-
Siemens SF24T258EU - page 1
S Operating instructions en 9000 231 454 (9001) ...
-
Siemens SF24T258EU - page 2
20 24 25 26 27 28 29 31 23 22 21 30 ...
-
Siemens SF24T258EU - page 3
en T able of contents Safety inst ructions . . . . . . . . . . . . . . . . . 4 Delivery . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . 4 In daily use . . . . . . . . . . . . . . . . . . . . . 4 Children in the household . . . . . . . . . . 4 Door lock . . . . . . . . . . . . . . . . . . . ...
-
Siemens SF24T258EU - page 4
en 4 Delivery – Check the packaging and dishw asher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier. – Please dispose of the packaging material in an envi ronmen tally friend ly manner. – Do not let children play with packaging and its parts. There is a risk of suffocation from collaps ...
-
Siemens SF24T258EU - page 5
en 5 Damage – The appliance may be repaired and opened up by a technician only. To do this, disconnect the appliance from the power supply. Pull out the mains plug or switch off the fuse. Turn off the tap. Disposal – Make redundant appliances unusa ble to prevent subsequent ac cidents. – Dispose of the appliance in an environmentally friendly ...
-
Siemens SF24T258EU - page 6
en 6 To ensure good washing results, the dishwasher requires soft water , i.e. containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container. Tap water above 7° dH (from set value • : ‹‚ ) must be softened. The water is softened with salt (re generatio n salt) in the water softening system of ...
-
Siemens SF24T258EU - page 7
en 7 Using special salt Always refill with spe cial salt immediate ly before switching on the appliance. This ensures that overrun special salt solution is immediately washed out and does not corrode the rinsing tank. –O p e n t h e s c r e w - t y p e cap of the compartment 1B . – Fill the tank with water (only required when switching on the a ...
-
Siemens SF24T258EU - page 8
en 8 As soon as the rinse-aid re fill indicator X is lit on the fascia, there is still a rinse-aid reserve of 1–2 rinsing processes. Refill with rinse aid. The rinse aid is required for stain-f ree utensils and clear glasses. Use onl y rinse aid for domestic dishwashers. Combined detergents w ith rinse-aid component may be used up to a water hard ...
-
Siemens SF24T258EU - page 9
en 9 Not suitable – Cutlery and utensils made of wood. – Delicate decorative glasses, craft and antique utensils. These decors are not dishwasher-proof. – Plastic parts not resistant to he at. –C o p p e r a n d t i n u t e n s i l s . – Utensils which are soil ed with ash, wax, lubricating grease or ink. Aluminium and silver parts hav e ...
-
Siemens SF24T258EU - page 10
en 10 Pans Bottom basket 1Z Tip Heavily soiled utensils (pans) should be placed in the bottom basket. The more powerful spray jet provides a better dishwashing result. Cutlery basket You should always place cutlery unsorte d with the point s downward s. To prevent injuries, place long, pointed implements and knives on the knife shelf. Knife shelf * ...
-
Siemens SF24T258EU - page 11
en 11 Small accessories holder * * depending on model Light-weight plastic accessories, e.g. cups, lids, etc. can be held sec urely in the smal l accessories holder. Adjusting the height of the bask et * * depending on model If required, the height of the upper utensils basket 1" can be adjusted to provide more space for tall utensils either i ...
-
Siemens SF24T258EU - page 12
en 12 You can use tablets as well as powder or liquid detergents for d ishwashers, but never use washing up liquid. The dosage can be individually ad justed with powder or a liquid detergent according to the degree of soiling. Tablets contain an adequately large amount of active ingredients for all clea ning tasks. Modern, powerful detergen ts pred ...
-
Siemens SF24T258EU - page 13
en 13 Combination detergent Apart from conventional deterge nts (Solo), a number of products are offered with additional functions. These products contain not only the detergent but also rinse-aid and salt replacement substance s (3in1) and, depending on the c ombination (4in1, 5in1, etc.), ad ditional components such as glass protection or stainle ...
-
Siemens SF24T258EU - page 14
en 14 The max. possible number of programmes is illu strated in this ov erview. The correspondi ng programmes and their arrangemen t can be found on the fascia. Programme selection You can select a suitable progra mme according to the type of utensils and degree of soiling. Information f or test institut es Test institutes can request the condition ...
-
Siemens SF24T258EU - page 15
en 15 * depending on model Additional options can be set with the buttons H . Ÿ Express W ash * The >>Express Wash<< function can reduce the running time by approx. 20% to 50% depending on the selected rinse programme. The change in the running time is indicated on the digital display 8 . To obtain optimum cleaning results at a reduced ...
-
Siemens SF24T258EU - page 16
en 16 Remaining running time displa y When the programme is selected, th e remaining running time of the programme is indicated on th e digital display 8 . The running time is determined during the programme by the water tem perature, the number of utensils as well as the degre e of soiling and may vary (depending on the selected programme). Timer ...
-
Siemens SF24T258EU - page 17
en 17 Intensiv e drying The final rinse uses a higher tempe rature which improves the drying result. The running time may increase slightly. (Caution if utensils are delicate!) – Close the door. – Hold down programme button # and press main switch ( until the digital display illuminates. – Release both buttons. The LED for button # flashes an ...
-
Siemens SF24T258EU - page 18
en 18 Filters The filters 1J keep large foreign objects in the rinsing water away from the pump. Th ese foreign obje cts may occasionally block the filters. – After each wash cycle check th e filters for residue and clean if required. – After unscrewing the coarse microfilter, you can take out the fil ter group. – Remove any residue and clean ...
-
Siemens SF24T258EU - page 19
en 19 W aste water pump Large food remnants in the rinsing water not retained by the filters may block the waste water p ump. The rinsing water is then not pumped out an d covers the filter. In this case: – First disconnect the appliance from the power supply. – Remove the fil ters 1J . – Scoop out water, use a sponge if required. – Loosen ...
-
Siemens SF24T258EU - page 20
en 20 “Check water supply ” display ` lights up. – Tap turned off. – Water supply interrupted. – Supply hose ki nked. – Filter in the wate r supply blocked. – Switch off the ap pliance and pull out the mains plug. – Turn off the tap. – Clean filter in the supply hose. – Reconnect power supp ly. – Turn on the tap. – Switch on ...
-
Siemens SF24T258EU - page 21
en 21 White stains on the utensils/glasses remain milky . If phosphate-free detergents are used with hard tap water, white deposits may be deposited more easily on utensils and the container walls. – Too little/unsuita ble detergent. – Too weak programme selected. – No/too little rinse aid. – No/too little special salt. – Water softening ...
-
Siemens SF24T258EU - page 22
en 22 The dishwasher must be connected correctly, otherwise it will not function properly. The specifications for t he inlet and outlet as well as the ele ctrical connected loads must correspond with the required criteria as specified in the following paragraphs or in the installation instructions. Install the appliance in the c orrect sequence: ? ...
-
Siemens SF24T258EU - page 23
en 23 T echnical specif ications Wei g h t : max. 53 kg V oltag e: 230 V, 50 Hz Connected load: 2,3 kW Fus e : 10/13 A Wa ter pressur e: at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar). At a higher water pressure: connect pressure-reducing valve ahead. Inlet rate: minimum 10 litres/minute W ater temperatur e: cold water; hot wate r max. tempera ...
-
Siemens SF24T258EU - page 24
en 24 Electrical connection – Connect the appliance onl y to 230 V and 50 Hz alternating current via a correctly installed socket with protective conductor. See rating plate for required fusing 9* . – The socket must be near the appliance and freely accessible following installation. – The connection may be modified by technicians only. – A ...
-
Siemens SF24T258EU - page 25
en 25 Both the packaging of new appliances and the old appliances themsel ves contain valuable raw material s and recyclable materials. Please dispose of the individual parts separated according to type. Please ask your dealer or inquire at your local authority about current means of disposal. Packaging All plastic parts of the applia nce are ident ...
-
Siemens SF24T258EU - page 26
...
-
Siemens SF24T258EU - page 27
Childproof lock (door lock) * 40 Activate the childproof lock. 41 Open the door with activated childproof lock. 42 Deactivate childproof lock. Always close the appliance door completely when you leave the appliance. This is the only way you can protect your children from potential dangers. Baking sheet spray head * Large sheets or grilles and plate ...
-
Siemens SF24T258EU - page 28
If your appliance is fitted with Aqua-Stop, you can leave your appliance unattended during operation and leave the tap turned on afterwards. The tap should only be turned off if you are absent from home for a prolonged period, e.g. several weeks holiday. A prerequisite for the warranty claim is that the appliance has been correctly installed and co ...
Do you have a question concerning Siemens SF24T258EU?
Use the form below
If you did not solve your problem by using a manual Siemens SF24T258EU, ask a question using the form below. If a user had a similar problem with Siemens SF24T258EU it is likely that he will want to share the way to solve it.