Manual BTC BCO4016IM

22 pages 0.59 mb
Download

Go to site of 22

Summary
  • BTC BCO4016IM - page 1

    Combo Drive CD-R 40X/CD-RW 12X/DVD 16X User’s Manual ...

  • BTC BCO4016IM - page 2

    CLASS 1 LA SER PRODUCT APPA REIL A LA SER DE CLASSE 1 LASER KLA SSE 1 LUOKAN 1 LA SERLAITE PRODUIT LASER CATEGORIE 1 DANGER INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO BEAM VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN A TTENTION RADIATION DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE. E ...

  • BTC BCO4016IM - page 3

    FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC Warning Statement This equipment has been teste ...

  • BTC BCO4016IM - page 4

    Table of Contents INTRODUCTION 1 F EATURES 1 S YSTEM R EQUIREMENTS 2 P ACKAGE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWARE I NSTALLATION 4 D RIVER I NSTALLATION 5 S OFTWARE D ESCRIPTION 6 DVD R EGION C ODING 6 OPERATION & CONNECTION 8 F RONT P ANEL 8 R EAR V IEW 9 TECHNICAL DATA 11 TROUBLESHOOTING 13 ...

  • BTC BCO4016IM - page 5

    COMBO DRIVE 1 INTRODUCTION Features Welcome to a multimedia world of CD-ReWritable technology and DVD-ROM capabilities. This high-performance combo drive combines CD-RW and DVD- ROM in one single drive which frees up precious bay space and presents you abundant function. It reads CDs of a ll types at maximum 40X speed, and DVD-ROMs at 16X speed max ...

  • BTC BCO4016IM - page 6

    COMBO DRIVE System Requirements For IBM compatible PCs, the sy stem requirements recommended are as follows: ♦ PC sufficient to run Windows 95/98/Me or WindowsNT/2000/XP ♦ Pentium II 300MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 150MB for installation, 1GB or more is recommended.) ♦ IDE host interf ...

  • BTC BCO4016IM - page 7

    COMBO DRIVE 3 INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices , but it is recommended that you separate IDE ports for your hard driv e and your Combo drive. This will ensure that your hard drive? ...

  • BTC BCO4016IM - page 8

    COMBO DRIVE MAST ER CSEL SLAVE JUMPER Improper or conflicting setting will cause the unit not be detected by your system. Hardware Installation 1. Turn off the power to your computer system and all peripheral devices. 2. Disconnect all cables and connectors from the back of your computer, and then remove the cover from the computer. 3. Insert the C ...

  • BTC BCO4016IM - page 9

    COMBO DRIVE 5. If you have a sound card that can be connected to this drive, you can also connect the drive (as Audio-Out) and the sound card (as Audio-in) with a 4-pin audio cable. If your mainboad is integrated with built-in sound system, plug the 4-pin audio cable into the CD-IN connector on the mainboard as Audio-in. 6. Re-attach the cover of t ...

  • BTC BCO4016IM - page 10

    COMBO DRIVE 6 Software Description Burning Software The bundled mastering software gives you the complete solution for making audio/data CDs right from your desktop. It allows you to copy files from your computer to a reco rdable compact disc. In addition, the audio CDs you create can be played in your home or car CD player. For the CD-RW media, yo ...

  • BTC BCO4016IM - page 11

    COMBO DRIVE 7 systems with DVD-Video capability. You can only play DVD-Video discs with the same region code as your DVD-Video Playback system. As for DVD-ROM drives, one kind of the DVD-Video Playback system, there are 2 types: RPC Phase 1 (as RPC1) : RPC1 drives do not have built-in hardware support for region management. DVD-ROM drives of this k ...

  • BTC BCO4016IM - page 12

    COMBO DRIVE 8 OPERATION & CONNECTION Front Panel 1. Headphone Jack By plugging in the stereo mini jack here, you can listen to an audio disc directly playing from the drive with headphones. 2. Headphone Volume Control This rotary knob adjusts the volume level of the headphone output. Turning the wheel to the right will increase the audio volume ...

  • BTC BCO4016IM - page 13

    COMBO DRIVE 4. Disc Tray This is the tray for the disc. Plac e the disc in the tray, then press the Close/Eject button or gently push the tray to close it. 5. Emergency Eject Hole When the Eject/Close button can’t wo rk properly and the disc tray can’t be opened, you can insert a paper clip or other small rod into this hole for manual ejection. ...

  • BTC BCO4016IM - page 14

    COMBO DRIVE 10 2. Analog Audio Output Connector This connector allows you to connect the drive to your sound card with a 4-pin audio cable. 3. Device Configuration Jumper Set the jumper to Master, Slave or Cable Select according to your system configuration. 4. IDE Interface Connector Plug one end of the 40-pin IDE cable here to join the 40-pin IDE ...

  • BTC BCO4016IM - page 15

    COMBO DRIVE 11 TECHNICAL DATA Performance Transfer rate Read: CD: 6000kb/sec (up to 40X) DVD: 21632kb/sec (up to 16X) Write: CD-R: 6000kb/sec (up to 40X) CD-RW: 1800kb/sec (up to 12X) Data buffer 2MB Writing modes TAO (Track at once), DAO (Disc at Once), SAO (Session at once), Multi-session, Incremental Packet Writing (fixed and variable packet siz ...

  • BTC BCO4016IM - page 16

    COMBO DRIVE 12 Compact Disc Disc Size 80mm and 120mm discs Disc Data Capacity DVD-ROM: Single layer – 4.7GB Dual layer – 8.5GB (one side) CD-ROM: 74min – 650MB – Mode 1 80min – 700MB – Mode 1 Disc Format Supported Write Read CD-DA   CD-ROM   CD-ROM XA   CD-EXTRA   Video CD   Photo CD   CD-I   CD ...

  • BTC BCO4016IM - page 17

    COMBO DRIVE 13 TROUBLESHOOTING To help you get more familiar with t he Combo Drive, the following FAQ lists some common problems you might encounter. Please read it for reference before you request RMA support from your dealer. Q1. The drive cannot be recognized. (1) It’s possible the drive hasn’t been connected properly. Please check whether t ...

  • BTC BCO4016IM - page 18

    COMBO DRIVE 14 (2) Check both rear side of the drive and sound card on M/B (If Audio chipset is on board). If they are well connect ed, check if the sound card is working. Q5. The drive can’t read former session(s) of the CD-R disc w hich has been w ritten tw ice or more times. Before writing CD-R discs with data copy, remember to choose “Impor ...

  • BTC BCO4016IM - page 19

    COMBO DRIVE 15 (1) Use the burning software which is provided by original supplier and bundled with this Combo Drive or download the updated file from internet. (2) More capacity of hard disk is needed if using hard disk as temporary buffer. (3) Place the disc correctly. (4) The blank disc needs full format first if using packet writing software. Q ...

  • BTC BCO4016IM - page 20

    COMBO DRIVE 16 Yes, it does support CD-Text & SAO f unction and you may edit the title or content into your music CD. ...

  • BTC BCO4016IM - page 21

    ...

  • BTC BCO4016IM - page 22

    3100550910 Version 1.1 Jan. 2003 ...

Manufacturer BTC Category CD Drives

Documents that we receive from a manufacturer of a BTC BCO4016IM can be divided into several groups. They are, among others:
- BTC technical drawings
- BCO4016IM manuals
- BTC product data sheets
- information booklets
- or energy labels BTC BCO4016IM
All of them are important, but the most important information from the point of view of use of the device are in the user manual BTC BCO4016IM.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals BTC BCO4016IM, service manual, brief instructions and user manuals BTC BCO4016IM. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product BTC BCO4016IM.

Similar manuals

A complete manual for the device BTC BCO4016IM, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use BTC BCO4016IM by users. Manuals are usually written by a technical writer, but in a language understandable to all users of BTC BCO4016IM.

A complete BTC manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual BTC BCO4016IM - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the BTC BCO4016IM, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the BTC BCO4016IM, that we can find in the current document
3. Tips how to use the basic functions of the device BTC BCO4016IM - which should help us in our first steps of using BTC BCO4016IM
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with BTC BCO4016IM
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of BTC BCO4016IM in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning BTC BCO4016IM?

Use the form below

If you did not solve your problem by using a manual BTC BCO4016IM, ask a question using the form below. If a user had a similar problem with BTC BCO4016IM it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)