English dropdown-ico

Manual Chauvet Vue II

16 pages 0.5 mb
Download

Go to site of 16

Summary
  • Chauvet Vue II - page 1

    Chauvet, 3000 N 2 9 th Ct, Hollywood, FL 3 3020 U.S.A. (800) 762-1084 – (954 ) 929-1115 FAX (954) 929-5560 www.chauvetlightin g.com V ue™ II Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle USER MANUAL ...

  • Chauvet Vue II - page 2

    T ABLE OF C ONTENTS 1. BEFORE YOU BEGIN ............................................................................................................................... .3 W HAT IS INCLUDED ............................................................................................................................... .......... 3 U NPACKING I NSTRUCT ...

  • Chauvet Vue II - page 3

    1. B EFORE Y OU B EGIN What is included ¾ 1 x Vue™ II ¾ Power Cord ¾ W arranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Noti fy the shipper immediately and retain packing materi ...

  • Chauvet Vue II - page 4

    Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. • Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that the y also receive this instruction booklet. • Always make sure that you are c ...

  • Chauvet Vue II - page 5

    2. I NTRODUCTION Features • 6-channel DMX-512 LED moon flower • Blackout/static/dimmer/strobe • Individual control of red, green and blue LEDs • Built-in automated programs via master/slave or DMX • Built-in sound activated programs via master/slave or DMX Additional Features • Creates firework -like projections • Additional power out ...

  • Chauvet Vue II - page 6

    Product Overview Tilt Adjustment Knob Hanging Bracket Power LED Microphone Signal/Sound Indicator LED Power Output Connector Dipswitches DMX Output Connector DMX Input Connector Sound Sensitiv ity Knob AC Power Input & Fuse Vue™ II User Manual 6 2007-05-10/13 :15 ...

  • Chauvet Vue II - page 7

    3. S ETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside this compartment. Remove using a flat head screwdriver. With a flat head screwdriver wedge the fuse holder out of its h ousing. Remove the damaged fuse from its holder and replace with exact same type f ...

  • Chauvet Vue II - page 8

    CABLE CONNECTORS This drawing prov ides a general illustration of the DMX Input/Output panel of a lighting fixture. U X Controller niversal DM Continue t he link Cabling must have a male XLR connector on one end and a female XLR connector on the othe r end. can cause a ground loop, and your fixt ure may perform erratically. Test cables with an ohm ...

  • Chauvet Vue II - page 9

    Often, the se tup for Master-S lave and Standalone op eration requires at the first f ixture i n t he chain be itialize d for this pur pose via ei ther ttings in the co ntrol panel or DIP- th in s e switches. Secondarily, the f ixture s that follow may also requir e a slave setting. Please consult the “Operating Instruct ions” sect io n in this ...

  • Chauvet Vue II - page 10

    4. O PERATING I NSTRUCTIONS Operation Stand-Alone Mode (Sound-Active, Au to Mode, Strobe Mode, All On): This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mode. 1) Set dipswitches position to Sound-Active or Auto Mode. Mode Dipswitches Sound-Active 1-8: Off, 9: On, 10: Off Auto Mode 1-4: Effect spee ...

  • Chauvet Vue II - page 11

    DMX Mode This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with DMX, please read the DMX Primer on page 15. 1) Set dipswitches 1-9 to the desired DMX addr ess. For help setting the address, see the “SETTING THE STARTING ADD RESS” section on the next page. DMX Channel Values C HANNEL V ALU E F UNCT ...

  • Chauvet Vue II - page 12

    SETTING THE STARTING ADDRESS This DMX mode enables the use of a uni versal DMX controller device. Each fixture requires a "sta rt address" from 1 to 512. A fixture requiring one or mo re chan nels for control begins to read the data on the channel indicated by the start address. For example, a fixtur e that uses 6 D MX channels and was ad ...

  • Chauvet Vue II - page 13

    DMX QUICK R EFERENCE CHART DMX Address Quick Reference Chart Dip Switch Position DMX DIP SWITCH SET #9 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 0=OFF #8 0 0 0 0 1 1 1 1 0 0 0 0 1 1 1 1 1=ON #7 0 0 1 1 0 0 1 1 0 0 1 1 0 0 1 1 X=OFF or ON #6 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 #1 #2 #3 #4 #5 0 0 0 0 0 32 64 96 128 160 192 224 256 288 320 352 384 416 448 480 1 0 0 ...

  • Chauvet Vue II - page 14

    General Troubleshooting Applies to Symptom Solution(s) Light s Foggers & Snow Controllers Dimmers & Chaser Auto shut off Check f an thermal switch reset 9 Beam is very dim or not bright Clean optical system or replace lamp Check 220/110v switch for proper setting 9 Breaker/Fuse keeps blowing Check total load placed on device 9 Chase is too ...

  • Chauvet Vue II - page 15

    Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A. ) Support (Email): tech@chauvetlighting.com Telephone: (954) 929-1115 - (Pre ss 4) Fax: (954) 929-5560 - (Att ention: Service) Website: http://www.chauvetlighting.com 5. A PPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned i ...

  • Chauvet Vue II - page 16

    Returns Proced ure Returned merchandise must be sent prepaid and in t he original packing, call tags will not be issued. Package must be clearly labeled with a Return Merc handise Author ization Number (RA #). Products returned without an RA # will be refused. Call CHAUVET and reque st RA # prior to shipping the fixture. Be prepared to provide the ...

Manufacturer Chauvet Category Work Light

Documents that we receive from a manufacturer of a Chauvet Vue II can be divided into several groups. They are, among others:
- Chauvet technical drawings
- Vue II manuals
- Chauvet product data sheets
- information booklets
- or energy labels Chauvet Vue II
All of them are important, but the most important information from the point of view of use of the device are in the user manual Chauvet Vue II.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Chauvet Vue II, service manual, brief instructions and user manuals Chauvet Vue II. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Chauvet Vue II.

Similar manuals

A complete manual for the device Chauvet Vue II, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Chauvet Vue II by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Chauvet Vue II.

A complete Chauvet manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Chauvet Vue II - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Chauvet Vue II, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Chauvet Vue II, that we can find in the current document
3. Tips how to use the basic functions of the device Chauvet Vue II - which should help us in our first steps of using Chauvet Vue II
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Chauvet Vue II
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Chauvet Vue II in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Chauvet Vue II?

Use the form below

If you did not solve your problem by using a manual Chauvet Vue II, ask a question using the form below. If a user had a similar problem with Chauvet Vue II it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)