-
Kidde PI9000CA - page 1
9 V Battery-Operated Dual Sensor Smoke Alarm Photoelectric / Ionization with Hush ® Alarm Manual Model PI9000CA Manual P/N 820-1062 Rev . A SINGLE STATION SMOKE ALARM Ionization sensing alarms may detect invisible fir e particles (associated with fast flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may detect visible ...
-
Kidde PI9000CA - page 2
Introduction . . . . . . . . . . . . . . . . . . . . . . . . 1 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 2–9 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . 9–13 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . 13–14 Fire Safety. . . . . . . . . . . . . . . . . . . . . . . . . . . 15–18 W ...
-
Kidde PI9000CA - page 3
This product is designed to detect products of combustion using both an ionization sensor and a photoelectric sensor . The ionization sensor contains 0.9 microcurie of Americium 241, a radioactive material. Distributed under U.S. NRC License No. 32-23858-01E. Manufactured in compliance with U.S. NRC safety criteria in 10 CFR 32.27. The purchaser is ...
-
Kidde PI9000CA - page 4
Recommended Locations • Locate the first alarm in the immediate area of the bedrooms. T ry to monitor the exit path, as the bedrooms are usually farthest from the exit. If more than one sleeping area exists, locate additional alarms in each sleeping area (Image 1A). • Locate additional alarms to monitor any stairway as stairways act like chimne ...
-
Kidde PI9000CA - page 5
• Install smoke alarms on sloped, peaked or cathedral ceilings at or within 0.9 m (3') of the highest point (measured horizontally). NFP A Standard 72 states: “Smoke alarms in rooms with ceiling slopes greater than 0.3 m in 2.4 m (1' in 8') horizontally shall be located on the high side of the room.” NFP A Standard 72 states: ? ...
-
Kidde PI9000CA - page 6
Locations to Avoid • Do not install within 0.9 m (3') of the following: The door to a kitchen, or a bathroom that contains a tub or shower , forced air supply ducts used for heating or cooling, ceiling or whole house ventilating fans, or other high, air-flow areas. • Do not place the alarm where drapes or other objects will block the senso ...
-
Kidde PI9000CA - page 7
Installation 6 IMAGE 2A IMAGE 2C IMAGE 2B HORIZONT AL DIST ANCE FR OM PEAK CEILING 10 cm (4”) MINIMUM 10 cm (4”) MINIMUM 30.5 cm (12”) MAXIMUM SIDE W ALL BEST PLACEMENT ACCEPT ABLE PLACEMENT NEVER HERE ST AGNANT AIR 10 cm (4”) 0.9 m (3’) 0.9 m (3’) NOT IN THIS AREA ANYWHERE IN THIS AREA 10 cm (4”) NOT IN THIS AREA ANYWHERE IN THIS ARE ...
-
Kidde PI9000CA - page 8
Mobile Homes Modern mobile homes have been designed to be energy efficient. Install smoke alarms as recommended in Recommended Locations and Image 2A. In older mobile homes that are not well-insulated compared to present standards, extreme heat or cold can be transferred from the outside to the inside through poorly insulated walls and roof. This m ...
-
Kidde PI9000CA - page 9
Installation 8 • Install the alarm on the mounting plate and rotate the alarm in the direction of the “ON” arrow on the cover until the alarm ratchets into place (Image 3D). This ratcheting function allows for aesthetic alignment. Note: The alarm will attach to the mounting plate in 4 positions (every 90°). A A IMAGE 3A IMAGE 3C IMAGE 3D “ ...
-
Kidde PI9000CA - page 10
Installation 9 Battery This unit will not function without a properly installed battery. When installing a battery, press the battery reminder tab down into the battery compartment and install the battery (See Image 4A and 4B). For initial installation a pre-installed 9 V battery is included with a battery pull tab that allows for easy connection. ...
-
Kidde PI9000CA - page 11
Operation 10 Hush ® Control Featur e Smoke alarms are designed to minimize nuisance alarms. Cigarette smoke will not normally set off the alar m, unless the smoke is blown directly into the alarm. Combustion particles from cooking may set off the alarm if the alar m is located close to the cooking area. Large quantities of combustible particles ar ...
-
Kidde PI9000CA - page 12
Operation 11 Alarm T amper-Resist Feature This alarm has a tamper-resist feature. This feature will help deter children or others from removing the alarm from the mounting plate. Activate the tamper-resist feature by breaking off the four posts in the square holes in the mounting plate (see Image 5A). Rotate the alarm onto the mounting plate until ...
-
Kidde PI9000CA - page 13
Operation 12 LED Indicators This smoke alarm is equipped with a red LED indicator. The red LED is located under the test button and has several modes of operation. Standby Condition The red LED will flash every 30–40 seconds to indicate that the smoke alarm is operating properly. Alarm Condition When the alarm senses particles of combustion and g ...
-
Kidde PI9000CA - page 14
Operation 13 T esting T est by pushing the Test button on the cover and hold it down for a minimum of 5 seconds. This will sound the alarm if all the electronic circuitry, horn and battery are working. If no alarm sounds, the unit has defective batteries or other failure. DO NOT use an open flame to test your alarm, you could damage the alarm or ig ...
-
Kidde PI9000CA - page 15
Maintenance After installing or changing the battery , reinstall your alarm and test your alarm by using the test button. W ARNING! Use only the batteries specified above. Use of different batteries than the recommended ones, may have a detrimental effect on the smoke alarm. A good safety measure is to replace the battery at least once a year , or ...
-
Kidde PI9000CA - page 16
Fire Safety Limitations of Smoke Alarms W ARNING: Please read carefully and thoroughly . • NFP A 72 states: Life safety from fire in residential occupancies is based primarily on early notification to o cc upants of the need to escape, followed by the appropriate e g r ess actions by those occupants. Fire warning systems for dwelling units are ca ...
-
Kidde PI9000CA - page 17
16 Fire Safety • If the alarm is located outside the bedroom or on a different floor , it may not wake up a sound sleeper. • The use of alcohol or drugs may also impair one’s ability to hear the smoke alarm. For maximum protection, a smoke alarm should be installed in each sleeping area on every level of a home. • Although smoke alarms can ...
-
Kidde PI9000CA - page 18
Fire Safety 17 What T o Do When The Alarm Sounds • Alert small children in the home. • Leave immediately by your escape plan. Every second counts, so don’t waste time getting dressed or picking up valuables. • In leaving, don’t open any inside door without first feeling its surface. If hot, or if you see smoke seeping through cracks, don? ...
-
Kidde PI9000CA - page 19
Additional Recommendations The National Fire Protection Association’s Standard 72 provides the following information: Smoke alarms shall be installed outside each separate sleeping area in the immediate vicinity of the bedrooms and on each additional story of the family living unit, including basements and excluding crawl spaces and unfinished at ...
-
Kidde PI9000CA - page 20
19 If after reviewing this manual you feel that your smoke alarm is defective in any way, do not tamper with the unit. In many cases, the quickest way to exchange your alarm is to return it to the original place of purchase. Alternatively, you may return it for servicing to Kidde. If you have questions, call Kidde Customer Service at 1-800-880-6788 ...
Do you have a question concerning Kidde PI9000CA?
Use the form below
If you did not solve your problem by using a manual Kidde PI9000CA, ask a question using the form below. If a user had a similar problem with Kidde PI9000CA it is likely that he will want to share the way to solve it.