents that we receive from a manufacturer of a Smeg P705VTBE can be divided into several groups. They are, among others:
- Smeg technical drawings
- P705VTBE manuals
- Smeg product data sheets
- information booklets
- or energy labels Smeg P705VTBE
All of them are important, but the most important information from the point of view of use of the device are in the user manual Smeg P705VTBE.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Smeg P705VTBE, service manual, brief instructions and user manuals Smeg P705VTBE. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Smeg P705VTBE.

Similar manuals

A complete manual for the device Smeg P705VTBE, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Smeg P705VTBE by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Smeg P705VTBE.

A complete Smeg manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Smeg P705VTBE - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Smeg P705VTBE, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Smeg P705VTBE, that we can find in the current document
3. Tips how to use the basic functions of the device Smeg P705VTBE - which should help us in our first steps of using Smeg P705VTBE
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Smeg P705VTBE
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Smeg P705VTBE in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Smeg P705VTBE?

Use the form below

If you did not solve your problem by using a manual Smeg P705VTBE, ask a question using the form below. If a user had a similar problem with Smeg P705VTBE it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)