English dropdown-ico

Manual Centro 2000

20 pages 1.92 mb
Download

Go to site of 20

Summary
  • Centro 2000 - page 1

    W ARNING Failure to follow all of the manufactur er’ s instructions could result in hazar dous fires, explosions, pr operty damage, or serious personal injury or even death. W ARNING Follow all leak check procedur es carefully prior to operation of barbecue, even if barbecue was stored assembled. Do not try to light this barbecue without reading ...

  • Centro 2000 - page 2

    i i T ABLE OF CONTENT S W arrant y . . . . . . . . . . . . . . . . . i i Installation Informatio n . . . . . . 1 Additional W a r ning s . . . . . . . . 1 Use of LP Gas Cylinde r , . . . . . 1- 2 T ransportation and Storage of the LP Cylinde r , Filling the LP Cylinde r Prior to Using the Gril l . . . . . . . 3 Safety Hose and Regulato r . . . . 4 ...

  • Centro 2000 - page 3

    1 ADDITIONAL W ARNINGS INST ALLA TION INFORMA TION The installation of this appliance must be in accordance with all local codes, or in the absence of local codes: • Canadian installation must conform to the current national standar ds, which at this time are CAN / CGA-B149.1/2-Natural Gas / Propane installation code. Drawing A Minimum clearance ...

  • Centro 2000 - page 4

    2 FILLING THE LP CYLINDER The cylinder must be filled prior to use and must have the air purged. For safety , follow these instructions when having your cylinder filled: • Have only your local qualified LP gas dealer fill or repair a cylinder . • Do not overfill the cylinder beyond the safe 80% fill level. • Make sure the dealer tests and che ...

  • Centro 2000 - page 5

    3 PRIOR TO USING Drawing E Do not use your barbecue until you have carefully r ead and fully understand all the information in this manual. Please ensure the following: • Y our barbecue is properly assembled. • There ar e no leaks in the system (see “Leak T est”). • The burner is properly assembled, with the V enturi tubes seated over the ...

  • Centro 2000 - page 6

    4 SAFETY HOSE AND REGULA TOR Propane Gas Models: Y our barbecue is designed to operate on L.P . (Propane) gas at a pressur e of 2.74 Kpa (11˝ water column). A regulator preset to this pr essure is supplied with the barbecue and must be used. This regulator is equipped with the T ype-1 quick-closing connecting system, which incor- porates these saf ...

  • Centro 2000 - page 7

    5 Drawing B Drawing C Drawing D SAFETY LEAK TESTING Perform a “Leak T est” • Before lighting your barbecue for the first time. • Every time the cylinder is refilled, or any component is r eplaced. • At least once every year , preferably at the start of the season. The “Leak T est” must be done outdoors, away from heat, open flames and ...

  • Centro 2000 - page 8

    6 LIGHTING THE GRILL Make Sure you have followed all the safety checks, pr ocedures and instructions indicated in the previous section, befor e attempting to light the grill. Lighting The Main Burners 1. Always open the hood completely and always inspect the grill and burners to confirm that all components are pr operly positioned before lighting t ...

  • Centro 2000 - page 9

    7 6. Confirm that the burner is properly lit. If the flame pattern is other than normal, consult the T roubleshooting Guide for corrective action. 7. Always preheat the Barbecue befor e starting to cook. Light all bur ners and adjust them to the HIGH position for 5-10 minutes. Before placing any food on the Barbecue, clean the cooking grids with a ...

  • Centro 2000 - page 10

    8 8 P ARTS LISTING FOR 85-1103 (PROP ANE) G41301 Item No. Quantity Specification Part No. A 1 T op Lid Assembly AA 1 T op Lid Weldment G413-0100-01 AB 1 Handle F/ T op Lid G413-0001-01 AC 1 Thermometer G413-0029-01 AD 2 Screw for T op Lid G607-0002-01 B 1 Burner Box Assembly BA 1 Burner Box Weldment G413-0200-01 BB 1 Left Side Upper Panel G413-0300 ...

  • Centro 2000 - page 11

    9 CL BG CI CJ DA EA BB CB CK AD AC BH BI AA BF AD AB BC DC EB CA DB BA CD CE CG CF CH CC EC ED EE EF EG EH BD BA BE CD 85-1103 (PROP ANE) G41301 ...

  • Centro 2000 - page 12

    10 P ARTS LISTING FOR 85-1003-6 (NA TURAL GAS) G41302 Item No. Quantity Specification Part No. A 1 T op Lid Assembly AA 1 T op Lid Weldment G413-0100-01 AB 1 Handle F/ T op Lid G413-0001-01 AC 1 Thermometer G413-0029-01 AD 2 Screw for T op Lid G607-0002-01 B 1 Burner Box Assembly BA 1 Burner Box Weldment G413-0200-01 BB 1 Left Side Upper Panel G413 ...

  • Centro 2000 - page 13

    11 CL BG CI CJ DA EA BB CK AD AC BI AA BF AD AB BC DC EB CA DB BA CD CE CG CF CH CC EC ED EE EF EG EH BD BA BE CD CL BG CI CJ DA EA CB BB CK AD AC BH BI AA BF AD AB BC DC EB CA DB BA CD CE CG CF CH CC EC ED EE EF EG EH BD BA BE CD 85-1003-6 (NA TURAL GAS) G41302 ...

  • Centro 2000 - page 14

    12 12 1/4” x 38 mm Screw (x4) Hardwar e Pack List No. Description Part Number Quantity 1 1/4” x 38 mm Screw 20120-13038-250 4 2 1/4” x 13 mm Screw 20120-13013-250 12 3 Ø7 Lock Washer 41400-07000-250 16 4 Ø7 Flat Washer 40300-07000-250 16 5 1/4”-20UNC Nut 30220-13000-250 6 6 No. 10 x 10 Screw 20124-10010-250 12 7 Ø5 Lock Washer 41400-0500 ...

  • Centro 2000 - page 15

    13 EG EH EF EA 2 3 5 4 EB EF 1 Attach two front casters (EH) and two back casters with lock (EG) to the bottom shelf (EF) by using the provided wr ench hardware #11. A B DB EB DA EA 6 7 8 2 Assemble the cart left side panel (EA) and cart right side panel (EB) to the bottom shelf (EF) using hardwar e #2, #3, #4 and #5 (x6). 3 Assemble the whole top ...

  • Centro 2000 - page 16

    14 5 Open lid (A) and position the three flame tamers (BF) above the burners (BD) as shown. Place the two cooking grates (BG) above the flame tamers. BB EA CE CH BG BF BD 4 Assemble the upper brace (CH) below the control panel (CE) as shown using hardwar e #6,#7 and #8 (x4). Remove the screws and nuts fr om the top lid handle (AB), then assemble th ...

  • Centro 2000 - page 17

    15 BC DB CC 7 Insert grease tray left and right rail (CJ) & (CK) into the holes at the inside of the cart assembly as shown. Insert the tank heat shield (CI) into the holes in the upper rail. Assemble the upper back panel (CL) to the back of the burner box by using hardwar e #1, #3 and #4 (x4). Then attach the upper back panel (CL) to the edge ...

  • Centro 2000 - page 18

    16 CD 10 10 Unscrew the igniter cap and place AA battery which is pr ovided into igniter (CD) with positive end (+) facing outward. Scr ew igniter cap onto igniter as shown. 11 For propane model only Secure 20lb pr opane tank onto the bottom shelf of the cart as shown, attach the regulator valve to 20lb pr opane tank. W ARNING Do not store the extr ...

  • Centro 2000 - page 19

    17 This model has a 12’ hose with a male coupling plug that will allow you to attach your barbecue to your residential gas line. WE STRONGL Y RECOMMEND CONT ACTING A CERTIFIED GAS-TECHNICIAN TO INST ALL YOUR NA TURAL GAS UNIT . Connecting to Gas Line 1. Pull back the outer sleeve located on the residential gas line (see illustration). 2. Insert t ...

  • Centro 2000 - page 20

    DISTRIBUTOR T rileaf Distribution T rifeuil T oronto, Canada M4S 2B8 ...

Manufacturer Centro Category Gas Grill

Documents that we receive from a manufacturer of a Centro 2000 can be divided into several groups. They are, among others:
- Centro technical drawings
- 2000 manuals
- Centro product data sheets
- information booklets
- or energy labels Centro 2000
All of them are important, but the most important information from the point of view of use of the device are in the user manual Centro 2000.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Centro 2000, service manual, brief instructions and user manuals Centro 2000. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Centro 2000.

Similar manuals

A complete manual for the device Centro 2000, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Centro 2000 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Centro 2000.

A complete Centro manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Centro 2000 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Centro 2000, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Centro 2000, that we can find in the current document
3. Tips how to use the basic functions of the device Centro 2000 - which should help us in our first steps of using Centro 2000
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Centro 2000
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Centro 2000 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Centro 2000?

Use the form below

If you did not solve your problem by using a manual Centro 2000, ask a question using the form below. If a user had a similar problem with Centro 2000 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)