-
Crimestopper Security Products CS-2014TW2 - page 1
CS - 2014 TW2 Super Page V™ 2 - Way AM/ FM LCD Paging Alarm & Remote Engine Starting System OPERATION INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of the SuperPage V ™ by Crimestopper Security Products Inc. This booklet contains the info rmation necessary for operating your system. If any questions arise, contact your installati ...
-
Crimestopper Security Products CS-2014TW2 - page 2
TABLE OF CONTENTS Operation Cautions & Warnings……..…………..……………………………………………………………………2 Transceiver / Pager - Remote……….....…………..…………… ………………………………………………………3 CS - 416TW Sidekick Remote Control…………………….? ...
-
Crimestopper Security Products CS-2014TW2 - page 3
#2 DISARM UNLOCK LCD SCREEN #4 ENGINE START/STOP #1 ARM LOCK #3 TRUNK #5 RECALL CAR I or II FIXED ANTENNA AM BUTTON 5 (On side of remote): • Press and release to light up the LCD screen. • Press and release twice to recall the last message from the LCD screen. • Press and Hold two seconds to change from Car 1 to Car 2 • Press 5 times to cha ...
-
Crimestopper Security Products CS-2014TW2 - page 4
CrimeStopper #3 #1 #2 #4 LOCK/ TRUNK REMOTE UNLOCK/ VEHICLE 2 FLASHLIGHT START #5 #6 ARM DISARM CS - 416TW SIDEK ICK REMOTE The CS - 416TW 1 - Way sidekick remote adds flexibility to your CS - 2014 TW2 . You can have the convenience of operating your system without needing to carry the larger pager remote. The Sidekick remote has less range and off ...
-
Crimestopper Security Products CS-2014TW2 - page 5
ARM - LOCK OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press button #1 (Lock symbol) on the transceiver. The System will arm emit one siren chirp, one light flash, an d the LED will begin to flash. Power locks will lock (if equipped). S tarter disable circuit will turn on. LCD Pager will beep once while displaying a Lock ing symbol . Af ...
-
Crimestopper Security Products CS-2014TW2 - page 6
SILENT ARM SILENT DIS ARM PANIC MODE All Icons Flash OPERATING INSTRUCTIONS - ALARM Disarming While Tripped (Triggered): Disarming the System while it is triggering requires TWO presses of the #2 U nlock Button. The first press of Button #2 Resets the alarm cycle only (system still armed) while a second press will disarm/unlock the system . Selecti ...
-
Crimestopper Security Products CS-2014TW2 - page 7
PRE - WARN TRUNK POP OPERATING INSTRUCTIONS - ALARM Pre - Warning Shock Protect ion The Pre - warning (warn - away) feature will activate when a low - level shock or vibration detected by the system’s shock sensor. The alarm will chirp the siren 5 times and flash the lights once to help deter any further tampering with the vehicle. T he pa ger/re ...
-
Crimestopper Security Products CS-2014TW2 - page 8
VALET MODE VALET PARK OPERATING INSTRUCTIONS - ALARM Emergency Override (Disarm) If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to disarm the system manually. Open the door with the key [alarm will sound], turn the ignition on, and press the override/program button for about 5 seconds. The ...
-
Crimestopper Security Products CS-2014TW2 - page 9
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START 1) Press remote start button on the remote transmitter. System will chirp 3 times for audible confirmation. (Chirps can be programmed on or off - See installation manual.) 2) Parking lights flash once, then turn on solid, Ignition/Ac cessory circuits turn on. 3) After a few seconds, St ...
-
Crimestopper Security Products CS-2014TW2 - page 10
REMOTE ENGINE CONTROL UNSUCCESSFUL REMOTE START In the ev ent that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For hard starting engines, the unit will allow a starter crank time of up to13 seconds maximum. This should provide ample cranking time ...
-
Crimestopper Security Products CS-2014TW2 - page 11
REMOTE ENGINE CONTROL IDLE DOWN MODE (TAKE - OVER OPERATION) This mode allows the unit to take over operation of your idling, parked vehicle while the ignition key is removed and you exit the vehicle. The vehicle is put into a remote running condition before you exit and it will remain running for the programmed run time, until you return, or until ...
-
Crimestopper Security Products CS-2014TW2 - page 12
REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self - start every 4 hours and run for the programmed run tim e. This can be helpful during extremely cold conditions where engine or fluid freeze - up is a concern. !!THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA!! TIMED SELF - START MODE – EX ...
-
Crimestopper Security Products CS-2014TW2 - page 13
ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 2 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the beginni ...
-
Crimestopper Security Products CS-2014TW2 - page 14
LED DIAGNOSTICS The CS - 201 4 FM system includes disarm diagnostics, through the RED LED light, that will help in determining what caused the last trigger of the alarm system. This is a valuable tool in determining how the vehi cle was tampered with or if there is a false alarm problem in which case you can make the necessary adjustments to correc ...
-
Crimestopper Security Products CS-2014TW2 - page 15
TRANSCEIVER / REMOTE CONTROL PROGRAMMING IGN OFF WAIT FOR 4 FLASHES PRESS 4X's FLASH 2, 3, or 4 X's (BLUE WIRE GROUNDED) 2-WAY SYSTEMS & IGN OFF PRESS TOGETHER LOCK & UNLOCK "SideKick" REMOTES COMPLETE 15 ...
-
Crimestopper Security Products CS-2014TW2 - page 16
CrimeStopper Press & release side button, then you have 4 seconds to control vehicle #2. Press & hold side button for 2 seconds. The remote will beep and "2" icon will appear on LCD screen. "Sidekick" VEHICLE #2 CONTROL: Remote FIXED ANTENNA LED Flashes 2 VEHICLE OPERATION 2 VEHICLE CONTROL Your CS - 2014 FM remotes have ...
-
Crimestopper Security Products CS-2014TW2 - page 17
TROUBLESHOOTING FAQ’s: “B EFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following section for tips that may remedy or explain your problem. RANGE QUESTIONS (2 - Way Pager/Remote): Your CS - 2014 FM system uses FM High - Frequency signals to send/receive d ata between the pager and the vehicle and from the vehicl ...
-
Crimestopper Security Products CS-2014TW2 - page 18
TROUBLESHOOTING continued SYSTEM IS NOT SUCCESSFUL AT REMOTE STARTING DURING EXTREME COLD CONDITIONS: Please be aware that during sub - freezing conditions your remote starter may take more that one attempt to start, or it may not successfully start the vehicle after 3 attempts. During these conditions, the vehicle may not pr operly start even usin ...
-
Crimestopper Security Products CS-2014TW2 - page 19
LOW BATTERY LOW BATTERY WARNING - LCD REMOTE Your 2 - Way pager remote will warn you when the batter y gets low. You will see a battery icon on the LCD screen when it is time to replace the AAA battery. To replace the battery : simply unlatch and slide open the battery door on the back of the 2 - Way LCD remote. Carefully insert a new battery, usin ...
-
Crimestopper Security Products CS-2014TW2 - page 20
Crimestopper Security Products Inc. 1770 So. Tapo Street Simi Valley , CA 93063 (800) 998 - 6880 www.crimestopper.com email@crimestopper.com ©200 5 Crimestopper Security Products ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb03.html ...
Do you have a question concerning Crimestopper Security Products CS-2014TW2?
Use the form below
If you did not solve your problem by using a manual Crimestopper Security Products CS-2014TW2, ask a question using the form below. If a user had a similar problem with Crimestopper Security Products CS-2014TW2 it is likely that he will want to share the way to solve it.