-
Hoover HFI 5 G10 - page 1
User instructions EN HFI 5G10 DISHWASHER ® ...
-
Hoover HFI 5 G10 - page 2
3 CONTENTS Safety advice Setting up, installation Wa ter softener unit Loading the salt Adjusting the upper basket Loading the dishes Information for test laboratories Loading the detergent T ypes of detergent Loading the rinse aid Cleaning the filters Some practical hints Routine cleaning and maintenance Description of the control panel T echnical ...
-
Hoover HFI 5 G10 - page 3
4 Fuses and plugs This appliance should be used only on a socket with a minimum rating of 13 Amp. Our ready-fitted plug is already equipped with a 13 amp fuse which is BS 1362 AST A approved. Any replacement should be exactly the same. If the fuse cover is lost, do not use the plug until it is replaced. A correct replacement fuse cover (obtainable ...
-
Hoover HFI 5 G10 - page 4
W ater connection IMPORT ANT The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. ■ Th e inlet and drain hoses can be directed to left or right. IMPORT ANT The dishwasher can be connected to either cold or hot water , as long as it is no hotter than 60 °C. ■ W ater pressure must be bet ...
-
Hoover HFI 5 G10 - page 5
LOADING THE SAL T ■ On the bottom of the machine there is a container for the salt for regenerating the softener . ■ It is important to use only a salt that is specifically designed for dishwasher . Ot h er types of salt contain small quantities of insoluble particles which over a long p eriod of time may affect and deteriorate the softener per ...
-
Hoover HFI 5 G10 - page 6
11 10 1 3 a b a b 2 ADJUSTMENT OF THE UPPER BASKET If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1. Pull out the upper basket; 2. Then grasp the basket from both sides and lift it upwards (fig. 1) . Dishes that are bigger than 2 ...
-
Hoover HFI 5 G10 - page 7
13 12 ■ The lower basket is fitted with a special adjustable central rack (fig. 3 and 4) . This permits stable and optimum loading, even when the size and/or shape of the dishes is non-standard. - POSITION “A” : for a standard load, or one that excludes pans, salad bowls and the like. - POSITION “B” : for dishes which, although standard s ...
-
Hoover HFI 5 G10 - page 8
15 LOADING THE DETERGENT The detergent IMPORT ANT It is essential to use a detergent that is specifically designed for dishwashers either in powder , liquid or tablet form. “FINISH” gives very good results and can be easily obtained. Unsuitable detergents (like those for washing up by hand) do not contain the proper ingredients for use in a dis ...
-
Hoover HFI 5 G10 - page 9
17 1 2 3 CLEANING THE FIL TERS The filter system (fig.A “4”) consists of: a central container that traps the larger particles; a flat gauze that continuously filters the wash water; a micro filter , located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. ■ To achieve excellent results every time, the filters shou ...
-
Hoover HFI 5 G10 - page 10
19 WHEN CYCLE IS FINISHED After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the of f position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. do an empty wash with detergent in order to clean the machine of any deposits; 2. pull o ...
-
Hoover HFI 5 G10 - page 11
21 PROGRAMME SELECTION AND SPECIAL FUNCTIONS (Use in conjunction with programme guide) IMPORT ANT T he dishwasher has two very practical functions: - the "recommended" programme (which is ideal for full load daily use) for quick and accurate selection; - the "Auto’ Memory", function saves any programme used at least 3 times co ...
-
Hoover HFI 5 G10 - page 12
23 "DELA Y ST ART" button Dishwasher start time can be set with this button, delaying start from 1 to 23 hours. Proceed as follows to set a delayed start: ■ Press the "DELA Y ST ART" button ( "00" will appear on the display). ■ Press the button again to increase the delay in hours (each time the button is pressed t ...
-
Hoover HFI 5 G10 - page 13
25 THE W A TERBLOCK SYSTEM Fig. 1 A The waterblock system has been designed to improve the safety of your appliance, particularly when the machine is left unattended. The waterblock system actually prevents flooding which might be caused by a machine ma lf un cti on or as a result of a fracture on the pipes. How does waterblock work The sump locate ...
-
Hoover HFI 5 G10 - page 14
27 55°C/ 65°C 80/ 100 • •• • 1 10/ 125 YES • •• • YES • •• • 59 70°C • • •• • 150 45°C • •• • YES 29 5 • ** WITH HOT WA TER THE TIME REMAINING UNTIL THE END OF THE PROGRAMME IS AUTOMA TICALL Y DISPLA YED WHILE THE PROGRAMME IS RUNNING. N/A = OPTION NOT A V AILABLE • • 26 Programme Description PROG ...
-
Hoover HFI 5 G10 - page 15
29 IDENTIFYING MINOR F AUL TS Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: 28 F AUL T CAUSE REMEDY 1 - Machine completely dead 2 - Machine does not draw water 3 - Machine does not discharge water 4 - Machine discharges water continuously 5 - Spray arms are not heard to rotate 6 - On electro ...
-
Hoover HFI 5 G10 - page 16
Hoover guarantees all parts of this product for 5 years fr om the date of purchase. During that time Hoover will r eplace or r epair all defective parts fr ee of charge, except for parts subject to fair wear and tear such as belts. The call out fee and labour costs are chargeable after the first 12 months. T o qualify for benefits under the guarant ...
-
Hoover HFI 5 G10 - page 17
08.10 - 41029442 - www .graficaestampa.it - Printed in Italy - Imprimé en Italie EN 08705-400600 HOOVER SER VICE FOR YOUR LOCAL ENGINEER PLEASE CALL OUR NA TIONAL NUMBER Areas covered by HOOVER SERVICE DEALERS Also Channel Islands, Scilly Isles, Orkney , Shetlands See local telephone directory Hoover policy is one of continuous development and for ...
Do you have a question concerning Hoover HFI 5 G10?
Use the form below
If you did not solve your problem by using a manual Hoover HFI 5 G10, ask a question using the form below. If a user had a similar problem with Hoover HFI 5 G10 it is likely that he will want to share the way to solve it.