English dropdown-ico

Manual Henny Penny MP-943

18 pages 1.13 mb
Download

Go to site of 18

Summary
  • Henny Penny MP-943 - page 1

    Henny Penny Mod el MP-941/942/943/944 Henny Penny Multipurpose Holding Cabinet Model MP-941 Model MP-942 Model MP-943 Model MP-944 OPERATOR’S MANUAL ...

  • Henny Penny MP-943 - page 2

    Model MP-941/942/943/944 LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT Subject to the fol lowing con ditions, He nny Penny Co rporati on makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacem ent parts: NEW EQUIPMENT: Any pa rt of a ne w appliance, e xcept ba skets, lam ps, and fuses, whi ch prove ...

  • Henny Penny MP-943 - page 3

    Model MP-941/942/943/944 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... ....1-1 1-1. Multipurpose Holding Cabinet ...............................................................................1-1 1-2. Features ........................... ...

  • Henny Penny MP-943 - page 4

    Model MP-941/942/943/944 SECTION 1. INTRODUCTION 1-1. MULTIPURPOSE The Henny Penny Multipurpose Holding Cabinet HOLDING CABINET is a basic unit of food equipment designed to hold hot foods at proper temper ature in commercial food operations. This cabinet will keep hot foods hum id while maintaining tem perature. As of August 16, 2005, the Waste El ...

  • Henny Penny MP-943 - page 5

    Model MP-941/942/943/944 1-5. SAFETY The only way to ensure safe operation of the Henny Penny Multipurpose Holding Cabinet is to fully understand the proper in stallation, operation and maintenance procedures. The in structions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importa ...

  • Henny Penny MP-943 - page 6

    Model MP-941/942/943/944 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny Multipurpose Holding Cabinet. Installation of this unit should be performed by a qualified service technician. Do not puncture the skin of unit with drills or screws as component damage or electrical shock could ...

  • Henny Penny MP-943 - page 7

    Model MP-941/942/943/944 2-2. UNPACKING (Continued) 4. Open drawers and remove the packing or literature that is inside. 5. Pull off any protective cove ring from the exterior of the cabinet. 6. Your multipurpose holding cabinet is now ready for location and setup. 2-3. ELECTRICAL The multipurpose holding cabinets are available f rom the factory as ...

  • Henny Penny MP-943 - page 8

    Model MP-941/942/943/944 2-4. CABINET DIMENSIONS MP-941 1 0 3 2 - 3 ...

  • Henny Penny MP-943 - page 9

    Model MP-941/942/943/944 2-4. CABINET DIMENSIONS (Continued) 2-4 103 ...

  • Henny Penny MP-943 - page 10

    Model MP-941/942/943/944 SECTION 3. OPERATION 3-1. INTRODUCTION This section provides oper ating procedures for the multipurpose holding cabinets. Read the Introduction, Installation and Operation Sec tions, and all instructions should be followed before operating the cabinet. This section contains an e xplanation of all controls, components, and i ...

  • Henny Penny MP-943 - page 11

    Model MP-941/942/943/944 3-2. OPERATING CONTROLS AND COMPONENTS (Continued) Figure 3-1 3-3. START-UP Before using the cabinet, it should be thoroughly cleaned as described in the cleaning procedures section of this manual. To put the cabinet into operation, move each POWER switch to the ON position and adjust each contro l to the appropriate temper ...

  • Henny Penny MP-943 - page 12

    Model MP-941/942/943/944 3-3. START-UP (Continued) 1. Turn the POWER switch to the ON position. 2. The display will show the time of day or “ON”. Press and hold the appropriate drawer button to view the actual temperature of the drawer. 3. Wh en the temperature LED illum inates, the setpoint temperature has been reached and product can now be l ...

  • Henny Penny MP-943 - page 13

    Model MP-941/942/943/944 3-5. CLEANING (Continued) 5. Clean the interior of the cabinet thoroughly with a cloth and soapy water. Do not use steel wool, other abrasive cleaners or cleaners/sanitizers con taining chlorine, bromine, iodine or ammonia chemicals, as these will deteriorate the stainle ss steel material and shorten the life of the unit. D ...

  • Henny Penny MP-943 - page 14

    Model MP-941/942/943/944 3-6. OPERATION AND 2. While holding in on the drawer button, press and PROGRAMMING release the SET button. Now the setpoint temperature (Continued) will be blinking at a faste r rate. Now release the drawer button. 3. Press the UP and DOWN buttons to change the setpoint temperature. 4. Once the desired setpoint temperature ...

  • Henny Penny MP-943 - page 15

    Model MP-941/942/943/944 3-6. OPERATION AND Setting Control to the Correct Number of Draw ers PROGRAMMING (Continued) The different models, MP-941, 942, 943, and 944, all use the same control board. The boards are programmed at the factory for the correct unit. But, should the unit show “E06” or some drawers will not heat, the board may not be ...

  • Henny Penny MP-943 - page 16

    Model MP-941/942/943/944 G L O S S A R Y HENNY PENNY HO LDING CABINETS air temperature probe a round devi ce located inside t he cabinet that measures t he inside air temperature an d sends that i nformation t o the contr ol panel concentration ring assembly a metal assembly located in the water pan in the bottom of the unit that h elps keep an eve ...

  • Henny Penny MP-943 - page 17

    Model MP-941/942/943/944 probe clip a metal holder that attaches to the outside of the contro l panel to hold the food probe when not in use; the clip is an optional accessory product load capacity the highest recommen ded number of pounds/k ilograms of food product that can be safely held in the cabinet proof function a program used for allowing b ...

  • Henny Penny MP-943 - page 18

    *FM05 - 017 - E * Henny Penny Corp., Eaton, Ohio 45320, Revised 02- 21 -0 8 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax www.hennype nny.com ...

Manufacturer Henny Penny Category Food Warmer

Documents that we receive from a manufacturer of a Henny Penny MP-943 can be divided into several groups. They are, among others:
- Henny Penny technical drawings
- MP-943 manuals
- Henny Penny product data sheets
- information booklets
- or energy labels Henny Penny MP-943
All of them are important, but the most important information from the point of view of use of the device are in the user manual Henny Penny MP-943.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Henny Penny MP-943, service manual, brief instructions and user manuals Henny Penny MP-943. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Henny Penny MP-943.

Similar manuals

A complete manual for the device Henny Penny MP-943, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Henny Penny MP-943 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Henny Penny MP-943.

A complete Henny Penny manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Henny Penny MP-943 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Henny Penny MP-943, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Henny Penny MP-943, that we can find in the current document
3. Tips how to use the basic functions of the device Henny Penny MP-943 - which should help us in our first steps of using Henny Penny MP-943
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Henny Penny MP-943
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Henny Penny MP-943 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Henny Penny MP-943?

Use the form below

If you did not solve your problem by using a manual Henny Penny MP-943, ask a question using the form below. If a user had a similar problem with Henny Penny MP-943 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)