-
Niles Audio AT8700 - page 1
MODEL S AT 8500 AT 8700 B LENDING H IGH F IDELITY AND A RCHITECTURE ® INST ALLA TION & OPERA TION GUIDE MODEL S AT 8500 AT 8700 AD V ANCED TECHNOL OG Y ® IN-W ALL L OUDSPEAKERS DS00222A/AT8500-8700 3/1/99 10:47 AM Page 2 ...
-
Niles Audio AT8700 - page 2
Congr at ulations! Thank you for choosing Advanced T echnology In-W all Loudspeakers from Niles. W ith proper installation and operation, you'll enjoy years of trouble-free use. Niles manufactures the industry's most complete line of custom installation components and accessories for audio/video systems. For a free full line catalog write ...
-
Niles Audio AT8700 - page 3
Intr oduction The A T or Advanced T echnology group of In-W all Loudspeakers are designed to deliver truly stunning performance with optimum installation flexibility . All models in the A T series are constructed using the highest quality components and utilize advanced materials technology to create speakers capable of reproducing both music and m ...
-
Niles Audio AT8700 - page 4
Computer Optimized Crossover with Acoustical Configuration Controls The second order Linkwitz-Riley crossover is computer optimized and constructed of premium components for unparalleled sonic performance. The baffle-mounted T one Controls provide installers with Bass, Midrange and T reble adjustment in four increments (-2dB, Flat, +2dB, +4dB). Add ...
-
Niles Audio AT8700 - page 5
New Construction Wings Bracket Frame Speaker Baffle Grille Recommended Amplifier Power For satisfactory performance, we recom- mend an amplifier with a power rating of twenty to two hundred watts for the A T8500 and A T8700 speakers. Curiously , most speakers are not damaged by large amplifiers but by small amplifiers. If your system is playing lou ...
-
Niles Audio AT8700 - page 6
are connected in line with the speaker , so you must connect the wire from the ampli- fier to the volume control and then from the volume control to the speaker . Speaker Wire Use 2-conductor speaker wire when con- necting A T speakers to your receiver or amplifier . For most applications, we recom- mend you use a minimum of 1 6 or 1 8 gauge wire. ...
-
Niles Audio AT8700 - page 7
appreciate the tighter bass and extended frequency response into the lower octaves that the use of a backbox (or blocking off the wall cavity) will provide. A hole cutting template is provided with the A T8000 Series Bracket Kit. The cutout for the speak- er must measure 9 -3/4” x 1 7 -1/4”. Insulating the W all Cavity When it is not possible t ...
-
Niles Audio AT8700 - page 8
clarity , detail and the textures of the individ- ual instruments, you are a critical listener . In a home theater , the intelligibility of dialog and action reproduced by the front speakers is paramount! The position of the speakers plays a very important role in how clear the sound is and how a stereo image is created. Here are some guidelines to ...
-
Niles Audio AT8700 - page 9
speakers in an array around the listening area, so that the music is always surround- ing you, regardless of the direction you face. The rule of thumb is to add one pair of speakers for every 100 to 200 square feet of listening area. Curiously , this is not so that you can play the music louder , but so that you can play it softer! When you have on ...
-
Niles Audio AT8700 - page 10
the wall or even down low at power outlet height, in the ceiling, near corners, or directed at reflective objects and walls. The more reflected sound there is in the room the stronger the ambient effect at low vol- umes. Y ou should use moderation, howev- er , otherwise the compromise becomes too one sided and at high volumes the sound will be blur ...
-
Niles Audio AT8700 - page 11
lation of an array of speakers. If you place them near a hard reflecting surface you can make one pair of speakers sound like sever- al. Create as many reflections as possible by mounting the speakers up high in the wall and aim the Midrange/T weeter Array into the corners or at an adjoining wall or ceiling to diffuse the sound (See Figures 5, 6 an ...
-
Niles Audio AT8700 - page 12
Inst allation Fundamen tals Running the Speaker Wire in New Construction If you have doubts about whether you are capable of installing Niles A T Series speak- ers in your walls, consult a Niles dealer or professional installer . They have special tools, techniques, and experience to make the impossible possible. The installer can provide you with ...
-
Niles Audio AT8700 - page 13
Pulling the Cable Pull the cable in sections (from the stereo to the volume control, from the volume control to the speaker). Start with the longest sections and use left over wire to complete the short sections. If you plan to pull many rooms at the same time through a central route, walk off the distance to each destination, add a generous fudge ...
-
Niles Audio AT8700 - page 14
stereo system itself (See Figure 9) . The other very common route is through the bottom plate of the wall into an unfinished basement or crawl space. Identify where all of your electrical, phone, and TV wiring is likely to be and plan to route around it all. Y ou can accidentally induce 60 Hz hum on your speakers if you run your speaker wire right ...
-
Niles Audio AT8700 - page 15
Sometimes, an under -the-carpet run is possible (there are special flat speaker wires made for under -the-rug wire runs). As a last resort, heating and air condi- tioning vents can be used as wire race- ways for plenum rated wire (check your local building codes, some municipalities require conduit). In traditional wood stud/drywall construc- tion ...
-
Niles Audio AT8700 - page 16
Inst allation of Br acket s, Fr ames and Grilles in Ne w Construc tion Stage One: Before Drywall is Hung Insulating the W all Cavity . If feasible, fill the wall cavity with insula- tion at this point. Attach the wings to the bracket by snapping them into the sides of the bracket. The wings can be shortened by breaking them along the scored lines i ...
-
Niles Audio AT8700 - page 17
Screw one side of the assembled bracket with wings to the stud using one of the sup- plied screws. Level the bracket. Screw the other side of the bracket to the stud. T wo or three screws (depending upon the size of the model) on each side makes for a very secure installation. Attach the wire to the bracket at the indicated wire tie points (See Fig ...
-
Niles Audio AT8700 - page 18
Inst allation of Br acket s, Fr ames and Grilles in Existing W alls Important: Before you cut into any wall, review the sections on running wire and speaker placement. 1. Drill a 1/8” pilot hole just barely through the wallboard or dry wall (1/2” to 5/8” deep in most homes) about an inch below the center of your proposed speaker location (an ...
-
Niles Audio AT8700 - page 19
7. Attach the frame to the bracket by screw- ing the frame to the bracket using the supplied screws. Do not overtighten the screws, this will distort the frame and the grilles will not fit (this is not permanent, just loosen the screws and the grille will pop in). The screws should pull the frame and bracket together (sandwiching the drywall) so th ...
-
Niles Audio AT8700 - page 20
Installing the Speaker If the grille is already installed, remove it by using a bent paper clip or the tip of a corkscrew and pulling it away from the frame (See Figure 1 8) . 1. Separate the speaker wire so that at least two inches of each conductor are free. 2. Strip one half inch of insulation from the end of each conductor of the speaker wire. ...
-
Niles Audio AT8700 - page 21
In-W all at Ear Level The A T8500 and A T8700 speakers will per- form their best when installed at ear level and spaced within the “good placement zone for music” (See “Speaker Placement” on page 5) . Position the Midrange/T weeter Array in the vertical position with the tweeter on the outside and pivot the Array in or out to obtain a belie ...
-
Niles Audio AT8700 - page 22
When utilizing A T8500 or A T8700 speakers to reproduce rear channel information in a home theater , the goal is to create as many reflections as possible by mounting the speakers up high in the wall or in the ceiling and aim the Midrange/T weeter Array into the corners or at an adjoining wall to diffuse the sound (See Figures 5 and 6 on page 8) . ...
-
Niles Audio AT8700 - page 23
Specifications Model A T8500 Driver Compliment WOOFER — 8” aluminum/urethane cone with a cast aluminum frame, vented pole piece, high temperature aluminum voice coil former , an inverted dust cap, butyl rubber sus- pension and a custom construction debris screen MIDRANGE — Dual 1 - 1/2” fluid-cooled aluminum/urethane hyperbolic domes with N ...
-
Niles Audio AT8700 - page 24
Specifications 22 Specifications Model A T8700 Driver Compliment WOOFER — 8” aluminum/titanium/urethane cone with a cast aluminum frame, bi-filer voice coil winding, a vented pole piece, an extreme temperature T il voice coil former , an inverted dust cap, a butyl rubber suspension and a custom construction debris screen MIDRANGE — Dual 1 - 1 ...
-
Niles Audio AT8700 - page 25
DET ACH HERE AND RETURN TO: Niles Audio Corporation Warranty Registration Dept. P .O. Box 160818 Miami, Florida 331 16- 0818 Model Purchased __________________ ____________ _____ ________________ _______ _______ ___________________ Serial Number _____________ _____________ _______ _________________________ _______ ___________________ Date Purchased ...
-
Niles Audio AT8700 - page 26
PLEASE FILL OUT THE W ARRANTY REGISTRA TION CARD ON THE REVERSE SIDE, DET ACH, AND MAIL T O: Niles Audio Corporation W arranty Registration Dept. P .O. Box 1 608 1 8 Miami, Florida 33 1 1 6- 08 1 8 DET ACH HERE DS00222A/AT8500-8700 3/1/99 10:47 AM Page 5 ...
-
Niles Audio AT8700 - page 27
Limit ed W arr anty 25 Limit ed W arr anty Niles Audio Corporation ("NILES") warrants its loudspeaker products to the original pur chaser to be free of manufacturing defects in material and workmanship for a period of two years from date of purchase. This W arranty is subject to the following additional conditions and limitations. The W a ...
-
Niles Audio AT8700 - page 28
Niles Audio Corporation 1 233 1 S. W . 1 30 Street Miami, Florida 33 1 86 T el: (305) 238-43 73 Fax: (305) 238-0 1 85 www .nilesaudio.com Printed in T aiwan © 1 999 Niles Audio Corporation DS00 222A DS00222A/AT8500-8700 3/1/99 10:47 AM Page 1 ...
Do you have a question concerning Niles Audio AT8700?
Use the form below
If you did not solve your problem by using a manual Niles Audio AT8700, ask a question using the form below. If a user had a similar problem with Niles Audio AT8700 it is likely that he will want to share the way to solve it.