Manual Sony SAVA-500

20 pages 0.27 mb
Download

Go to site of 20

Summary
  • Sony SAVA-500 - page 1

    3-866-402- 11 (1)  1999 by Sony Corporation Home Theater Active Speaker System Operating Instructions SA V A-700 SA V A-500 ...

  • Sony SAVA-500 - page 2

    2 W ARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to ...

  • Sony SAVA-500 - page 3

    3 T ABLE OF CONTENTS Getting Started Unpacking 4 Hooking Up the Speaker System 5 Hooking Up the Speaker System 5.1-channel Input 7 Choosing the Best Location 8 Turning the Speaker System On and Off 9 Home Theater Operations Enjoying Surround Sound 10 Adjusting the Surround Sound 11 Adjusting the Sound 13 Operating Other Sony Components 14 Additiona ...

  • Sony SAVA-500 - page 4

    4 Getting Started Unpacking Check that you received the following items with your speaker system: • Satellite speakers SS-T100 (SAVA-700 only) (3; one for the center speaker, and two for the rear speakers) • Mounting brackets (SAVA-700 only) (2) • Wood screws (SAVA-700 only) (4) • Foot pads (SAVA-700 only) (12) • Center speaker SS-CN16 (S ...

  • Sony SAVA-500 - page 5

    5 Getting Started Hooking Up the Speaker System This section describes how to connect the speaker system to your TV and VCR. Center speaker Rear speaker (right) Front speaker (right) TV set VCR STEP 3 Rear speaker (left) Front speaker (left) STEP 1 STEP 3 Center speaker Front speaker (left) Front speaker (right) Front speaker (left) * If you use an ...

  • Sony SAVA-500 - page 6

    6 Getting Started Front speaker (left) TV Rear speaker (right) Rear speaker (left) STEP 3 Connecting the rear speakers Use the supplied 32-foot-9 3 / 4 inch (10 m) speaker cords to connect the left and right rear speakers. Insert the stripped wires into the speaker terminals. #3 #3 REAR SPEAKERS LL R –+ R # Be sure to connect matching speaker ter ...

  • Sony SAVA-500 - page 7

    7 Getting Started Front speaker (left) CD player, DVD player, LD player, etc. 1 Use an optional CONTROL S cord to connect the CONTROL S TV IN jack on the left front speaker to the CONTROL S OUT jack on the back of the TV. CONTROL S OUT ç TV IN CONTROL S 2 Follow the Operating Instructions supplied with your TV set to set it to operate this spea ...

  • Sony SAVA-500 - page 8

    8 Getting Started 8 ft (2.5 m) max 2 - 3 ft (60 - 90 cm) Setting the Dolby Digital (AC-3) decoder Specify the speaker type in the decoder’s display as below: Specify by selecting front speaker size LARGE center speaker size LARGE rear speaker size LARGE subwoofer selection YES To enjoy theater-quality Multi-Channel Surround sound Press INPUT (or ...

  • Sony SAVA-500 - page 9

    9 Getting Started T urning the Speaker System On and Off = ( p + 0 ) P ++ + ++ + + – –– – – – – TV CD VIDEO DVD Turning on the speaker system Press U on the lower part of the left front speaker. The ON indicator on the left front speaker lights up. When the speaker system is in standby or ready mode (i.e., the STANDBY or READY indicat ...

  • Sony SAVA-500 - page 10

    10 Home Theater Operations Enjoying Surround Sound You can enjoy the speaker’s surround sound capability simply by choosing one of the five available surround modes: PRO LOGIC (Dolby Pro Logic) surround mode Reproduces superb theater-like presence and surround effects from video software encoded with Dolby Surround. C.STUDIO surround mode Creates ...

  • Sony SAVA-500 - page 11

    11 Home Theater Operations CENTER +/– REAR +/– T.TONE DELAY To mute the sound Press MUTING on the remote. To restore the sound, press MASTER VOL + (or MUTING on the remote again). Notes • Some videos and laser discs may support Dolby Pro Logic Surround sound even if it is not indicated on the package. • The surround modes do not operate whe ...

  • Sony SAVA-500 - page 12

    12 Home Theater Operations Setting the center mode In PRO LOGIC or C.STUDIO surround mode, you can choose from four different center modes: NORMAL, WIDE, 3 STEREO, or PHANTOM. For normal use, select NORMAL or WIDE mode. When you use the supplied center speaker, we recommend using WIDE mode. To select the mode that you want, follow the procedure bel ...

  • Sony SAVA-500 - page 13

    13 Home Theater Operations Adjusting the Sound Although this speaker system’s sound quality has been pre-adjusted at the factory, you can change the settings for each surround mode to suit your taste. The adjusted settings remain stored for the respective surround mode until you change them. + ++ + + –– – – – 1 Play back a program. 2 Ma ...

  • Sony SAVA-500 - page 14

    14 Home Theater Operations Oper ating Other Sony Components Z You can use the supplied remote to operate Sony components, including TV set, VCRs, DVD players, LD players, and CD players. TV CD VIDEO DVD = ( p + 0 ) P ++ + ++ + + – –– – – – – Before using the remote for your Sony component Table below shows the components that supports ...

  • Sony SAVA-500 - page 15

    15 Additional Information Remote operations cannot be performed. / Point the remote towards the remote sensor g on the left front speaker. / Remove any obstructions between the remote and this system’s left front speaker. / Replace the batteries in the remote. T r oubleshooting If you experience any of the following difficulties while using the s ...

  • Sony SAVA-500 - page 16

    16 Additional Information Specifications SAVA-700 Amplifier section AUDIO POWER SPECIFICATIONS (The U.S model only) POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 8 ohm loads both channels driven, from 200 Hz - 20 kHz; rated 32 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated outpu ...

  • Sony SAVA-500 - page 17

    17 Additional Information SAVA-500 Amplifier section AUDIO POWER SPECIFICATIONS (The U.S model only) POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 8 ohm loads both channels driven, from 200 Hz - 20 kHz; rated 20 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output. Continuous R ...

  • Sony SAVA-500 - page 18

    18 Additional Information 5.1-channel input (5.1 CH IN) jacks These jacks are used to input decoded multi- channel format audio signals (e.g., Dolby Digital (AC-3), DTS, etc.), allowing you to enjoy 5.1 channel surround sound. Use these jacks to connect a multi-channel decoder or a DVD player with a built-in multi-channel decoder. Rear speaker (L) ...

  • Sony SAVA-500 - page 19

    19 Additional Information Index A, B Adjusting bass 13 delay time 12 speaker volume 10, 11 subwoofer level 13 treble 13 C Center mode NORMAL mode 12, 18 PHANTOM mode 12, 18 3 STEREO mode 12, 18 WIDE mode 12, 18 Checking the connection 9 Connecting. See Hookups CONTROL S TV IN 7 D, E Delay time 12, 18 Dolby Digital (AC-3) 7, 18 Dolby Pro Logic Surro ...

  • Sony SAVA-500 - page 20

    Sony Corporation Printed in Malaysia ...

Manufacturer Sony Category Speaker System

Documents that we receive from a manufacturer of a Sony SAVA-500 can be divided into several groups. They are, among others:
- Sony technical drawings
- SAVA-500 manuals
- Sony product data sheets
- information booklets
- or energy labels Sony SAVA-500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Sony SAVA-500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Sony SAVA-500, service manual, brief instructions and user manuals Sony SAVA-500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Sony SAVA-500.

Similar manuals

A complete manual for the device Sony SAVA-500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Sony SAVA-500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Sony SAVA-500.

A complete Sony manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Sony SAVA-500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Sony SAVA-500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Sony SAVA-500, that we can find in the current document
3. Tips how to use the basic functions of the device Sony SAVA-500 - which should help us in our first steps of using Sony SAVA-500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Sony SAVA-500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Sony SAVA-500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Sony SAVA-500?

Use the form below

If you did not solve your problem by using a manual Sony SAVA-500, ask a question using the form below. If a user had a similar problem with Sony SAVA-500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)