English dropdown-ico

Manual Yard Machines 330

28 pages 0.67 mb
Download

Go to site of 28

Summary
  • Yard Machines 330 - page 1

    IMPOR TANT: READ SAFETY RULES AND INSTRUCTIONS CAREFUL LY MTD PRODUCTS INC. P .O. B OX 368022 CLEVELAND, OHIO 44136-9722 Model Series 230 and 520 22" SELF-PROPELLED RO TARY MOWERS PRINTED IN U.S.A. FORM NO.770-8559A O PER AT OR’S M AN UAL Warning: This unit is equipped with an internal combustion engine and should not be used on or near any ...

  • Yard Machines 330 - page 2

    2 SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR LAWN MOWER. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY R ...

  • Yard Machines 330 - page 3

    3 • Do not engage the self-propelled mechanism on units so equipped while starting engine. • The blade control handle is a safety device. Never attempt to bypass its operation. Doing so makes the safety device inoperative and may result in personal injury through contact with the rotating blade. The blade control handle must operate easily in b ...

  • Yard Machines 330 - page 4

    4 • To reduce fire hazard, keep mower free of grass, leaves, or other debris build-up. Clean up oil or fuel spillage. Allow mower to cool at least 5 minutes before storing. • Before cleaning, repairing, or inspecting, make certain the blade and all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the spark ...

  • Yard Machines 330 - page 5

    5 SECTION 2: FINDING YOUR MODEL NUMBER This Operator’s Manual is an important part of your new walk behind. It will help you assemble, prepare and maintain your walk behind. Please read and understand what it says. Before you start to prepare your walk behind for its first use, please locate the model plate and copy the information from it in thi ...

  • Yard Machines 330 - page 6

    6 Slope Gauge 15° SIGHT AND HOLD THIS LEVE L WITH A V ERTICAL TREE A POWE R POLE A CORNER OF A BUILDING OR A FENCE P OST F O L D O N D O T T E D L I N E , R E P R E S E N T I N G A 1 5 ° S L O P E USE THIS PAGE AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY. Do n ot mow on inclin es with a slope in exces s of 15 degrees (a rise o ...

  • Yard Machines 330 - page 7

    7 SECTION 4: UNPACKING To removing unit from carton 1 . Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton. 2 . Remove loose parts if included with unit (i.e., owner's manual, etc.). 3 . Make sure the cables are straight and not crimped while removing loose parts or the unit from the carto ...

  • Yard Machines 330 - page 8

    8 This owner's guide covers various models of mowers. Follow only those instructions which pertain to your unit. IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil before operating your mower. NOTE: Reference to right or left hand side of the mower is observed from the oper ...

  • Yard Machines 330 - page 9

    9 1. Lift the chute deflector on the mower. Slide the notches in the bottom of the mulching baffle over the lip of the discharge opening. See Figure 6. 2. Push the hooks on the top of the baffle until they snap over the hinge on the discharge chute. Release the chute deflector. FINAL ASSEMB LY Make certain all nuts and bolts are tightened securely. ...

  • Yard Machines 330 - page 10

    10 SECTION 6: OPERATION WARNING: Keep hands and feet away from the chute area on cutting deck. See Figure 1 in the Safety Section. WARNING: The operation of any lawn mower can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields. We recommend wide vision safety mask f ...

  • Yard Machines 330 - page 11

    11 TO STOP ENGINE AND BLADE 1. Move throttle control lever to SLOW position. 2. Release the blade control handle to stop the engine and blade. WARNING: The blade continues to rotate for a few seconds after the engine is shut off. 3. Disconnect the spark plug wire and ground it against the engine to prevent accidental starting while equipment is una ...

  • Yard Machines 330 - page 12

    12 Figure 10 4. Turn the lower handle around so the notches on the bottom of the lower handle are facing forward as shown in Figure 10. 5. Reassemble, placing the bottom holes in the handle over the weld pins in the handle mounting bracket. 6. Reassemble the upper handle. 7. Place the hairpin clips in the inner holes in the weld pins and attach the ...

  • Yard Machines 330 - page 13

    13 THROTTLE CONTROL ADJUSTMENT If the throttle control requires adjustment or if it has been replaced and need adjustment, proceed as follows: Figure 12 1. Remove the screw shown in Figure 12. Remove the cable clamp from the cable. NOTE: If you have a Tecumseh engine, simply loosen the screw so the cable will move freely beneath the clamp. It is no ...

  • Yard Machines 330 - page 14

    14 T ransmission The transmission is pre-lubricated and sealed at the factory. It does not require checking. If disassembled for any reason, fill with 2 ounces of Alvania grease, part number 737-0168. WARNING: Be sure to disconnect and ground the spark plug wire before performing any repairs or maintenance. NOTE: When tipping the unit, empty the fu ...

  • Yard Machines 330 - page 15

    15 BLADE MOUNTING TORQUE Center Bolt: 450 in. lbs. min., 600 in. lbs. max.; Blade Adapter Bolts (if applicable): 200 in. lbs. min., 350 in. lbs. max. To ensure safe operation of your unit, all nuts and bolts must be checked periodically for correct tightness. DECK The underside of the mower deck should be cleaned after each use to prevent a buildup ...

  • Yard Machines 330 - page 16

    16 7. Remove the belt from between the idler pulley and the belt guard on the idler pulley bracket. 8. Remove the belt from the transmission pulley. 9. Push the idler pulley up and out of the way. See Figure 18. 10. Slide the belt in from the rear of the deck, and place it around the transmission pulley. Figure 18 11. Release the idler pulley so th ...

  • Yard Machines 330 - page 17

    17 SECTION 10: TROUBLE SHOOTING GUIDE **Self-propelled models only Note: For repairs beyond the minor adjustments above, contact your local authorized service dealer. Trouble Possible Cause(s) Corrective Actions Engine fails to start Blade control handle disengaged. Spark plug wire disconnected. Dirty aircleaner. Primer button not depressed. Thrott ...

  • Yard Machines 330 - page 18

    18 Model Series 230 30 30 33 31 32 ...

  • Yard Machines 330 - page 19

    19 Model Series 230 RE F . NO. PART NO. DESCRIPTION 1 747-0824 Control Handle Ass’ y . (Std.) 2 720-0225 Foam Grip (2 Req’d.) 720-0226 Foam Grip (1 Req’d.) (Optional) 3 746-0876 Throttle Lever 4 710-0605 Oval C-Sunk Scr. 5 712-0324 Hex L-Nut 1/4-20 Thd. 6 736-0501 Sp r. Wash. .66" I. D . 7 646-0875 Throttle Body 8 811-00185 Throttle Box ...

  • Yard Machines 330 - page 20

    20 111 710-0841 Fl-”C”-Sunk Hd. T ap Scr. #10 x .75" Lg. 112 736-0356 Bell Wash. .39 I. D . x 1.38 O. D . 122 711-0805 Shld. Pin 3/8-24 x 1.43" Lg. 128 712-0711 Hex Jam Nut 3/8-24 Thd. 130 736-0270 Bell Washer .265 ID x .75 131 710-0751 Cap Screw HH 1/4-20 x .620 133 748-0318 Ratchet Wheel 1.62" O. D . 134 741-0522 Hex Flange Bea ...

  • Yard Machines 330 - page 21

    21 Model Series 230 and 520 18 46 RE F . NO. PART NO. DESCRIPTION 1 710-1062 Hex Bolt 1/4-20 x 1.25" Lg. 2 726-0329 L-Wash. 1/4" I. D . 3 618-0053 Upper Hsg. Half (Incl. Ref. 12) 4 713-0400 #48 Sprocket 7 Tooth x 1/2 Pitch 5 736-0336 Fl-Wash. 5/8" I. D . x .030 6 741-0413 Hex Flange Brg. .631" I. D . 7 16500A Hex Bearing Cup 8 7 ...

  • Yard Machines 330 - page 22

    22 Model Series 520 †Optional Hub Caps Description Part No. Gray (3-1/2” Dia.) Black (4-1/4” Dia.) Gray (4-1/4” Dia.) Gray (5-1/2” Dia.) 720-0249 731-0354 731-0355A 731-0981A ** Front Wheel Chart Size Tread Type Part No. 8” x 1.75” 8” x 1.75” 8” x 2” Bar T read “T” T read “S” Wave 634-0020 734-1268 734-1512A ...

  • Yard Machines 330 - page 23

    23 Model Series 520 RE F . NO. PART NO. DESCRIPTION 1 647-0004 Control Handle Ass’ y . (Deluxe) 747-0824 Control Handle Ass’ y . (Std.) 2 720-0225 Foam Grip (Optional) 3 749-0539B Upper Handle 4 710-0605 Oval C-Sunk Scr. 5 646-0875 Throttle Body 6 746-0550 Control Cable—39" Lg. 7 736-0501 Spring Wash. .66" I. D . 8 712-0324 Hex L-Nu ...

  • Yard Machines 330 - page 24

    24 Shroud Chart Pa rt N o. 751B281439 751B281440 751B281443 Color Dark Red Black Bright Red Pa rt N o. 731-1395A 731-1396A 731-1397A Color Red Black Gray Pa rt N o. 731-1587A 731-1603A 731-1610A 731-1620A Color Black Y ellow Pewter Gray Pa rt N o. 731-1561 Color Black Hardware: 710-1256 (Screw) Hardware: 710-1256 (Screw) Hardware: 710-1184 (Screw) ...

  • Yard Machines 330 - page 25

    25 NOTES ...

  • Yard Machines 330 - page 26

    26 NOTES ...

  • Yard Machines 330 - page 27

    27 ...

  • Yard Machines 330 - page 28

    MANU FA CTURER’S LIMITED WARRANTY FOR: For TWO YEARS from the date of retail purchase within the United States of America, its possessions and territories, MTD PRODUCTS INC will, at its option, repair or replace, for the original purchaser, free of charge, any part or parts found to be defective in material or workmanship. This warranty covers un ...

Manufacturer Yard Machines Category Lawn Mower

Documents that we receive from a manufacturer of a Yard Machines 330 can be divided into several groups. They are, among others:
- Yard Machines technical drawings
- 330 manuals
- Yard Machines product data sheets
- information booklets
- or energy labels Yard Machines 330
All of them are important, but the most important information from the point of view of use of the device are in the user manual Yard Machines 330.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Yard Machines 330, service manual, brief instructions and user manuals Yard Machines 330. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Yard Machines 330.

Similar manuals

A complete manual for the device Yard Machines 330, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Yard Machines 330 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Yard Machines 330.

A complete Yard Machines manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Yard Machines 330 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Yard Machines 330, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Yard Machines 330, that we can find in the current document
3. Tips how to use the basic functions of the device Yard Machines 330 - which should help us in our first steps of using Yard Machines 330
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Yard Machines 330
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Yard Machines 330 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Yard Machines 330?

Use the form below

If you did not solve your problem by using a manual Yard Machines 330, ask a question using the form below. If a user had a similar problem with Yard Machines 330 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)