-
Python 1401 - page 1
Remote Start Keyless Entr y Model 1401 Owner’ s Guide © 2008 Directed Electronics, Vista, CA G4102P 2008-09 ...
-
Python 1401 - page 2
...
-
Python 1401 - page 3
Contents Government regulations .....................................................................................5 W arning! Safety first .........................................................................................7 What’ s included ................................................................................................9 ...
-
Python 1401 - page 4
...
-
Python 1401 - page 5
5 © 2008 Directed Electronics. All rights reserved. Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including inter ference that may cause undesirable operatio ...
-
Python 1401 - page 6
6 © 2008 Directed Electronics. All rights reserved. This device complies with the Industr y Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to ser vices authorized by IC. In addit ...
-
Python 1401 - page 7
7 © 2008 Directed Electronics. All rights reserved. W ar ning! Safety first The following safety warnings must be obser ved at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer . When properly installed, this system can start the vehicle via a command signal from ...
-
Python 1401 - page 8
8 © 2008 Directed Electronics. All rights reserved. Use of this product in a manner contrar y to its intended mode of operation may result in property damage, personal injur y , or death. (1) Never remotely start the vehicle with the vehicle in gear , and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have t ...
-
Python 1401 - page 9
9 © 2008 Directed Electronics. All rights reserved. What’ s included T wo five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control center with integrated status LED and V alet override switch • A remote start defeat toggle switch • Window decals • Y our warranty registration • Imp ...
-
Python 1401 - page 10
10 © 2008 Directed Electronics. All rights reserved. ➤ System maintenance The system requires no specific maintenance. Y our remotes are powered by small coin cell lightweight 3-volt lithium batteries that last approximately one year under normal use. The remote uses one CR2032 cell batter y . When the batter y begins to weaken, the operating r ...
-
Python 1401 - page 11
11 © 2008 Directed Electronics. All rights reserved. + + Detail T urn both the unit front and circuit board over , remove batter y from 2. clip and replace. Note: V erify that the battery polarity is correct when replacing. Reposition all parts and snap together . 3. ➤ T wo car operation Y ou can use the remote control system for two cars, with ...
-
Python 1401 - page 12
12 © 2008 Directed Electronics. All rights reserved. 1-way remote 5313 ,&$ )&&,'(=6'(, %$ 77(5 < &5 8 1 2 3 4 5 6 7 6 7 9 1 2 3 4 5 6 531? ...
-
Python 1401 - page 13
13 © 2008 Directed Electronics. All rights reserved. ➤ T ransmitter configuration Button Level Direct Access A U X x 1 A U X x 2 A U X x 3 A U X x 4 A U X Lock Silent Lock A U X Unlock Silent Unlock V alet Mode Car Finder A U X Remote Start Reset Runtime Timer Mode Smart Star t Rear Defogger A U X T runk Release AUX 1 AUX 2 AUX 3 A U X Function ...
-
Python 1401 - page 14
14 © 2008 Directed Electronics. All rights reserved. ➤ Feature list A U X Unlock Command : Press one time to Lock Notes : Press/hold for 1.5 seconds to lock the system and then activate the Panic output* A U X Unlock Command : Press one time to Unlock A U X Remote Start Command : Press one time to activate Remote Start A U X Aux (trunk) Command ...
-
Python 1401 - page 15
15 © 2008 Directed Electronics. All rights reserved. Runtime reset Command : Press A U X one-time and then A U X . Notes : Re-starts the remote star t runtime counter if remote star t is active. . Aux 1 Command : Press A U X one time and then press A U X . Notes : This is an optional feature. See your sales rep/installer for details. V alet mode C ...
-
Python 1401 - page 16
16 © 2008 Directed Electronics. All rights reserved. Smart star t Command : Press A U X three-times and then press A U X . Notes : Enables or disables the Smart Start feature. The parking lights flash fast 5 times when turning the feature on, and flash slowly 5 times when turning the feature off. Aux 3 Command : Press A U X three times and then ...
-
Python 1401 - page 17
17 © 2008 Directed Electronics. All rights reserved. Using the system ➤ Locking the vehicle T o lock the vehicle, press the button on the remote control. The horn in the vehicle “honks” one-time, and the parking lights flash one-time. If the power door locks have been connected, the doors lock. The system automatically checks for errors whe ...
-
Python 1401 - page 18
18 © 2008 Directed Electronics. All rights reserved. ➤ V alet mode Y ou can prevent your system from automatically activating the Failsafe® Star ter Kill. When the system is in V alet mode, the feature is disabled. The doors do not automatically lock. This is useful when washing or having the vehicle ser viced. T o enter or exit valet mode with ...
-
Python 1401 - page 19
19 © 2008 Directed Electronics. All rights reserved. ➤ Remote feature programming The remote control has a menu for programming user features. Before you start make sure the keypad is unlocked. (See page 12) T o program the remote user features: Press and hold the 1. A U X button on the remote for 12 seconds. (ignore the car indicator at 3 secon ...
-
Python 1401 - page 20
20 © 2008 Directed Electronics. All rights reserved. ➤ Overriding the optional starter kill T o bypass the optional star ter kill without a remote control: Use your override switch located on the control center (see diagram below) to bypass the system. This switch bypasses the system only if you have the vehicle key . T o check proper operation: ...
-
Python 1401 - page 21
21 © 2008 Directed Electronics. All rights reserved. Using the remote star t Read this user guide, including the W arnings section at the beginning of this guide before using the remote start . Ensure that the vehicle is parked in an open area, not in a garage. T o use your remote star t to pre-warm or pre-cool your vehicle, remember to set the cl ...
-
Python 1401 - page 22
22 © 2008 Directed Electronics. All rights reserved. ➤ Manual transmission vehicles If the vehicle has manual transmission the proper steps must be followed before leaving the parked vehicle, or the remote start feature is disabled. This process is called MTS, manual transmission start. While the vehicle is running, put the transmission in neutr ...
-
Python 1401 - page 23
23 © 2008 Directed Electronics. All rights reserved. ➤ Timer mode This unit can be programmed to start and run the engine ever y three hours, for a maximum of six cycles. The engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine. Note: This feature works only when the system has bee ...
-
Python 1401 - page 24
24 © 2008 Directed Electronics. All rights reserved. T o exit timer mode without the transmitter: Make sure the remote start system is not operating the engine. 1. T ur n the ignition on. Timer Mode is exited and the parking lights flash 2. slowly four times. Note: The Bitwriter can change the amount of times the remote start activates and, it ca ...
-
Python 1401 - page 25
25 © 2008 Directed Electronics. All rights reserved. T o enter turbo timer mode with a manual transmission: Perform the manual transmission procedure (See p. 22) with the door open. T ransmit the timer mode feature with the remote by pressing two-times, and then press A U X . After exiting the vehicle, lock the system and the vehicle remains runni ...
-
Python 1401 - page 26
26 © 2008 Directed Electronics. All rights reserved. T o activate Smar t Star t mode: Press the • button on the remote 3 times and then press the A U X button. The parking lights flash 5 times fast to confirm the remote is in Smart Star t mode. T o activate Smar t Star t mode with a manual transmission: Enter the MTS procedure. 1. Exit the ...
-
Python 1401 - page 27
27 © 2008 Directed Electronics. All rights reserved. ➤ T urning on the rear defogger The rear defogger (if connected) is programmed to automatically activate when remote start is turned on. If the interior cabin temperature is above 55˚ F the defogger will not activate. T o manually activate the rear defogger after remote star t is on: Press ? ...
-
Python 1401 - page 28
28 © 2008 Directed Electronics. All rights reserved. Safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components. ➤ Optional starter anti-grind circuitr y Whenever the vehicle is remote started, advanced anti-grind circuitr y prevents the ...
-
Python 1401 - page 29
29 © 2008 Directed Electronics. All rights reserved. Diagnostics The microprocessor at the heart of the system is constantly monitoring the switches that are connected to the main unit. ➤ Locking If the system is locked at the same time that the door input is active, you will hear one horn honk to indicate locking, and then a second horn honk to ...
-
Python 1401 - page 30
30 © 2008 Directed Electronics. All rights reserved. Owner recognition Owner recognition lets up to four users of the system have unique settings to meet their specific needs. It is almost like having four separate systems in your vehicle, one for each user . This feature is only available to authorized dealers using the Bitwriter or Bitwriter 2 ...
-
Python 1401 - page 31
31 © 2008 Directed Electronics. All rights reserved. Programming options Y our system has many custom programmable options. Some may require instal- lation labor . Ask your authorized dealer for details. The following is a list of the programmable options, with the factor y settings in Bold . Active • locking (remote only) passive locking, th ...
-
Python 1401 - page 32
32 © 2008 Directed Electronics. All rights reserved. Convenience expansions Listed below are some of the expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Power T runk Release: The accessory output of the system can operate a fac- tor y power release for the vehicle’ s trunk o ...
-
Python 1401 - page 33
33 © 2008 Directed Electronics. All rights reserved. Glossar y of terms Control Center: The control center contains the system’ s radio-frequency antenna, the valet and override switch, and the Status LED. For maximum remote-control range, the Control Center is usually located at the top of the windshield, centered near the rear-view mirror . Co ...
-
Python 1401 - page 34
34 © 2008 Directed Electronics. All rights reserved. ...
-
Python 1401 - page 35
35 © 2008 Directed Electronics. All rights reserved. Quick reference guide Locking • T o lock press for one second. The doors lock. The LED on the control center flashes and the horn honks one time. (if connected). The parking lights flash once to confirm locking. Unlocking • T o unlock press 1 3 4 5 6 2 A U X . The doors unlock, and ...
-
Python 1401 - page 36
36 © 2008 Directed Electronics. All rights reserved. Remote Start • Press . The parking lights turns on (if connected). The vehicle starts and runs for the programmed duration. Rear Defogger • Press four-times, and then press (only after remote start is On.) The parking lights flash 4 times confirming activation of the defogger output. ...
-
Python 1401 - page 37
37 © 2008 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’ s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote tra ...
-
Python 1401 - page 38
38 © 2008 Directed Electronics. All rights reserved. WITHOUT LIMIT A TION, LIABILITY FOR THEFT , DAMAGE AND/OR V ANDALISM. THIS W ARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOV AL OR REINST ALLA TION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOL VING DIRECTED OR ITS SUBSIDIARY , THE VEN ...
-
Python 1401 - page 39
...
-
Python 1401 - page 40
G4102P 2008-09 Vista, CA 92081 www .directed.com © 2008 Directed Electronics—All rights reser ved The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 1 ...
Do you have a question concerning Python 1401?
Use the form below
If you did not solve your problem by using a manual Python 1401, ask a question using the form below. If a user had a similar problem with Python 1401 it is likely that he will want to share the way to solve it.