English dropdown-ico

Manual M&S Systems DMC3-4

24 pages 3.63 mb
Download

Go to site of 24

Summary
  • M&S Systems DMC3-4 - page 1

    dmc3-4 Installation Instructions $QEG $QEG 1. 1. ...

  • M&S Systems DMC3-4 - page 2

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 2 Introduction Designed to update older intercom systems, the dmc3-4 is a whole- house music communications system th at uses your existing intercom 3 or 4 conductor system wire. It is designed to provide years of enjoyment and service to the homeowner. M&S audio products are bac ...

  • M&S Systems DMC3-4 - page 3

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 3 Impor tant Safety Instr uctions READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR USING THE DMC3-4 SYSTEM THE dmc3-4 MUST BE INSTALLED B Y A M&S SYSTEMS DEALER OR INSTALLER, AND MUS T CONFORM TO ALL LOCAL BUILDING AND ELECTRICAL CODES. Warning: Always follow these safety ins ...

  • M&S Systems DMC3-4 - page 4

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 4 The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of shock to persons. The exclamati ...

  • M&S Systems DMC3-4 - page 5

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 5 • Upon completion of any service or product repair, have the M&S Systems dealer or installer conduc t a safety check to ensure the system is in proper operating condition. • Use only a damp cloth to clea n the dmc3-4 master and room stations. Do not use liquid cl eaners or ...

  • M&S Systems DMC3-4 - page 6

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 6 • KEEP cables away from objects such as heating and air conditioning ducts, metal construction plates , and anything else with sharp edges that can damage the cables. Cautions: Room Station Rough-In Careful consideration should be used when determining the location of the room st ...

  • M&S Systems DMC3-4 - page 7

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 7 Installation Overview The dmc3-4 retrofit installation is completed using the following steps: • Develop the job estimate • Removal of the old intercom system • Install the dmc1H or dmc1HC housing • Replace the room stations (not e do not remove the existing room station mo ...

  • M&S Systems DMC3-4 - page 8

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 8 • Wood chisel • Dry wall saw You may not need to use all these tools on each install but having them handy will make the overa ll installation process easier. Develop the Job Estimate It is critical that you determine the complexity of each retrofit installation prior to develo ...

  • M&S Systems DMC3-4 - page 9

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 9 Removing the Old System Prior to removing the existing intercom system make sure all power is turned off at the intercom loca tion. Remove the screws from the intercom master and while removing the intercom, make sure to carefully label each wire with its corresponding room locatio ...

  • M&S Systems DMC3-4 - page 10

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 10 Figure 2 - dmc1H or dmc1HC wall housing placement Figure 3 - Transformer 120VAC/60Hz run combination systems only – or thos e that include the dmc3-4 master and the optional dmc1CD 6-disc CD player. Locate wall housing dmc1H or dmc1HC (combo). The housing must be positioned so t ...

  • M&S Systems DMC3-4 - page 11

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 11 Figure 4 – Transformer placement TE5C TE2C Figure 5 - dmc3-4HC transformer connection Figure 6 - DMCFR installation For the dmc1HC combo wall housing ha ve a qualified electrician loop a power wire from the TE5C tran sformer enclosure to the TE2C transformer enclosure following ...

  • M&S Systems DMC3-4 - page 12

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 12 Figure 7 - Room Station W iring - 3- W ire Next connect the wires to the dmc retrofit room station as shown in Figure 7. Match the wire colors to the corresponding screw locations on the dmc3 or dmc4 room stations. Please make sure to use only dmc3 room stations in a 3-wire instal ...

  • M&S Systems DMC3-4 - page 13

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 13 Figure 8 - Placing Room Station in After connecting the room station to the existing wiring using the diagrams above. Place the room station through the DMCFR plastic mounting plate. Position the plate either vertically or horizontally depending on the room station replaced. Place ...

  • M&S Systems DMC3-4 - page 14

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 14 DMC1HRWS. This is a surface mount box and cover that will support the DMC1RW, DMC3RW or DMC4RW patio speakers. To install a patio speake r follow the instructions presented above for interior room stations. Door Stations Remove the old door station but do not remove the rough-in b ...

  • M&S Systems DMC3-4 - page 15

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 15 Figure 10 - Chime module installation Make sure the single gang box extends past the wall stud and into the room so it will be flush with the sh eetrock when it is applied. Run the Red and Black shielded audio cables (included in the AWPRX) from the master unit location to the AWP ...

  • M&S Systems DMC3-4 - page 16

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 16 Green Terminal W hite Terminal Red Terminal Figure 14 - dmc3-4 maste r wire connections Black Terminal Black Patio Shield Wire Terminal Installing the dmc3-4 The dmc3-4 ships configured for a 3- wire retrofit system. If you are replacing a 4-wire system you must change the jumper ...

  • M&S Systems DMC3-4 - page 17

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 17 Figure 15 - Door Station Connections Figure 16 – Chime Plug Connection marked on the inside of the door ac cess panel on the left side of the dmc3-4 master. Connect the green wire(s) from the pa tio station(s) to the Patio green terminal. Connect the patio Black wi re(s) to the ...

  • M&S Systems DMC3-4 - page 18

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 18 Follow the steps below to attach a Nu Tone 300 Ohm twin lead antenna to the dmc3-4. 1. If the antenna has a plug on the end, cut the plug off 2. Strip the 2 wire ends 3. Connect the wire ends to terminal S1 and S2 on the antenna board 4. Connect a bare jumper wire (a 22 gauge spea ...

  • M&S Systems DMC3-4 - page 19

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 19 MC960 Power Amp Installation Run the MS7XSC cable from the dmc1H or dmc1HC wall housing to the remote power amplifier. Run the MS3XSC cable from the remote amplifier to each volume control (use the SVC96 for ster eo or the MVC1 for mono). From each volume control, run the MS2SXSC ...

  • M&S Systems DMC3-4 - page 20

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 20 amplifier. From each volume contro l location, run a MS2SXSC cable to each satellite speaker (left & right) or mono as shown in Figure 19. Install the appropriate mounting ring for each respective speaker. Follow the instructions included with the sp eaker for specific dimensi ...

  • M&S Systems DMC3-4 - page 21

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 21 Test the System After all connections have been made, insert the dmc3-4 power plug into TE5C transformer and secure the mast er to the wall housing using the 2 screws provided. If using the dmc1F, dmc1FC or dmc1FM frame with a dmc1CD player, install the master unit over the frame. ...

  • M&S Systems DMC3-4 - page 22

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 22 NuT on e S y st e m s I M - 4 4 0 6 IM - 3 3 0 3 SM 4 2 8 X 2561/ 2562 X 2401/ 2402 X 2542 X 2540/ 2541 X IM - 4 0 6 X IM - 4 0 0 6 X IM A - 3 0 3 X I M A - 203D X I M A - 2003 X I M A - 3003 X I M A - 3303 X 2067/ 2068 X 2011/ 2012 X 2015/ 2016 X 2053/ 2054 X 2055/ 2056 X 2071 X ...

  • M&S Systems DMC3-4 - page 23

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 23 Appendix B – M&S Systems M& S P ar t Nu mb er M& S 6 0 2 M& S MC 60 2 w it h MC P / MDC 6 M& S MC 7 0 2 M& S MC 70 2 w i t h MC P / MC D6 M& S 3 0 2 M& S MC 30 2 w i t h MC P / MDC6 M &S 440 Se r i es M& S 5 00 Se r i e s M& S 4 0 Se r ...

  • M&S Systems DMC3-4 - page 24

    dmc3-4 www.mssystems.com | 800.421.1 587 | www.mssystems.com Page 24 M&S Systems 2-Year Warranty M&S Systems wa rrants its prod ucts to be free of defects for 2 years. The warranty period begins on either (a) the date of purchase or in stallation date o f this product or (b) the date of closing on a new residence in which this product was o ...

Manufacturer M&S Systems Category Intercom System

Documents that we receive from a manufacturer of a M&S Systems DMC3-4 can be divided into several groups. They are, among others:
- M&S Systems technical drawings
- DMC3-4 manuals
- M&S Systems product data sheets
- information booklets
- or energy labels M&S Systems DMC3-4
All of them are important, but the most important information from the point of view of use of the device are in the user manual M&S Systems DMC3-4.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals M&S Systems DMC3-4, service manual, brief instructions and user manuals M&S Systems DMC3-4. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product M&S Systems DMC3-4.

Similar manuals

A complete manual for the device M&S Systems DMC3-4, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use M&S Systems DMC3-4 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of M&S Systems DMC3-4.

A complete M&S Systems manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual M&S Systems DMC3-4 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the M&S Systems DMC3-4, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the M&S Systems DMC3-4, that we can find in the current document
3. Tips how to use the basic functions of the device M&S Systems DMC3-4 - which should help us in our first steps of using M&S Systems DMC3-4
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with M&S Systems DMC3-4
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of M&S Systems DMC3-4 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning M&S Systems DMC3-4?

Use the form below

If you did not solve your problem by using a manual M&S Systems DMC3-4, ask a question using the form below. If a user had a similar problem with M&S Systems DMC3-4 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)