Manual Hilleberg Jannu

23 pages Not applicable
Download

Go to site of 23

Summary
  • Hilleberg Jannu - page 1

    Upp sättning Aufbauanleitung Pitching instructions Jannu ...

  • Hilleberg Jannu - page 2

    Sök upp en plats som är jämn och fri från vassa föremål. Rensa undan sådant som kan skada tältet. Finn en plats som är skyddad från vind. Undvik helst att sätta upp tältet helt nära vattendrag, vilket kan ge mer kondens. Undvik också svackor i marken där gärna fukt och regnvatten samlas. Förberedelse av upp sättning Det är lämpl ...

  • Hilleberg Jannu - page 3

    F ör in stängerna i de korta kanalerna, så att stängernas ”ramverk” byggs upp. Börja nedifrån och fäst stängerna med kopplingskrokarna. När alla krokar är kopplade, fästs ventil- skyddet över tältet för att skydda ventil- öppningen. ...

  • Hilleberg Jannu - page 4

    Placering av markpinnar Fäst markpinnar i fotändens hörn (om det inte redan är gjort). S träck tältet ordentligt och fäst mark- pinnar i absiden. Se till att de ställbara pinnfästena är i ytterläge innan mark- pinnarna placeras i metallringarna på pinnfästesbanden, och trycks ned i marken. Längs tältets långsidor utgörs pinnfästen ...

  • Hilleberg Jannu - page 5

    förankrats, är det dags att placera övriga markpinnar , samt spänna ut staglinorna och förankra även dessa. Vinkeln på dessa från tältet kan man variera efter förmodad vindriktning. Det är viktigt att linorna hålls så långa som möjligt, för bästa stagningsförmåga. De skall dock inte spännas så hårt att tältets form påverkas. ...

  • Hilleberg Jannu - page 6

    Ingång och absid På Jannu är det enkelt att variera ingången i absiden. Blixtlåsöppningen ger möjlighet att fritt välja ingångssida. Man kan gå in från sidan eller frami- från, beroende på vad som pas- sar bäst i rådande väder- förhållanden (ingång framifrån skyddar innertältet bättre vid regn). Oavsett hur man väljer att öp ...

  • Hilleberg Jannu - page 7

    Nedt agning och p ackning Börja med att sopa ur innertältet innan nedt agning. Blixtlåsen skall vara stängda när tältet packas. Koppla loss ventilskyddet på ena sidan och låt den sitta kvar med två fästen. Nu är det enkelt att komma åt kopplingskrokarna. Börja att lossa krokarna från toppen. L yft ur stängerna ur de kort a kanalerna. ...

  • Hilleberg Jannu - page 8

    Användning av inner- och yttertält sep arat Det är enkelt att använda innertältet separat. Det som behövs är sex lösa stånghållare, som kopplas i innertältets hörnfästen, samt i de som finns på tältets långsidor . Tältets stänger träs genom öglorna i kopplingsresårerna, och stångändarna pla- ceras i respektive stånghållare. ...

  • Hilleberg Jannu - page 9

    Choice of site Find a site that is even and without any sharp objects. Remove those things that can damage your tent. Find a spot that is protected from the wind. A void pitching your tent close to any bodies of water to minimize condensation. Avoid also hollows where rain water can gather . Prep arations for pitching your tent It is good to start ...

  • Hilleberg Jannu - page 10

    Put the pole ends into the short pole sleeves to create the frame work of the construction. S tart from below to clip on the hooks of the outer tent to the poles. When all hooks are in place you can fasten and tighten the roof cover to ...

  • Hilleberg Jannu - page 11

    Pegging your tent Fix the tent to the ground with pegs if you have not done this yet. The Jannu does not need pulling tight because it has a self-bearing construction. But make sure that the corners are fully pulled out. When you place the pegs at the adjustable peg loops of the vestibules remember to loosen them fully before pushing the pegs throu ...

  • Hilleberg Jannu - page 12

    When the ground pegs at the corners are in place one should pull out the guy lines and peg these to the ground. An angle of approximately 45° - 90° to the direction of the tent is appropriate but the prevailing direction of the wind should be considered. It is imperative to peg down the lines as far as possible from the tent for best results in s ...

  • Hilleberg Jannu - page 13

    Entrance and vestibule With the Jannu it is easy to vary the entrance at the vestibule. The zipperoffers you a choice of entry from either the side or from the front of the tent – all depending on the prevailing weather conditions. Y ou roll up the panel and fasten it. Y ou can also chose to roll aside the entire vestibule for a panorama view! ...

  • Hilleberg Jannu - page 14

    T aking down your tent and packing it S tart by sweeping out all dirt from the inner tent. Close all zippers. Remove the roof cover on one side but keep it tied on with two attachment s. Now you can easily detach the hooks from the poles. Lift out the poles from the short pole sleeves. When the poles have been taken out pull out the pegs, fold and ...

  • Hilleberg Jannu - page 15

    Use of inner or outer separately It is easy to use the inner tent separately . All you need are six pole holders to attach to the inner tent. Thread the poles through the elastic loops and place the ends of the pole into the pole holders. The tension of the poles spreads the inner tent. Also the outer tent can be used by itself. With the inner take ...

  • Hilleberg Jannu - page 16

    Die Suche eines geeigneten Zeltplatzes Der ideale Zeltplatz ist eben, windgeschützt und ohne spitze, scharfkantige Gegenstände, die den Zeltboden beschädigen könnten. Das Zelt sollte möglichst nicht zu dicht an W asserläufen aufgebaut werden, da dies zu erhöhter Kondens- bildung führen kann. Zu vermeiden sind außerdem V ertiefungen im Bode ...

  • Hilleberg Jannu - page 17

    Die S tangen zuerst in die kurzen Kanäle einführen, um das „Rahmenwerk“ des Zeltes zu errichten. Dann, von unten beginnend, mit den Kopplungshaken befestigen. Sind alle Haken befestigt, wird der Lüftungsventilschutz über dem Zelt montiert. ...

  • Hilleberg Jannu - page 18

    Setzen der Zeltheringe Die Heringe in den Heringsbefestigungen am Fußende befestigen. Jetzt das Zelt ordentlich strecken und Heringe an der Apside befestigen. Die einstellbaren Heringsbefestigungen müssen ganz ausgezogen sein, bevor die Heringe in die Metallringe plaziert und in den Boden gesteckt werden. Entlang der Längsseiten des Zeltes beste ...

  • Hilleberg Jannu - page 19

    Anwendung der Zeltleinen Das Zelt wird mit bereits montierten Abspannleinen ausgeliefert, welche immer verankert werden sollten, auch wenn das Wetter bei Zelt aufbau gut ist. Zur optimalen Abspannung die langen Leinenbefestigungen um die Zeltst angen wickeln, bevor die Leinen gestreckt und verankert werden. Nach V erankerung der Heringe an den Zelt ...

  • Hilleberg Jannu - page 20

    V entilation Große V entilationsöffnung ist nahe des höchsten Punktes des Zeltes plaziert. Sie ist wie eine runde Luke geformt und kann je nach Belüftungsbedarf reguliert werden. Das Innenzelt hat im Dach einen großen, mit Moskitonetz versehenen, regulierbaren Lüfter . Eingang und Abside Der Eingang des Jannu ist einfach zu variieren. Die Rei ...

  • Hilleberg Jannu - page 21

    Es kann auch die ganze Abside zur freien Aussicht und V entilation offen gehalten werden. Abbau und V erp acken V or dem Abbau allen Schmutz aus dem Innenzelt ent fernen. Die Reißverschlüsse sollen beim Zusammenpacken geschlossen sein. Die Lüfterabdeckung über dem Außenzelt auf einer Seite loskoppeln (an zwei Befestigungpunkten eingekoppelt la ...

  • Hilleberg Jannu - page 22

    trockenen Ort aufgehängt, statt im Beutel aufbewahrt werden. V or dem Einpacken allen Schmutz herausschütteln und eventuelle Schmutzflecken mit lauwarmen W asser entfernen. Das Zelt auf eventuelle Schäden kontrollieren und gegebenenfalls reparieren. Zelt-Heringe reinigen und verloren gegangene ersetzen. Das Gestänge auf Schä- den überprüfen. ...

  • Hilleberg Jannu - page 23

    Zubehör: Unterlegboden zum Schutz vor Schmutz, scharfkantigen S teinen und Feuchtigkeit. (Eine abgedeckte Apsis ergiebt weniger Kondens) Heringe für Schnee und Sand. Eine große Hilfe beim Zelten auf losem Sand oder Schnee! Heringe für harte Böden. Bei sehr harten Böden können schlagfeste Heringe erforderlich sein, welche eine gute Ergänzung ...

Manufacturer Hilleberg Category Tent

Documents that we receive from a manufacturer of a Hilleberg Jannu can be divided into several groups. They are, among others:
- Hilleberg technical drawings
- Jannu manuals
- Hilleberg product data sheets
- information booklets
- or energy labels Hilleberg Jannu
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hilleberg Jannu.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hilleberg Jannu, service manual, brief instructions and user manuals Hilleberg Jannu. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hilleberg Jannu.

Similar manuals

A complete manual for the device Hilleberg Jannu, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hilleberg Jannu by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hilleberg Jannu.

A complete Hilleberg manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hilleberg Jannu - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hilleberg Jannu, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hilleberg Jannu, that we can find in the current document
3. Tips how to use the basic functions of the device Hilleberg Jannu - which should help us in our first steps of using Hilleberg Jannu
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hilleberg Jannu
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hilleberg Jannu in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hilleberg Jannu?

Use the form below

If you did not solve your problem by using a manual Hilleberg Jannu, ask a question using the form below. If a user had a similar problem with Hilleberg Jannu it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)