English dropdown-ico

Manual Hoshizaki F-330BAH(-C)

17 pages 0.84 mb
Download

Go to site of 17

Summary
  • Hoshizaki F-330BAH(-C) - page 1

    ® Hoshizaki “A Superior Degree of Reliability” www .hoshizaki.com Model F-330BAH(-C) Self-Contained Flaker Hoshizaki America, Inc. Issued: 5-4-2007 Revised: 9-5-2007 I N S T R U C T I O N M A N U A L ...

  • Hoshizaki F-330BAH(-C) - page 2

     IMPORTANT Only qualied service technicians should attempt to install, service, or maintain this icemaker. No installation, service, or maintenance should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/manager should not proceed to operate the icemaker until the installer has instructed the ...

  • Hoshizaki F-330BAH(-C) - page 3

    3 CONTENTS I. Specications ..................................................................................................................... 4 A. Nameplate Rating ......................................................................................................... 4 B. Dimensions/Connections .............................................. ...

  • Hoshizaki F-330BAH(-C) - page 4

    4 I. Specications A. Nameplate Rating 1. F-330BAH, F-330BAH-C See the nameplate for electrical and refrigeration specications. This nameplate is located on the rear panel. We reserve the right to make changes in specications and design without prior notice. HOSHIZAKI ICE MAKER MOTOR- COMPRESSOR THERM A LLY PRO TECT ED, NOT INTENDED F OR OU ...

  • Hoshizaki F-330BAH(-C) - page 5

    5 B. Dimensions/Connections 1. F-330BAH, F-330BAH-C Unit = inches (mm) ...

  • Hoshizaki F-330BAH(-C) - page 6

    6 II. Installation and Operating Instructions A. Checks Before Installation IMPORTANT 1. Install in accordance with all applicable national, state, and local regulations. . Remove shipping carton, tape, and packing. If any are left in the icemaker, it will not work properly. 3. Ensure all components, fasteners, and thumbscrews are securely in pl ...

  • Hoshizaki F-330BAH(-C) - page 7

    7 C. Location CAUTION This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F (+7°C to +38°C); Normal operating water temperature should be within +45°F to +90°F (+7°C to +3°C). Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affe ...

  • Hoshizaki F-330BAH(-C) - page 8

    8 • Drain line should not be piped directly to the sewer system. An air gap of a minimum of  vertical inches (5 cm) should be between the end of the drain pipe from the unit and the oor drain. • This icemaker must be installed in accordance with applicable national, state, and local regulations. • A plumbing permit and services of a lic ...

  • Hoshizaki F-330BAH(-C) - page 9

    9 G. Final Checklist 1) Is the icemaker level? ) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and the water temperature within +45°F to +90°F (+7°C to +3°C) all year around? 3) Is there at least 4" (61 cm) clearance at top for maintenance or service? 4) Have the shipping car ...

  • Hoshizaki F-330BAH(-C) - page 10

    10 H. Startup CAUTION 1. All parts are factory-adjusted. Improper adjustments may result in failure. . If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor. 1) Clean the storage bin. ) Open the water supply line shut-off valve. 3) Make sure the power switch on the control bo ...

  • Hoshizaki F-330BAH(-C) - page 11

    11 III. Cleaning and Maintenance A. Cleaning and Sanitizing Instructions IMPORTANT Ensure all components, fasteners, and thumbscrews are securely in place after any maintenance or cleaning is done to the equipment. WARNING 1. HOSHIZAKI recommends cleaning this unit at least twice a year. More frequent cleaning, however, may be required in some exis ...

  • Hoshizaki F-330BAH(-C) - page 12

    1 6) Lift up the top insulation and unsnap the bin control assembly. Lift the assembly up through the insulation and set it aside. See Fig. 4. 7) Remove the top insulation. 8) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B). See Fig. 5. 9) Remove the thumbscrews attaching spout (A) and safety bracket (A) to the evapo ...

  • Hoshizaki F-330BAH(-C) - page 13

    13 19) When the gear motor starts, remove the front panel and move the ush switch to the "FLUSH" position to drain out the water from the icemaker. 0) After the water has drained, move the power switch to the "OFF" position and unplug the unit. Note: If you do not sanitize the icemaker, leave the unit plugged in with the p ...

  • Hoshizaki F-330BAH(-C) - page 14

    14 4) Remove the top panel. 5) Remove the bin control assembly from the top insulation and set it aside. Remove the top insulation. 6) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B). 7) Remove the thumbscrews attaching spout (A) and safety bracket (A) to the evaporator assembly, then remove spout (A) and safety bracket ...

  • Hoshizaki F-330BAH(-C) - page 15

    15 B. Maintenance IMPORTANT 1. This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker. . To achieve optimum icemaker performance, the following parts need periodic inspection and maintenance: Extruding Head and Upper Bearing Housing and Lower Bearing Evaporator Cylinder Auger Gear ...

  • Hoshizaki F-330BAH(-C) - page 16

    16 C. Preparing the Icemaker for Long Storage CAUTION When the icemaker is not used for two or three days under normal conditions, it is sufcient to only move the power switch to the "OFF" position. When storing the icemaker for extended time or in sub-freezing temperatures, turn the water off and drain out all water from the water lin ...

  • Hoshizaki F-330BAH(-C) - page 17

    17 HOSHIZAKI AMERICA, INC. 618 Hwy . 74 S., Peachtree City , GA 30269 USA TEL (770) 487-2331 F AX (770) 487-3360 www .hoshizaki.com 91A2SA10B ...

Manufacturer Hoshizaki Category Ice Maker

Documents that we receive from a manufacturer of a Hoshizaki F-330BAH(-C) can be divided into several groups. They are, among others:
- Hoshizaki technical drawings
- F-330BAH(-C) manuals
- Hoshizaki product data sheets
- information booklets
- or energy labels Hoshizaki F-330BAH(-C)
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hoshizaki F-330BAH(-C).

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hoshizaki F-330BAH(-C), service manual, brief instructions and user manuals Hoshizaki F-330BAH(-C). Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hoshizaki F-330BAH(-C).

Similar manuals

A complete manual for the device Hoshizaki F-330BAH(-C), how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hoshizaki F-330BAH(-C) by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hoshizaki F-330BAH(-C).

A complete Hoshizaki manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hoshizaki F-330BAH(-C) - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hoshizaki F-330BAH(-C), FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hoshizaki F-330BAH(-C), that we can find in the current document
3. Tips how to use the basic functions of the device Hoshizaki F-330BAH(-C) - which should help us in our first steps of using Hoshizaki F-330BAH(-C)
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hoshizaki F-330BAH(-C)
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hoshizaki F-330BAH(-C) in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hoshizaki F-330BAH(-C)?

Use the form below

If you did not solve your problem by using a manual Hoshizaki F-330BAH(-C), ask a question using the form below. If a user had a similar problem with Hoshizaki F-330BAH(-C) it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)