Manual Telex ANR TM 500

12 pages 0.33 mb
Download

Go to site of 12

Summary
  • Telex ANR TM 500 - page 1

    T el ex ® Op er ating In struc tions Air man ANR ™ 500 Head set ...

  • Telex ANR TM 500 - page 2

    Note: See page 7 for avail able re place ment parts. 1 Fl exible Boom Permits Precise Mic Placement Noise Canceling Electret Microphone Replaceable Ear Cushions Detented Sliders Adjust to Any Size Head Replaceable Headband Pad Volume Control Mono/Stereo Switch Pow er Switch Low Battery LED Fig ure 1 : Ref er ence View ...

  • Telex ANR TM 500 - page 3

    Gen eral De scrip tion The Telex Airman ANR ™500 Active Noise Reduction headset combines design features of a lightweight headset with the advanced techniques of electronic noise reduction. The result is a comfortable light-weight headset that provides good electronic reduction of low frequency ambient noise, while the cushion design provides goo ...

  • Telex ANR TM 500 - page 4

    HEADSET OPERATION 1. Connect the headset as shown in Figure 2. 2. Rotate the entire boom to wear the microphone on either the right or left side of the head. 3. With the Airman ANR  500 headband resting securely on the top of the head, check that the ear cups are centered over the ears. Proper perfor - mance depends on proper fit of the headset. ...

  • Telex ANR TM 500 - page 5

    Microphone Gain Adjustment The microphone gain has been factory-adjusted to the nominal level required for normal radio operation and should normally not require adjustment. If needed, adjustment by a qualified avionics technician is recommended. To access the microphone gain, insert a small phillips head screwdriver through the access hole in the ...

  • Telex ANR TM 500 - page 6

    BATTERY MODULE BATTERY INSTALLATION The battery module requires one 9 volt battery. Alkaline batteries are recommended for best performance. Do not use nickel-cadmium rechargeable batteries or lithium batteries. 1. To remove the battery door press down on the detent while sliding the battery door over in the direc - tion of the arrow, then lift up. ...

  • Telex ANR TM 500 - page 7

    Specifications Receivers: Type: Dynamic Frequency Response: ±6dB re 1000 Hz over the range 350 - 3000 Hz Sensitivity: 90 ±5 dB SPL (1 kHz, 1 mW input per earcup side) Impedance: 300 Ω stereo or 150 Ω monaural mode Stereo/Mono: Switch located on the control module, allows stereo or monaural headset op - eration Microphone and Amplifier: Elemen ...

  • Telex ANR TM 500 - page 8

    Gen eral: Cord age: Straight cord from head set to bat tery mod ule, 5.5 ft (66") Ra dio Con nec tions: Re ceiver; 1/4" di am e ter ste reo plug Mi cro phone: 0.206" di am e ter plug (PJ-068 equiv a lent) Weights: Head set only: 7 oz. (198g) Bat tery mod ule with bat ter y: 17 oz. (482g) Color: Black OR DERING IN FOR MA TION Prod uct ...

  • Telex ANR TM 500 - page 9

    8 LIMITED WARRANTY — VALID ONLY IN UNITED STATES AND CANADA TELEX Communications, Inc. (“Telex”) warrants to the user, who originally purchased the product delivered with this card, that the product will be free from defects in material and workmanship for the following periods after such date of purchase: Material 36 months, workmanship 36 m ...

  • Telex ANR TM 500 - page 10

    CUSTOMER SERVICE For information or technical assistance, call or write to Telex at: Customer Service Department Telex Communications, Inc. 12000 Portland Ave. So. Burnsville, MN 55337 U.S.A. (952) 884-4051 Domestic Toll Free: (877) 863-4168 (Collect calls not accepted) All equipment returned for repair must be accompanied by documentation stat - i ...

  • Telex ANR TM 500 - page 11

    Notes ...

  • Telex ANR TM 500 - page 12

    TELEX COMMUNIC AT IONS, INC. 12000 Portland Ave. S., Burnsville, MN 55337 U.S.A. l ® 38109-822 Rev C 7/02 ...

Manufacturer Telex Category Headphones

Documents that we receive from a manufacturer of a Telex ANR TM 500 can be divided into several groups. They are, among others:
- Telex technical drawings
- ANR TM 500 manuals
- Telex product data sheets
- information booklets
- or energy labels Telex ANR TM 500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Telex ANR TM 500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Telex ANR TM 500, service manual, brief instructions and user manuals Telex ANR TM 500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Telex ANR TM 500.

Similar manuals

A complete manual for the device Telex ANR TM 500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Telex ANR TM 500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Telex ANR TM 500.

A complete Telex manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Telex ANR TM 500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Telex ANR TM 500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Telex ANR TM 500, that we can find in the current document
3. Tips how to use the basic functions of the device Telex ANR TM 500 - which should help us in our first steps of using Telex ANR TM 500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Telex ANR TM 500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Telex ANR TM 500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Telex ANR TM 500?

Use the form below

If you did not solve your problem by using a manual Telex ANR TM 500, ask a question using the form below. If a user had a similar problem with Telex ANR TM 500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)