English dropdown-ico

Manual Nuvo 500

16 pages 4.92 mb
Download

Go to site of 16

Summary
  • Nuvo 500 - page 1

    ~1~ ASSEMBL Y & OPERA TION MANUAL 250/500 CELLAR n u v o k o o l s p a c e TM ...

  • Nuvo 500 - page 2

    ~2~ ~3~ 1. LOCA TING YOUR WINE CELLAR - Remember , it is not an appliance, it is a piece of furniture 2. AREA FOR ASSEMBLING YOUR WINE CELLAR Choose a clear 12’ by 12’ area with a level oor and carpeting to help reduce scratching of surfaces. 3. T OOLS * Hex wrench (included) * P hillips screwdriver * Carpenter’ s level * Helper or two is ...

  • Nuvo 500 - page 3

    ~2~ ~3~ Cam Cap x 26 (x30)* Hex bolt x 22 (x30)* Coupler screw x 8 Hex wrench x 1 Cam x 24 (x28)* Cam P in x 24 (x28)* Coupler hanger x 4 Hinge x 4 In Cooling Unit Box Hex Bolt (Flange) x 2 P anel Insulation Strip *NOTE : Hardware quantities for Model 500 are indicated in parenthesis. HARDW ARE KIT C B A G F I E J H D ...

  • Nuvo 500 - page 4

    ~4~ ~5~ Open Boxes VP6 and VP7. Install INSULA TION STRIP (J) to Back, T op, and Bottom P anels. PUSH IN FULL Y! Insert Cam Pins (F) in BACK P ANEL ’S predrilled holes down to T AB. (May require some force) STEP 1 : P ANEL PREP ARA TION 1 P ANEL EDGE J CAUTION : 1. W atch for sharp staples on boxes. 2. DO NOT STEP ON P ANELS 3 . The manual will g ...

  • Nuvo 500 - page 5

    ~4~ ~5~ Use allen key provided or #3 phillips screwdriver . Attach T OP and Bottom to Back by CAREFULL Y aligning edge holes over Cam P ins and gently push together to avoid damaging cam pins. DO NOT BANG OR SLAP P ANELS T OGETHER!!! Insert Cam, push all the way in under panel level (may require some force) and make sure Arrow points to outside edg ...

  • Nuvo 500 - page 6

    ~6~ ~7~ Insert Cam Cap (A) in all Cam Holes . 3 STEP 2 : CABINET ASSEMBL Y CONTINUED T OP !!! Open Box VP5 or VP2. Insert Cam Pins (F) in BACK P ANEL ’S predrilled holes down to T AB. (May require some force) Attach SIDES to Back/Bottom/T op by CAREFULL Y aligning edge holes over Cam P ins and gently push together to avoid damaging cam pins. DO N ...

  • Nuvo 500 - page 7

    ~6~ ~7~ Open Box VP3. Fasten one HINGE (found in door box) to the SIDE of the cabinet Install four LEGS (H) into BASES fully in. Fasten FRONT BASE to the BOTT OM of the cabinet ( FRONT BASE has to be set with end tabs away from front edge) Fasten BASE with HEX BOL TS (B) 4 1 3 4 STEP 3 : HINGE,BASE AND LEGS INST ALLA TION Raise cabinet and check fo ...

  • Nuvo 500 - page 8

    ~8~ ~9~ STEP 4 : SHEL VES Open box VP4S or VP4D Hook SHEL VES into hangers start- ing from the bottom of cabinet, (12 shelves on cooling unit side, 14 on the other) alternating the two sides HINT : CENTER SHEL VES ON HANGERS 1 2 Snap SHEL VES into hangers on one side Push the SHEL VES down to snap into op- posite side hangers 3 3 1 2 P R ES S BOTT ...

  • Nuvo 500 - page 9

    ~8~ ~9~ STEP 5 : COOLING UNIT INST ALLA TION GET HELP BEFORE INST ALLING AND KEEP CHILDREN CLEAR OF CELLAR CONSTRUCTION AREA. Get helper to help guide unit, keep light cord clear of edge inside cellar and to prevent tipping of cellar . MAKE SURE INSULA TION STRIP IS IN CORRECT ORIENT A TION . Run light cord through Cut-out. Slide unit into the back ...

  • Nuvo 500 - page 10

    ~10~ ~1 1~ STEP 6 : LIGHT AND LIGHT COVER INST ALLA TION 4 Insert LIGHT COVER to holes pre drilled on front edge of T OP panel. 2 Plug cord to LIGHTS and 1 R emove plastic CAP at right end for only LIGHT , DO NOT remove CAP from LIGHT . CAP 1 LIGHT 2 LIGHT 1 2 3 Insert LIGHT to LIGHT COVER 1 2 Cord behind ...

  • Nuvo 500 - page 11

    ~10~ ~1 1~ 1 2 3 4 5 6 7 1 2 3 4 5 6 7 1 2 3 4 5 6 7 1 2 4 5 6 7 1 2 3 4 4 5 6 7 1 2 3 4 5 6 7 1 2 3 3 4 5 6 7 1 2 3 4 4 5 6 7 1 2 3 4 5 6 7 1 2 3 4 5 6 7 1 2 3 4 4 5 6 7 1 2 3 4 5 6 7 1 2 3 3 4 5 6 7 1 2 3 4 5 6 7 1 2 3 4 5 6 7 1 2 3 4 5 6 7 4 4 3 3 4 4 4 Install T OP HINGES with HEX BOL TS ( B) NOTE : STEP 7 : DOORS INST ALLA TION Insert DOORS on ...

  • Nuvo 500 - page 12

    ~12~ ~13~ FEA TURES: - Default SET temperature 57º F/14º C (ideal for wine storage). - Calibration option of the temperature sensor . - Display of actual temperature by request. - SET temperature range 52ºF-64ºF . - Digital temperature sensor . - Dual display Fº/Cº. - Settings are stored in memory for power failures. - P re programed software ...

  • Nuvo 500 - page 13

    ~12~ ~13~ MAXIMUM CAP ACITIES AND LOADING TIPS 8 MODEL 500 220 248 � 38 40 40 26 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 Max 4" dia. bottles Max 3.5" dia. bottles 3 rows 3" dia. or 2 rows 4.5" dia. Max: 506 3" bottles 26 2 12 8 8 4 MODEL 250 110 124 � 19 20 20 13 7 7 7 7 7 7 7 7 7 7 7 7 7 ...

  • Nuvo 500 - page 14

    ~14~ ~15~ TROUBLE SHOOTING GUIDE Although each Vintage K eeper cooling unit has been carefully tested at every stage of manufacture, occasional problems arise, the majority of which are due to rough or careless handling during shipping or installation. Other problems may derive from improper cabinet assembly , power interruption or surge, low line ...

  • Nuvo 500 - page 15

    ~14~ ~15~ LIMITED W ARRANTY AND PRODUCT SUPPOR T ONE YEAR LIMITED W ARRANTY If your Koolspace cooling unit or cabinet fails to perform as designed within one year of the date of purchase, VINT AGE KEEPER INC. warrants that, upon your request, it will be repaired or replaced, at our option, during the one year warranty period. This warranty applies ...

  • Nuvo 500 - page 16

    ~16~ T oll free: 1-888-274-8813 www .koolspace.com 250/500 CELLAR n u v o k o o l s p a c e TM ...

Manufacturer Nuvo Category Beverage Dispenser

Documents that we receive from a manufacturer of a Nuvo 500 can be divided into several groups. They are, among others:
- Nuvo technical drawings
- 500 manuals
- Nuvo product data sheets
- information booklets
- or energy labels Nuvo 500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Nuvo 500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Nuvo 500, service manual, brief instructions and user manuals Nuvo 500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Nuvo 500.

Similar manuals

A complete manual for the device Nuvo 500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Nuvo 500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Nuvo 500.

A complete Nuvo manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Nuvo 500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Nuvo 500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Nuvo 500, that we can find in the current document
3. Tips how to use the basic functions of the device Nuvo 500 - which should help us in our first steps of using Nuvo 500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Nuvo 500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Nuvo 500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Nuvo 500?

Use the form below

If you did not solve your problem by using a manual Nuvo 500, ask a question using the form below. If a user had a similar problem with Nuvo 500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)