Manual AutoFlo S2020

12 pages 0.72 mb
Download

Go to site of 12

Summary
  • AutoFlo S2020 - page 1

    ELECTRONIC STEAM UNIT - POWER HUMIDIFIER MODELS S2000 AND S2020 FOR GAS OR OIL FORCED AIR FURNACES, HEA T PUM PS A ND ELECTRIC FURNACES The AutoFlo Residential Power Humidifier you have purchased has been designed to be simple to Install, Operate and Maintain. Read this manual before you install the Humidifier. Parts included in the Steam Humidifie ...

  • AutoFlo S2020 - page 2

    SIMPLIFIED INST ALLA TION INSTRUCTIONS DET AILED INST ALLA TION INSTRP4.56603 0.000010000 TD(L)Tj8.5660 0.0000 TD701 I3 IION ...

  • AutoFlo S2020 - page 3

    6. W ATER SUPPL Y - Required Criteria 9. WIRING THE STEAM HUMIDIFIER IMPORT ANT: Dedicated fused circuits of the pr oper voltage and current ratings must be provided. All wiring must conform to local and national codes. 7. M OUNTING THE STEAM HUMIDIFIER 8. STEAM OPERATION A. W ATER SUPPL Y USING THE SADDLE V ALVE FURNISHED WITH UNIT A. INSTALLING A ...

  • AutoFlo S2020 - page 4

    10. SETTING THE HUMIDIST AT Connect field wiring as shown in Figures 5 or 6. It is recommended that humidistat settings of 30-40% not be exceeded. If condensation is noticed on windows during very cold outside temperatures, the humidistat setting should be lowered. 4 RELA TIVE HUMIDITY CHAR T Outside T emperature Outside Relative Humidity Indoor Re ...

  • AutoFlo S2020 - page 5

    11. INITIAL STAR T -UP - SEQUENCE OF OPERATION and SER VICE “LED” INDICAT ORS 12. OPERATING SEQUENCE Once the Steam Humidifier has been installed and the water, humidistat and blower interlock connections completed, the humidifier may be initially started. A. Flush and Turn "ON" the water supply to the steam Humidifier. B. Set the hum ...

  • AutoFlo S2020 - page 6

    14. SERVICE INDICA TORS Seven LED lamps provided on the front panel indicate the functional status of the humidifier as shown in Figure 7 below. 6 A. L. M. N. O. B. C. D. E. F. G. H. I. J. K. Unplug the power cord from the 120 volt source for S2000 (240 volt for S2020) and allow the water to cool for at least 30 minutes prior to removal. Turn off t ...

  • AutoFlo S2020 - page 7

    7 A. G. B. C. D. E. F. The green "Power" light does not blink off and on. 1. The S2000 is not connected to an active 120 V AC 15 Amp power source. (S2020, 240 V AC, 10 AMP). 2. Call the Technical Support Hotline. The "HEATER" LED does not illuminate. 1. The humidistat is not closed, calling for humidity or the humidistat is wire ...

  • AutoFlo S2020 - page 8

    15. SERVICE AND REPLACEMENT P ARTS CONTROLS INC. 385 Highway 33 Englishtown, NJ 07726 www.ew ccontrols.com e-mail: autoflo@ewccontrols.com T el. (800) 446-3110 Fax : (732) 635-8646 8 ITEM 1 120 VOLT HEAT ER AS SEMBL Y 240 VOLT HEAT ER AS SEMBL Y 24 VOL T SOLEN OID VA LV E A SSEMBL Y WA TER LEVEL P ROBE AS SEMBL Y THERMISTOR PROBE A SSEMBL Y CIRCUIT ...

  • AutoFlo S2020 - page 9

    CONTROLS INC. 385 Highway 33 Englishtown, NJ 07726 www.ew ccontrols.com e-mail: autoflo@ewccontrols.com T el. (800) 446-3110 Fax : (732) 635-8646 T ech. (800) 526-4048 FIG. 8 9 DRAIN COCK VAL VE P/N 094020A0055 "T" ADAPTER, 1/4" NPT P/N 094021A0038 OVERFLOW TUBE, .50 ID x 6" LG . P/N 094021A0074 BARBED TEE, 1/4-18 NPT TO 1/2&quo ...

  • AutoFlo S2020 - page 10

    AUTOFLO HUMIDIF IER Z100 ASSEM BLY INSTALLATION INSTRUCTIONS & OWNER'S MANUAL Z100 REPLACEMENT INSTRUCTIONS SUPPLEMENT TO THE AUTOFLO ELECTRONIC STEAM POWER HUMIDIFIERS MODEL # S2000 AND S2020 APPLICA TION NOTE AN 131 The AUTOFLO steam humidifier now comes equipped with a factory installed Z100, which ac ts as a sacrificial metal. P ut sim ...

  • AutoFlo S2020 - page 11

    C E W CONTROLS INC. Excellence W ithout Compromise R APPLICA TION NOTE AN 147 F AN F AILURE SAFETY LOCK-OUT CIRCUIT “Field Provided” EWC Controls Inc. 385 Highway 33 Englishtown, NJ 07726 800-446-31 10 732-446-31 10 F AX 732-446-5362 . . . . . R W G Y TYPICAL THERMOSTAT R W G Y C FURNACE HUMIDISTAT G1 R G2 H H S2000 & S2020 HUMIDIFIER NO NO ...

  • AutoFlo S2020 - page 12

    “S” series AutoFlo Steam Humidifier IMPORT ANT NOTES: EWC Controls Inc. 385 Highway 33 Englishtown, NJ 07726 800-446-31 10 732-446-31 10 F AX 732-446-5362 LOCATION: Installing the steam unit in the attic is NOT recommended. Freezing temperatures, the possibility of flood damage, the possibility of producing an environment where mold can start, ...

Manufacturer AutoFlo Category Humidifier

Documents that we receive from a manufacturer of a AutoFlo S2020 can be divided into several groups. They are, among others:
- AutoFlo technical drawings
- S2020 manuals
- AutoFlo product data sheets
- information booklets
- or energy labels AutoFlo S2020
All of them are important, but the most important information from the point of view of use of the device are in the user manual AutoFlo S2020.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals AutoFlo S2020, service manual, brief instructions and user manuals AutoFlo S2020. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product AutoFlo S2020.

Similar manuals

A complete manual for the device AutoFlo S2020, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use AutoFlo S2020 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of AutoFlo S2020.

A complete AutoFlo manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual AutoFlo S2020 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the AutoFlo S2020, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the AutoFlo S2020, that we can find in the current document
3. Tips how to use the basic functions of the device AutoFlo S2020 - which should help us in our first steps of using AutoFlo S2020
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with AutoFlo S2020
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of AutoFlo S2020 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning AutoFlo S2020?

Use the form below

If you did not solve your problem by using a manual AutoFlo S2020, ask a question using the form below. If a user had a similar problem with AutoFlo S2020 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)