English dropdown-ico

Manual Henny Penny HCS-5

26 pages 1.01 mb
Download

Go to site of 26

Summary
  • Henny Penny HCS-5 - page 1

    Henny Penny Humidified Counter W armer Model HCW -2 Model HCS-2 Model HCW -3 Model HCW -5 Model HCS-5 Model HCW -8 OPERA T OR’S MANUAL ...

  • Henny Penny HCS-5 - page 2

    ...

  • Henny Penny HCS-5 - page 3

    Model HCS-2/HCW-3/HCW-5/HCW-8 FM05-019-F Revised 02-14-07 LIMITED W ARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT : Any part of a new appliance, except baskets, lamps, ...

  • Henny Penny HCS-5 - page 4

    Model HCS-2/HCW-3/HCW-5/HCW-8 T ABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1 - 1 1-1. Heated Display Cabinet ....................................................................................... 1 - 1 1-2. Features .................. ...

  • Henny Penny HCS-5 - page 5

    Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 1. INTRODUCTION 1-1. HEA TED DISPLA Y The Henny Penny Heated Display Cabinet is a basic unit of food CABINET processing equipment used to display the food product and maintain the temperature of hot foods in the commercial food service operation. This highly efficient, quality-built cabinet will keep hot foods ...

  • Henny Penny HCS-5 - page 6

    Model HCS-2/HCW-3/HCW-5/HCW-8 1-5. SAFETY The only way to ensure safe operation of the Henny Penny Heated Display Cabinet is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importanc ...

  • Henny Penny HCS-5 - page 7

    Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 2. INST ALLA TION 2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Display Cabinet. Installation of this unit should be performed only by a qualified service technician. Do not puncture the skin of the unit with drills or screws as component damage or electrical s ...

  • Henny Penny HCS-5 - page 8

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-2. UNP ACKING (Continued) 2. Open top flaps and remove packing. 3. Lift carton off skid. 4. Remove four bolts from under skid. The unit is now ready for location and set-up. 2-2 103 Step 2 Step 3 Step 4 ...

  • Henny Penny HCS-5 - page 9

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-3. LOCA TION Place the unit on a table, preferably with a cut-out opening below the cabinet to allow easy service connections and serviceability . When setting up the Henny Penny Heated Display Cabinet, be sure to level the table. The unit has built-in draining capabilities, but this becomes ineffective when set on a ...

  • Henny Penny HCS-5 - page 10

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-5. DRAIN CONNECTION The drain can be connected to a 1 inch N.P .T . directly below the water well or to a 3/4 inch N.P .T . from the operator ’ s side. W e recommend the 1 inch N.P .T . connection as this will allow straight down draining of the water . 2-6. ELECTRIC CONNECTION The heated display cabinet is availab ...

  • Henny Penny HCS-5 - page 11

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-6. ELECTRICAL CONNECTION The electrical power can be connected from the bottom or from the (Continued) operator ’ s side. There is a 1-3/32 inch diameter hole for either connection. Again, we recommend the bottom connection as this will give a cleaner appearance to the unit. Please observe the electrical connection ...

  • Henny Penny HCS-5 - page 12

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-8. W A TER SUPPL Y CONNECTION (Continued) This unit as manufactured requires the installation of an appropriate back-siphoning device (as per National Plumbing Code ASA-A40.8-1955) to be connected to the water inlet line. This device to be connected in accordance to the basic plumbing code of the Building Officials a ...

  • Henny Penny HCS-5 - page 13

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS 1006 2-7 Model HCS-2 Model HCW-3 ...

  • Henny Penny HCS-5 - page 14

    Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS (Continued) 2-8 1006 Model HCW-5 ...

  • Henny Penny HCS-5 - page 15

    Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 3. OPERA TING INSTRUCTIONS 3-1. INTRODUCTION This section provides operating procedures for the heated display cabinets. The Introduction, Installation and Operation sections should be read, and all instructions should be followed before operating the cabinet. 3-2. OPERA TING CONTROLS Figures 3-1 through 3-12 i ...

  • Henny Penny HCS-5 - page 16

    Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERA TING CONTROLS (Continued) 3-2 1 03 Figure 3-1 Figure 3-2 Figure 3-3 Figure 3-4 Figure 3-5 Figure 3-6 ...

  • Henny Penny HCS-5 - page 17

    Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERA TING CONTROLS (Continued) 103 3 - 3 Figure 3-7 Figure 3-8 Figure 3-9 Figure 3-10 Figure 3-1 1 Figure 3-12 ...

  • Henny Penny HCS-5 - page 18

    Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3- 1 1 W ater V alve An electrical solenoid valve energized by the float switch or the water control switch (in manual position) that allows water to flow into the water pan 3- 1 2 W ater Strainer A filter to prevent particles plugging the water valve 3- 1 3 Contactor The relay th ...

  • Henny Penny HCS-5 - page 19

    Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3-10 13 W ater Control A three-position switch with center position being OFF; Switch i n the position marked AUTOMA TIC (up), the water level in the unit will be controlled by the float switch; in the position marked MANUAL (down), the water valve is opened directly by the switch ...

  • Henny Penny HCS-5 - page 20

    Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3 - 11 2 2 Float Switch An electro-mechanical sensing device used to automati- cally control the water level in the water pan; the float switch can be inactivated by the water control switch; the float switch illuminates the low water light when it senses a low water condition 3-1 ...

  • Henny Penny HCS-5 - page 21

    Model HCS-2/HCW-3/HCW-5/HCW-8 4. Install the perforated bun pans over the water well. This will help in a more rapid heat up of the water . 5. Close the doors. 6. Turn the power switch to the ON position. 7. T urn the light switch to the ON position. 8. Turn the radiant heat switch to the desired setting. W e recommend starting at “6” for the l ...

  • Henny Penny HCS-5 - page 22

    Model HCS-2/HCW-3/HCW-5/HCW-8 3-5. SHUT -DOWN AND 1. T urn the water thermostat to OFF . CLEANUP 2. T urn the radiant heat to OFF . 3. T urn the water control switch to OFF . 4. Open the doors. 5. Remove all the pans. 6. Remove the drain standpipe. 7. Remove the grids from the water pan and clean with soap and water at sink. 8. If cleaning a five-p ...

  • Henny Penny HCS-5 - page 23

    Model HCS-2/HCW-3/HCW-5/HCW-8 4-1. TROUBLESHOOTING GUIDE Product not • Doors are not kept closed • Keep doors closed when holding possible temperature • Product held too long • Only hold product for recommended times • W ater temperature too low • T urn to higher setting • Radiant heat too low • T urn to higher setting • Light bul ...

  • Henny Penny HCS-5 - page 24

    Model HCS-2/HCW-3/HCW-5/HCW-8 G L O S S A R Y HENNY PENNY HOLDING CABINETS air temperature probe a round device located inside the cabinet that measures the inside air temperature and sends that information to the control panel concentration ring assembly a metal assembly located in the water pan in the bottom of the unit that helps keep an even hu ...

  • Henny Penny HCS-5 - page 25

    Model HCS-2/HCW-3/HCW-5/HCW-8 probe clip a metal holder that attaches to the outside of the control panel to hold the food probe when not in use; the clip is an optional accessory product load capacity the highest recommended number of pounds/kilograms of food product that can be safely held in the cabinet proof function a program used for allowing ...

  • Henny Penny HCS-5 - page 26

    *FM0 5 - 0 19 - F * Henny Penny Corp., Eaton, Ohio 4532 0, R evised 02-14-07 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax www.hennype nny.com ...

Manufacturer Henny Penny Category Food Warmer

Documents that we receive from a manufacturer of a Henny Penny HCS-5 can be divided into several groups. They are, among others:
- Henny Penny technical drawings
- HCS-5 manuals
- Henny Penny product data sheets
- information booklets
- or energy labels Henny Penny HCS-5
All of them are important, but the most important information from the point of view of use of the device are in the user manual Henny Penny HCS-5.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Henny Penny HCS-5, service manual, brief instructions and user manuals Henny Penny HCS-5. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Henny Penny HCS-5.

Similar manuals

A complete manual for the device Henny Penny HCS-5, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Henny Penny HCS-5 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Henny Penny HCS-5.

A complete Henny Penny manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Henny Penny HCS-5 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Henny Penny HCS-5, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Henny Penny HCS-5, that we can find in the current document
3. Tips how to use the basic functions of the device Henny Penny HCS-5 - which should help us in our first steps of using Henny Penny HCS-5
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Henny Penny HCS-5
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Henny Penny HCS-5 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Henny Penny HCS-5?

Use the form below

If you did not solve your problem by using a manual Henny Penny HCS-5, ask a question using the form below. If a user had a similar problem with Henny Penny HCS-5 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)