English dropdown-ico

Manual DVDO VP50

26 pages 0.92 mb
Download

Go to site of 26

Summary
  • DVDO VP50 - page 1

    DVDO by Anchor Bay Technologies, Inc. 983 University A venue, Building A Los Gatos, CA 95032 USA Tel: 866-423-DVDO (3836) Fax: 408-379-3845 www.dvdo.com Customer Support T el: 866-423-DVDO (3836) Extension 333 help@dvdo.com OWNER’S MANUAL HIGH-DEFINITION VIDEO PROCESSOR & HUB ...

  • DVDO VP50 - page 2

    DVDO BY ANCHOR BA Y TECHNOLOGIES, INC. LIMITED WARRANTY WARRANTY V ALID ONL Y IN THE U.S.A. WARRANTY DVDO by Anchor Bay T echnologies, Inc. (DVDO) warrants that products distributed in the U.S.A. that fail to function properly under normal use due to a manufacturing defect when installed and operated according to the owner’ s manual enclosed with ...

  • DVDO VP50 - page 3

    1 T ABLE OF CONTENTS SECTION 1 – GET TING ST AR TED 2 Introduction 2 Unpacking and Inspection 2 Display Compatibility Requirements 3 Document Conventions 3 Menu Navigation 3 Remote Control Battery Installation 4 Remote Control Overview 4 Info Screen 5 Installation Guidelines 6 SECTION 2 – BASIC OPERA TION 7 Front Panel Overview 7 Rear Panel Ove ...

  • DVDO VP50 - page 4

    Advanced Setups 17 Conguring the iScan VP50 PRO for projectors with anamorphic lenses Conguring the iScan VP50 PRO to output 24/48/72Hz and 25/50/75Hz SECTION 4 – MENU OPTIONS 1 8 Input Select 18 Input Aspect Ratio Control 18 Frame Aspect Ratio 19 Active Aspect Ratio 19 Panorama 19 Zoom 20 Pan 20 Borders 20 Presets 21 Input Adjust Control 2 ...

  • DVDO VP50 - page 5

    2 SECTION 1 – GET TING ST AR TED Introduction Thank you for purchasing the iScan VP50 PRO video processor , the rst VRS (Video Reference Series) component available with: • Mosquito Noise Reduction • Fine Detail Enhancement™ • Edge Enhancement VRS T echnologies included in the iScan VP50 PRO are: • 10-bit Precision Deinterlacing ™ ...

  • DVDO VP50 - page 6

    3 4 Both input and output cables can be supplied by your Authorized DVDO Reseller . T o nd your nearest Authorized DVDO Reseller , go to www.anchorbaytech.com . There are also a wide selection of cables and adapters av ailable directly from Anchor Bay . Display Compatibility Requirements DVDO iScan video processing products are compatible with a ...

  • DVDO VP50 - page 7

    5 6 INPUT SELECT ST ANDBY POWER INPUT ADJUST CONFIG PICTURE CONTROL OUTPUT SETUP MENU EXIT 16:9 4:3 AUTO VIDEO 1 S-VIDEO 1 COMP 1 HDMI 2 VIDEO 2 S -VIDEO 2 COMP 2 HDMI 3 ENTER HDMI 4 BORDER CROP INFO CURT AIN MEMORIES RGB HV HDMI 1 SDI ASPECT ZOOM P AN ON/OFF DISPLA Y PROFILES VIEWING MODES INPUT ASPECT RATIO TEST P ATTERN ENTER Standby Info Curtai ...

  • DVDO VP50 - page 8

    7 8 SECTION 2 – BASIC OPERA TION Front Panel Overview Status LED – This displays the current state of the iScan VP50 PRO Off = The unit is in standby mode R ed = No signal detected Blue = The unit is processing the signal Blinking Blue = There is a problem with HDCP authentication Green = The unit detects an unsupported signal Blinking Green = ...

  • DVDO VP50 - page 9

    9 10 The iScan VP50 PRO accepts digital audio sourced from DVD players, satellite receivers, digital set top boxes, HD-DVD players, Blu-ray players, game consoles, and other video components with digital audio. These inputs are compatible with most consumer digital audio formats, including CD-A udio (44.1kHz/16 bit LPCM), Dolby Digital, and DT S. T ...

  • DVDO VP50 - page 10

    11 12 K eep in mind that some displays do not accept their native resolution and almost all HD TVs will accept 720p and 1080i resolutions, but no xed pixel display has a native resolution of 1080i. In almost all cases, the picture will be better if one of these displays is sent a 720p signal instead of a 1080i signal. T o change the Output R eso ...

  • DVDO VP50 - page 11

    13 14 Set Top Boxes DirecTV HR10-250 (HD-TiVo) The HD- TiV o does not allow the User to select one output setting that will always output the right resolutions under the right conditions. For example, when tuned to an SD channel the output resolution should be 480i, but when tuned to an HD channel the resolution should be 720p (FOX, ABC, ESPN) or 1 ...

  • DVDO VP50 - page 12

    15 16 Forced 3:2 Mode This mode is perfect for HD-DVD and Blu-Ray players that output a cleanly encoded 3:2 signal over the entire length of a movie. This insures the highest performance playback from these high quality sources. If you intend on setting up the iScan to output a 24Hz, 48Hz, or 72Hz signal for lm-based content this mode is highly ...

  • DVDO VP50 - page 13

    17 18 The iScan has sever al ‘Half T est Patterns’ that can be brought up while the matching test patterns are played from the VRS DVD. The test patterns to use on the DVD are listed below . The matching test patterns can be found in the ‘Conguration’ menu (Congur ation → T est Patterns). Static Patterns _ Half Patterns _ Black and ...

  • DVDO VP50 - page 14

    19 20 The VP50 PRO ‘s menu is exit automatically after 30 seconds of no user interaction. Video input signals are usually classied in the following two ways: • Frame Aspect R atio • Active Input Aspect Ratio Frame Aspect Ratio Frame Aspect Ratio (F AR) consists of two possible ratios: 4:3 or 16:9. DVD discs encoded in a 16:9 frame are some ...

  • DVDO VP50 - page 15

    21 22 Horizontal Border Control: Push the p button to move the left and right borders towards the middle of the image, increasing the border width and cutting off the sides of the input image. Push the ▼ button to move the left and right borders away from the image and decreases their width. If there are system-generated left/right borders alread ...

  • DVDO VP50 - page 16

    23 24 • Game 2 – This mode is intended for use with game consoles (like those from Sony , Microsoft and Nintendo). This mode gives y ou minimal latency with both motion and edge-adaptive processing. The total amount of dela y with source-locked output mode set on the VP50 PRO is about one and a half fr ames of delay . Unlocked frame rates will ...

  • DVDO VP50 - page 17

    25 26 4 - Press the Exit button again to complete the priority assignment. 5 - Repeat Steps 1 through 4 to select the next video input and adjust the priorit y setting. Audio Input The Audio Input function assigns an audio input to the currently selected video input. Four digital audio inputs and a single analog audio input are available. The HDMI ...

  • DVDO VP50 - page 18

    27 28 LED Brightness This selection allows the user to congure the behavior of the Front Panel LED brightness. The ‘Normal’ par ameter adjusts the brightness of the Front P anel LED when the menu is being na vigated. The ‘Navigate’ parameter adjusts the brightness of the Front Panel LED during normal usage, when the menu is not being nav ...

  • DVDO VP50 - page 19

    29 30 A vi deo pro ject or c an a lso be u sed in conj unc tion wit h an ana mor phic le ns. An a namo rph ic l ens allo ws the us er to focus the max imu m reso lut ion an d brig htn ess in to a spe ci ed are a, ei ther 16:9 or 2.35 :1. The mos t common congu ra tio n is a const ant image heig ht (CIH) system with a 16:9 proje ctor , an anam ...

  • DVDO VP50 - page 20

    31 32 signal. Unlike the locked mode(s), the iScan’s output signal timing will not be disrupted when the input source is changed. However , it’s guaranteed to cause dropped or repeated frames as the input and output frame rates are not the same. Note that regardless of what number the unlocked output frame r ate is set to, it will never be iden ...

  • DVDO VP50 - page 21

    33 34 Trigger #1 is powered on when the iScan VP50 PRO is powered on. T rigger #1 is powered off when the iScan VP50 PRO is put into Standby mode. This can be useful for powering on a display or motorizing a screen or lift. Trigger #2 can be programmed to be powered on in the ‘Output Setup’ menu. This action can be saved as part of a Display Pr ...

  • DVDO VP50 - page 22

    35 36 User Save User to Preset 1 No Y es Preset 2 No Y es Preset 3 No Y es Preset 4 No Y es Preset 5 No Y es Preset 6 No Y es Preset 7 No Y es Preset 8 No Y es Preset 9 No Y es Preset 10 No Y es Input Adjust Mosquito Noise Reduction Off Low Medium High Deinterlacing Auto Film Bias Mode Forced Modes Video Mode Forced 3:2 Forced 2:2 2:2 Even 2:2 Odd ...

  • DVDO VP50 - page 23

    37 38 Checkerboard V ertical Lines Horizontal Lines Judder Color8 Bars75 Color8 Bars100 Window IRE10 Window IRE20 Window IRE30 Window IRE40 Window IRE50 Window IRE60 Window IRE70 Window IRE80 Window IRE90 Window IRE100 Gray R amp Xhatch Coarse Xhatch Fine Focus Half B/W H-Clr7 Bars75 H-Clr7 Bars100 H-Clr8 Bars75 H-Clr8 Bars100 Black White Red Green ...

  • DVDO VP50 - page 24

    39 40 Display 4:3 5:4 16:9 Custom Lens Mode 1 Mode 1 - Auto Mode 2 None Screen 4:3 16:9 2.35:1 Custom Range: 1.00- 3.00 Image Shift V ertical Range: -30-30 Horizontal Range: -30-30 Underscan Range: 0-100 Sync T ype Bi-Level T ri-Level Composite H+/V+ H+/V- H-/V+ H-/V- Color Space RGB YPbPr YCbCr 4:2:2 YCbCr 4:4:4 Output Level Video PC Framerate 24H ...

  • DVDO VP50 - page 25

    41 42 Y es Prole 9 No Y es Prole 10 No Y es Auto Off On ...

  • DVDO VP50 - page 26

    43 44 ...

Manufacturer DVDO Category VCR

Documents that we receive from a manufacturer of a DVDO VP50 can be divided into several groups. They are, among others:
- DVDO technical drawings
- VP50 manuals
- DVDO product data sheets
- information booklets
- or energy labels DVDO VP50
All of them are important, but the most important information from the point of view of use of the device are in the user manual DVDO VP50.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals DVDO VP50, service manual, brief instructions and user manuals DVDO VP50. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product DVDO VP50.

Similar manuals

A complete manual for the device DVDO VP50, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use DVDO VP50 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of DVDO VP50.

A complete DVDO manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual DVDO VP50 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the DVDO VP50, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the DVDO VP50, that we can find in the current document
3. Tips how to use the basic functions of the device DVDO VP50 - which should help us in our first steps of using DVDO VP50
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with DVDO VP50
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of DVDO VP50 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning DVDO VP50?

Use the form below

If you did not solve your problem by using a manual DVDO VP50, ask a question using the form below. If a user had a similar problem with DVDO VP50 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)