English dropdown-ico

Manual Kenmore 153.31242

24 pages 2.42 mb
Download

Go to site of 24

Summary
  • Kenmore 153.31242 - page 1

    Use & Care Guide Model No. 153.312420 40 Gallon 0Qus I<enmore® c" @ For potable water heating only. Not suitable for space heating. INSTALLER: Affix these instructions to or near the water heater. OWNER: Retain these instructions for future reference. Si no puede leer o entender el ingles y necesita el manual de instrucciones en espaSo ...

  • Kenmore 153.31242 - page 2

    Your safety and the safety of others is extremely important in the installation, use and servicing of this water heater. Many safety-related messages and instructions have been provided in this manual and on your own water heater to warn you and others of a potential injury hazard. Read and obey all safety messages and instructions throughout this ...

  • Kenmore 153.31242 - page 3

    Read and understand instruction manual and safety messages before installing, operating or servicing this water heater. Failure to follow instructions and safety messages could result in death or serious injury. Instruction manual must remain with water heater. Improper installation and use may result in property damage. • Do not operate water he ...

  • Kenmore 153.31242 - page 4

    3 - YEAR LIMITED WARRANTY ON WATER HEATER For three years from the date of purchase, if this water heater is installed and operated in a single-family home in accordance with the owner's manual instructions and all local applicable plumbing codes, Sears will: 1. Supply free water heater parts for those that are defective in material or workman ...

  • Kenmore 153.31242 - page 5

    SAFE INSTALLATION, USE AND SERVICE ....................................................................................................................................... 2 GENERAL SAFETY .................................................................................................................................................................. ...

  • Kenmore 153.31242 - page 6

    installed and maintained, itshould give you years oftrouble free service. It is strongly suggested that this new water heater be professionally installed, contact the local Sears Service Center or any Sears store. They wilt arrange for prompt, quality installation by Sears authorized contractors. Abbreviations Found In This Instruction Manual: UL- ...

  • Kenmore 153.31242 - page 7

    Materials Needed To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials, depending on your type of installation. WATER HEATER INSTALLATION KIT WITH FLEXIBLE CONNECTORS FOR 3/4" THREADED OR COPPER PLUMBING. EXPANSION TANKS FOR THERMAL EXPANSION CONDITIONS AVAILABLE IN ...

  • Kenmore 153.31242 - page 8

    Removing the Old Water Heater The water passing out of the drain valve may be extremely hot. To avoid being scalded, make sure all connections are tight and that the water flow is directed away from any person. 4, Check again to make sure the electrical supply is turned "OFF" to the water heater. Then unplug the water heater (cord set) or ...

  • Kenmore 153.31242 - page 9

    Mineral Buildup or Sediment MayAccumulate • This causes the water heater to become much heavier than normal. • If spilled, could causestaining. Mineral buildup or sediment may have accumulated in the old water heater. This causes the water heater to be much heavier than normal and this residue, if spilled out, could cause staining. Facts to Con ...

  • Kenmore 153.31242 - page 10

    HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a temperature which wilt satisfy clothes washing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely tobe permanently injured by hot water than others. These include the elderly, children, the ...

  • Kenmore 153.31242 - page 11

    block the discharge opening or hinder access to the manual relief lever (Figure 9). Ensure a discharge pipe is installed into the T&P valve discharge opening per the instructions in this manual. 4. Locate the hot water (outlet) & cold water (inlet) pipes tothe water heater. 5. Locate the slit running the length of a section of pipe insulati ...

  • Kenmore 153.31242 - page 12

    The temperature-pressure relief valve must be manually operated at least once a year. Caution should be taken to ensure that (1) no one is in front of or around the outlet of the temperature- pressure relief valve discharge line, and (2) the water manually discharged wilt not cause any bodily injury or property damage because the water may be extre ...

  • Kenmore 153.31242 - page 13

    c. Wiring Diagram Flexible metal conduit or flexible metallic tubing shall be permitted for grounding if all the following conditions are met: The length in any ground return path does not exceed 6 feet. The circuit conductors contained therein are protected by overcurrent devices rated at 20 amperes or less. The conduit or tubing is terminated in ...

  • Kenmore 153.31242 - page 14

    Temperature Regulation Temperature Settings IF ll mT_,l([e] =1 :! Water temperature over 125°F (52°C) can cause severe burns instantly resulting in severe injury or death. Children, the elderly, and the ,_ physically or mentally disabled ...-'_@:k _ are at highest riskfor scald injury. Feel water before bathing or showering. Temperature limi ...

  • Kenmore 153.31242 - page 15

    Anode Rod Inspection Property Damage Hazard • Avoid water heater damage. • Inspection and replacement of anode as needed. The anode rod is used to protect the tank from corrosion. Most hot water tanks are equipped with an anode rod. The submerged rod sacrifices itself to protect the tank. Instead of corroding the tank, water ions attack and eat ...

  • Kenmore 153.31242 - page 16

    NOTE: If the water heater is going to be shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate to an adequate drain. 6. Close the drain valve, refill the tank, and restart the heater as directed in this manual. Improper installation and use may result in property damage. ? ...

  • Kenmore 153.31242 - page 17

    eT_,W =1 t,i • Burn hazard • Hotwater discharge. • Keep hands clear of drain valve discharge. The water passing out of the drain valve may be extremely hot. To avoid being scalded, make sure all connections are tight and that the water flow is directed away from any person. 4. Remove the screw securing the access panel, then remove the panel. ...

  • Kenmore 153.31242 - page 18

    Never use this water heater unless it is completely full of water. To prevent damage to the tank and heating element, the tank must be filled with water. Water must flow from the hot water faucet before turning "ON" power. 14. Check element for water leaks. If leakage occurs, tighten element or repeat steps 2 and 3, remove element and rep ...

  • Kenmore 153.31242 - page 19

    Start Up Conditions NOTE: Expansion tanks are pre-charged with a 40 psi air charge. If the inlet water pressure is higher than 40 psi, the THERMAL EXPANSION expansion tank's air pressure must be adjusted to match that pressure, but must not be higher than 80 psi. Property Damage Hazard • Avoid water heater damage. • Install thermal expansi ...

  • Kenmore 153.31242 - page 20

    Smelly water may be eliminated or reduced in some water heater models by replacing the anode rod (s) with one of tess active material, and then chlorinating the water heater tank and all hot water lines. Contact the local Sears Service Center for further information concerning an Anode Replacement Kit #9001453 and this Chlorination Treatment. Anode ...

  • Kenmore 153.31242 - page 21

    2. 3. 4. 5. 6. 7. Make sure the electrical supply to your water heater is "ON". Check for loose or blown fuses in your water heater circuit. Circuit breakers weaken with age and may not handle their rated load and should be replaced. Make certain the disconnect switch, if used, is in the "ON" position. Check to see the electric ...

  • Kenmore 153.31242 - page 22

    Never use this water heater unless it is completely full of water. To prevent damage to the tank and heating element, the tank must be filled with water. The water must flow from the hot water faucet before turning "ON" power. A. *Condensation may be seen on pipes in humid weather or pipe connections may be leaking. B. Small amounts of wa ...

  • Kenmore 153.31242 - page 23

    KENMORE 6 _ [ _ "I ELECTRIC WATER HEATERS I ![ 153.312420 40 Gallon Medium G ® Key No. Part Description 1 Drain Valve 2 Drain Valve Washer (17/32"xl 3/64"xl/8" thick)** 3 Element Gasket 4 Heat Trap Nipple 5 Lower Access Panel 6 Lower Element - 3800 Watts 7 Lower Thermostat w/Hi-Limit 8 Manual 9 Primary Anode Rod 10 Cold Water I ...

  • Kenmore 153.31242 - page 24

    Your Home For troubleshooting, product manuals and expert advice: managemylife www.managemylife.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it ...

Manufacturer Kenmore Category Network Router

Documents that we receive from a manufacturer of a Kenmore 153.31242 can be divided into several groups. They are, among others:
- Kenmore technical drawings
- 153.31242 manuals
- Kenmore product data sheets
- information booklets
- or energy labels Kenmore 153.31242
All of them are important, but the most important information from the point of view of use of the device are in the user manual Kenmore 153.31242.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Kenmore 153.31242, service manual, brief instructions and user manuals Kenmore 153.31242. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Kenmore 153.31242.

Similar manuals

A complete manual for the device Kenmore 153.31242, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Kenmore 153.31242 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Kenmore 153.31242.

A complete Kenmore manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Kenmore 153.31242 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Kenmore 153.31242, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Kenmore 153.31242, that we can find in the current document
3. Tips how to use the basic functions of the device Kenmore 153.31242 - which should help us in our first steps of using Kenmore 153.31242
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Kenmore 153.31242
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Kenmore 153.31242 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Kenmore 153.31242?

Use the form below

If you did not solve your problem by using a manual Kenmore 153.31242, ask a question using the form below. If a user had a similar problem with Kenmore 153.31242 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)