Manual Craftsman 358.79731

13 pages 0.57 mb
Download

Go to site of 13

Summary
  • Craftsman 358.79731 - page 1

    Instruction Manual (RRFTSMR 24cc/1.4 cu.in. 2-Cycle 200 MPHi400 CFM GASOLINE POWERED BLOWER/VAC Model No. 358.797310 • Safety • Assembly • Operation • Maintenance • Parts List • Espa_ol A WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this produc ...

  • Craftsman 358.79731 - page 2

    Warranty Statement 2 Storage 11 Safety Rules 2 Troubleshooting Table 12 Assembly 4 Emissions Statement 12 Operation 6 Parts List 14 Maintenance 9 Spanish 17 Service & Adjustments 10 Parts and Ordering Back FULL TWO YEAR WARRANTY ON CRAFTSMAN ® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, a ...

  • Craftsman 358.79731 - page 3

    • Mix and pour fuel in an outdoor area; store fuel in a cooI, dry, wel_ ventilated pIace; use an approved, marked con- tainer for al} fuel purposes. • Do not smoke while handling fuel or while operating the unit. • Make sure the unit is properIy as- sembIed and in good operating con- dition. • Do not fill fuel tank while engine is running. ...

  • Craftsman 358.79731 - page 4

    • Store in a dry area out of reach of children. SPECIAL NOTICE: For users on U.S. Forest Land and in some states, in- cluding California(Public Resources Codes 4442 and 4443), Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington: Certain internal combus- tion engines operated on forest, brush, and/or grass covered land in the above areas a ...

  • Craftsman 358.79731 - page 5

    2. Push the small end of the elbow tube through the small opening in the bag. Elbow Tube Small Opening Zipper Opening Rib NOTE: Make sure edge of the smaIt opening is flush against the flared area of the elbow tube, and the rib on the eIbow tube is on the bottom. 3. Close the zipper on the bag. Make sure the zipper is closed complete- ly. 4. Remove ...

  • Craftsman 358.79731 - page 6

    SHOULDER STRAP ADJUSTMENT (for vacuum use only) 1. Hold the unit as shown. 2. Pass the shouider strap over your head and onto your right shoulder. 3. Extend you left arm toward the rear of the vacuum bag. 4 Adjust shouider strap until the vac- uum bag/shoulder strap seam lies between your thumb and index finger. 5. Make sure air flows freety from t ...

  • Craftsman 358.79731 - page 7

    OPERATING TIPS • While vacuuming or blowing debris, hold the unit with the muffler side fac- ing away from your body and clothes (see OPERATING POSITION). • To reduce the risk of hearing boss associated with sound level(s), hear- ing protection is required. • To reduce the risk of injury associated with contacting rotating parts, stop the eng ...

  • Craftsman 358.79731 - page 8

    STARTING THE ENGINE z% _ll WARNING: You MUST make sure the tubes are secure before using the unit. Fuel engine. Move at teast 10 feet (3 meters) away from the fuelng site. HoM the unit in the starting position as shown. Make sure the blower end is directed away from peopte, animals, gtass, and sold objects. STARTING POSITION Blower / WARNING: When ...

  • Craftsman 358.79731 - page 9

    CUSTOMER RESPONSIBILITIES CARE & MAINTENANCE TASK WHEN TO PERFORM Check for Loose fasteners and parts Check for damaged or worn parts Clean unit and IabeIs Clean air filter Replace spark plug Replace fuel filter Check muffler bolts dBbWARNING: Stop engine and be sure the impeller blades have stopped turning before opening the vacuum in- let doo ...

  • Craftsman 358.79731 - page 10

    REPLACE FUEL FILTER To replace fuel filter, drain unit by run- ning it dry of fuel, then remove fuel cap/retainer assembly from tank. Pull filter from tank and remove it from the fuel line. Instatl new fuel filter on fuel line; reinstall parts, CHECK MUFFLER BOLTS _ItWARNING: Avoid touching muf- fler unless engine is coM. A hot muf- fler can cause ...

  • Craftsman 358.79731 - page 11

    WARNING: Perform the following steps after each use: •AlIow engine to cool, and secure the unit before storing or transporting. • Store unit and fuel in a welt venti- lated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. • Store unit with all guards in place. Position u ...

  • Craftsman 358.79731 - page 12

    TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing any of the recommended remedies betow other than remedies that re- TROUBLE Engine wiII not start. Engine witl not idle properly Engine will not accelerete, _acks power, or dies under a Ioad. Engine smokes excessively. Engine runs hot quire operation of the ...

  • Craftsman 358.79731 - page 13

    part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part witl be repaired or re- pIaced by Sears. OWNER'S WAR- RANTY RESPONSIBILITIES: As the Iawn and garden equipment engine owner, you are res ...

Manufacturer Craftsman Category Blower

Documents that we receive from a manufacturer of a Craftsman 358.79731 can be divided into several groups. They are, among others:
- Craftsman technical drawings
- 358.79731 manuals
- Craftsman product data sheets
- information booklets
- or energy labels Craftsman 358.79731
All of them are important, but the most important information from the point of view of use of the device are in the user manual Craftsman 358.79731.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Craftsman 358.79731, service manual, brief instructions and user manuals Craftsman 358.79731. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Craftsman 358.79731.

A complete manual for the device Craftsman 358.79731, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Craftsman 358.79731 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Craftsman 358.79731.

A complete Craftsman manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Craftsman 358.79731 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Craftsman 358.79731, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Craftsman 358.79731, that we can find in the current document
3. Tips how to use the basic functions of the device Craftsman 358.79731 - which should help us in our first steps of using Craftsman 358.79731
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Craftsman 358.79731
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Craftsman 358.79731 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Craftsman 358.79731?

Use the form below

If you did not solve your problem by using a manual Craftsman 358.79731, ask a question using the form below. If a user had a similar problem with Craftsman 358.79731 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)