English dropdown-ico

Manual APC SC450RMI1U

16 pages Not applicable
Download

Go to site of 16

Summary
  • APC SC450RMI1U - page 1

    990 - 1852 C , 10 /2005 User Manual English APC Smart - UPS ® SC 250/450 VA 110/120/230 Vac 1U Rack - Mount/Tower Uninterruptible Power Supply ...

  • APC SC450RMI1U - page 2

    ...

  • APC SC450RMI1U - page 3

    1 Introduction The APC Uninterruptible Power Supply (UPS) is designed to prevent blackouts, brow n outs, sags, and surges from re aching your equipment. The uninterruptible power supply (UPS) filters small uti l- ity line fluctuations and isolates your equipment from large disturbances by internally disconnecting from the utility line. The UPS prov ...

  • APC SC450RMI1U - page 4

    2 Rack - Mounting Œ • Ž • Two - post rack - mounting : Utilize the bracket holes that are of f set 6 .25”. • Secure clip - nuts to the rack, and attach brackets with provided screws. ‘ ...

  • APC SC450RMI1U - page 5

    3 ’ “ Tower Configuration Attention: Connect the battery before tower setup by referring to applicable steps in Rack - Mounting. ...

  • APC SC450RMI1U - page 6

    4 Wall Mounting Attention: Connect the battery before mounting by referring to applicable steps in Rack - Mounting. To avoid a safety hazard, do not mount the unit on the wall with the bezel facing downwards, or with the display panel at the bottom. Œ • Note: Whenever possible, a ttach two screws into wall studs. If stud mounting is not poss i b ...

  • APC SC450RMI1U - page 7

    5 2: S TART UP Connect Equipment t o the UPS Rear Panels 110/120 V: 230 V: Note: A laser printer draws significantly more power than other types of equipment and may ove r- load the UPS. Connect the UPS to the Network (if Applicable) Serial Port Telephone/ Network Surge Suppre s sion P orts Use only interface kits a p proved by APC. Use only the su ...

  • APC SC450RMI1U - page 8

    6 3: O PERATION Front Display Panel 110/120 V 230 V I NDICATOR D ESCRIPTION On L ine The UPS is supplying utility power to the connected equipment. On Ba t tery The UPS is supplying battery power to the connected eq uipment. Ove r load The connected loads are drawing more than the UPS power rating. Replace Ba t tery The battery must be replaced. F ...

  • APC SC450RMI1U - page 9

    7 4: U SER C ONFIGURABLE I TEMS N OTE : S ETTINGS ARE ADJUSTED THROUGH P OWER C HUTE SOFTWARE F UNCTION F ACTORY D E FAULT U SER S E LECTABLE C HOICES D ESCRIPTION Automatic Self - Test Every 14 days (336 hours) Every 7 days (168 hours), Every 14 days (336 hours), On Startup Only, No Self - Test Set the inte r val at which the UPS will execute a s ...

  • APC SC450RMI1U - page 10

    8 N OTE : S ETTINGS ARE ADJUSTED THROUGH P OWER C HUTE SOFTWARE F UNCTION F ACTORY D E FAULT U SER S E LECTABLE C HOICES D ESCRIPTION Low Battery War n ing 2 minutes PowerChute Business Edition sof t ware provides automatic, una t- tended shutdown when approx i- mately 2 mi n utes of battery ope r- ated runtime r e- mains. 2, 5, 7, 10 mi n utes (Ti ...

  • APC SC450RMI1U - page 11

    9 5: S TORAGE AND M AINTENANCE Storage Store the UPS covered in a cool, dry loc ation, with the ba t tery fully charged. At - 15 to +30 ° C (+5 to +86 ° F), charge the UPS ba t tery every six months. At +30 to +45 ° C (+86 to +113 ° F), charge the UPS ba t tery every three months. Battery Replacement The UPS battery life differs based on usage ...

  • APC SC450RMI1U - page 12

    10 6: T ROUBLESHOOTING , S HIPPING , AND S ERVICE Use the chart below to solve minor UPS installation and operat ion problems. Refer to www.apc.com with co m plex UPS problems, and for battery runtime charts. P ROBLEM AND / OR P OSSIBLE C AUSE S OLUTION UPS WILL NOT TURN ON UPS not connected to utility power supply. Check that the power cord from t ...

  • APC SC450RMI1U - page 13

    11 P ROBLEM AND / OR P OSSIBLE C AUSE S OLUTION THE OVERLOAD LED IS ILLUMINATED AND THE UPS EMITS A SU S TAINED ALARM TONE The UPS is overloaded. The connected equipment is dra w- ing more VA than the UPS can sustain. The connected equipment exceeds the specified “maximum load.” The alarm remains on until the overload is removed. Disconnect non ...

  • APC SC450RMI1U - page 14

    12 Shipping and S ervice Prepare the UPS for shipping: Shutdown and disconnect any equipment attached to the UPS. Shut down the UPS, and di s connect the UPS from the utility power outlet. Disconnect the battery. If the UPS requires service do not return it to the dealer. Fo llow these steps: 1. Review the problems discussed in Troubleshooting to e ...

  • APC SC450RMI1U - page 15

    13 7: R EGULATORY AND W ARRANTY I NFORMATION 110/120 V models This equipment has been tested and found to comply with the limits for a Class A digital device, pu r- suant to part 15 of the FCC Rules. These l imits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial enviro n ment. ...

  • APC SC450RMI1U - page 16

    14 Limited Warranty American Power Conversion (APC) warrants its products to be free from defects in materials and workmanship for a period of two years from the date of purchase. Its obligation under this warranty is l imited to repairing or replacing, at its own sole o p tion, any such defective products. To obtain service under warranty you must ...

Manufacturer APC Category Uninterruptible power supply (

Documents that we receive from a manufacturer of a APC SC450RMI1U can be divided into several groups. They are, among others:
- APC technical drawings
- SC450RMI1U manuals
- APC product data sheets
- information booklets
- or energy labels APC SC450RMI1U
All of them are important, but the most important information from the point of view of use of the device are in the user manual APC SC450RMI1U.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals APC SC450RMI1U, service manual, brief instructions and user manuals APC SC450RMI1U. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product APC SC450RMI1U.

Similar manuals

A complete manual for the device APC SC450RMI1U, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use APC SC450RMI1U by users. Manuals are usually written by a technical writer, but in a language understandable to all users of APC SC450RMI1U.

A complete APC manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual APC SC450RMI1U - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the APC SC450RMI1U, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the APC SC450RMI1U, that we can find in the current document
3. Tips how to use the basic functions of the device APC SC450RMI1U - which should help us in our first steps of using APC SC450RMI1U
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with APC SC450RMI1U
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of APC SC450RMI1U in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning APC SC450RMI1U?

Use the form below

If you did not solve your problem by using a manual APC SC450RMI1U, ask a question using the form below. If a user had a similar problem with APC SC450RMI1U it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)