English dropdown-ico

Manual Ariens 921024

29 pages 4.13 mb
Download

Go to site of 29

Summary
  • Ariens 921024 - page 1

    Quick St art Guide Delux e 24 (921 024 s/n 101 & up) • Step 1: Assemble Handlebars • Step 2: Install Discharge Chute • Step 3: Install Discharge Chute Crank • Step 4: Install Remote Deflector Control • Step 5: Check Functi on of Dual Handle Interlock • Step 6: Check T ire Pressure • Step 7: Adjust Skid Shoes • Step 8: Check Auge ...

  • Ariens 921024 - page 2

    St ep One: Assemble Handlebar s NO TE: The Ariens c ompan y has made chang es to packaging tha t affects this serial number r ang e. If the upp er handlebar s on your unit came already at tached please disr eg ar d th e f ollowing fiv e slides. Not at tached A tt ached ...

  • Ariens 921024 - page 3

    Step On e: Assemble Handlebar s (Unf old Lower Handlebar) IMPORT A NT : Be sure to block w heels or secure unit so it does not move during assembly . 1. Rotate lower handlebar out from unit so low er handlebar mounting holes align w ith mounting holes on the unit f rame. 2. Secure lower handlebar to unit using two 3/8 in x 3/4 in. hex head serrated ...

  • Ariens 921024 - page 4

    Step On e: Assemble Handlebar s (A t tach Upper Hand lebar Assembly) 1. Attach upper handlebar assembly to lower handlebar using two sets of the handleb ar hardware. One set to att ach each side of the handlebar s. NOTE: DO NOT tighten hardw are. Allow upper handlebar assembly to hang from the lower handlebar s for the nex t st ep. NO TE: Th is sli ...

  • Ariens 921024 - page 5

    Step On e: Assemble Handlebar s (A t tach Con tr ol Cables) 1. Hook Spring end of attachment cont rol cable to the c lutch arm. 2. Hook spring end of the traction c ontrol cable to the cable eyelet on back of frame. NOTE: Make sure the cable remains in the groove of the pulley . NO TE: Th is slide applies to UNA TT ACHED handlebars ONL Y ...

  • Ariens 921024 - page 6

    Step On e: Assemble Handlebar s (Unf old Upper Handlebar) Assembly) 1. Rotate handlebar into operating position. NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward. 2. Install the remaining handlebar hardware attaching the upper handlebar as sembly to the low er handlebar . 3. T ighten all hardw are. 4. Remov e packagi ...

  • Ariens 921024 - page 7

    Step One: Assemble Handl ebar s (Connect Headlight Wir e Harness) NOTE: The headlight w ire harness comes attached to the upper handlebar as sembly . 1. Route the wire harness along the interior of the right side handlebar . 2. Connect to the engine elec trical plug. 3. Press cable anc hor into mounting hole in the frame near the engine electrical ...

  • Ariens 921024 - page 8

    Step On e: Assemble Handlebar 1. Remov e the lower and loosen the upper hardware on the handlebar as sembly . 2. Loosen the hardware on the shift rod. 3. Put the speed selector lever in the six t h forw ard pos ition. 4. Rotate the handlebar int o operating position. NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward. ...

  • Ariens 921024 - page 9

    Step T wo: Ins t all Discharg e Chut e 1. Grease underside of discharge chute ring (if not already greased). 2. Remov e mounting hardware from auger housing. 3. Install discharge c hute over opening in the auger housing. Finger tighten the mounting hardware remov ed above. NOTE: Leav e disc harg e chute pedestal loose to help ins tall the chute cra ...

  • Ariens 921024 - page 10

    Step Thr ee: Inst all Discharg e Chut e Cr ank 1. Remov e the gear cov er from top of chute pedest al. 2. Insert the short end of the c hute crank into the hole in the front of the control panel. NOTE: Be careful not to damage ny lon bushing when attaching crank to the dash. 3. Connect the chute crank to the pinion gear on chute with hairpin. 4. Re ...

  • Ariens 921024 - page 11

    Step F our: Ins t all R emot e Deflect or Con trol Cable 1. Connect the barrel cable end to the chute deflector cable anchor before clipping the cable to the discharge chute cable bracket. 2. Route deflector remote cable along the left side of the chute pedestal. 3. Insert the barrel on the cable end into the bracket on left side of chute deflector ...

  • Ariens 921024 - page 12

    St ep Fiv e: Check Function of Dual Handle In terlock Without the en gine running , press dow n (engage ) both clu tch levers. Relea se attachment clutch lever . Attachment clu tch should remain engage d until traction clutch lever is released , then both clutches must d isenga ge. If they do not, contact your dealer for repairs. ...

  • Ariens 921024 - page 13

    St ep Six: Check Tir e Pr essur e Check tire pressu re and adjust to the pressure listed on tire sidew all. ...

  • Ariens 921024 - page 14

    St ep Sev en: Adjus t Skid Shoes IMPORT A NT : Skid shoes should be adjusted as conditions require. Allow 1/8 in. (3mm) between scraper blade and hard smooth s urfaces. All ow 7/8 in (22 mm) between scraper blade and unev en or gravel surfaces. (See Skid Shoes in Owners Manual). ...

  • Ariens 921024 - page 15

    Check oil le vel in auger gearcase (see Check Auger Gearcase in Ow ners Manual). St ep Eigh t: Check Aug er Gear case Oil ...

  • Ariens 921024 - page 16

    IMPORT A NT : The eng ine is shipped with 5W-30 oil in crankcase. Refer to engine manual for detailed instructions. St ep Nine: Check Engine Cr ank case Oil (Ariens AX) ...

  • Ariens 921024 - page 17

    Fill fuel tank. DO N OT OVERFILL! See FILLING FUEL T ANK in Ow ners Manual. St ep T en: Fill Engine Fuel T ank (Ariens AX) ...

  • Ariens 921024 - page 18

    St ep Ele v en: St arting the Engine (Arie ns AX) ...

  • Ariens 921024 - page 19

    St arting Engine / Step A: Chok e T urn throttle al l the way up. T urn choke ON. ...

  • Ariens 921024 - page 20

    St arting Engine / Step B: R ock er Swit ch Push rocker switch to RUN position. ...

  • Ariens 921024 - page 21

    St arting Engine / Step C: Fuel Shut Off V alv e T urn fuel petcock to ON position. ...

  • Ariens 921024 - page 22

    St arting Engine / Step D: K ey Install Safety K ey Switch. Insert ignition key into slot but DO NOT turn the key . Be sure ignit ion key snaps into place. ...

  • Ariens 921024 - page 23

    St arting Engine / Step E: Prime Prime sy stem: 3 primes maxi mum. DO NOT over prime system. Make sure to cover the v ent hole on primer bulb before the primer bulb is compressed. Hold the primer bulb in the compressed pos ition for one full second each time you press it. Repeat for a total of 3 primes. ...

  • Ariens 921024 - page 24

    St arting Engine / Step F: (Manual St art) Grasp rope handle. Pull slowly until resistance is felt, then pull rope firmly and quickly to start engine and avoid kickback. ...

  • Ariens 921024 - page 25

    St arting Engine / Step F: (Electric St art) Use a 3-wire ex tension cord and plug cord into starter motor adaptor first. Then plug cord into wall receptacle. Use appropriately siz ed extension cord (10A WG or larger) to prevent damage to electric starter . ...

  • Ariens 921024 - page 26

    St arting Engine / Step G: (Electric St art) Press and hold starter button. Note : Do not hol d the electric starter button down for more than 5 seconds. W ait at least 1 minute before additional starting attempts. ...

  • Ariens 921024 - page 27

    St arting Engine / Step H: W arm up Allow the engine to warm up for 1- 2 minutes, move the choke control to the CHOKE OFF position. ...

  • Ariens 921024 - page 28

    St ep T welv e: St opping the Engine (Ariens AX) Under normal condition s: 1. T urn throttle dow n. 2. Push rocke r sw itch to STOP position. 3. Pull safety key OUT . T o s top engine in a n emergency , flip the Rocker Sw itch to the ST OP p osition, OR Pull Safety Key from Engine. ...

  • Ariens 921024 - page 29

    Additional R eso ur ces • R ef er to O wner s Manual and Engine Manual • Con t ac t Ariens Compan y www .ariens.com Phone: 920- 756 - 4688 E-mail: inf o@ariens.com 2013 The Ariens Company . All rights r eser ved. ...

Manufacturer Ariens Category Snow Blower

Documents that we receive from a manufacturer of a Ariens 921024 can be divided into several groups. They are, among others:
- Ariens technical drawings
- 921024 manuals
- Ariens product data sheets
- information booklets
- or energy labels Ariens 921024
All of them are important, but the most important information from the point of view of use of the device are in the user manual Ariens 921024.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Ariens 921024, service manual, brief instructions and user manuals Ariens 921024. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Ariens 921024.

Similar manuals

A complete manual for the device Ariens 921024, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Ariens 921024 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Ariens 921024.

A complete Ariens manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Ariens 921024 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Ariens 921024, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Ariens 921024, that we can find in the current document
3. Tips how to use the basic functions of the device Ariens 921024 - which should help us in our first steps of using Ariens 921024
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Ariens 921024
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Ariens 921024 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Ariens 921024?

Use the form below

If you did not solve your problem by using a manual Ariens 921024, ask a question using the form below. If a user had a similar problem with Ariens 921024 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)