English dropdown-ico

Manual Gigabyte GA-6BA

19 pages Not applicable
Download

Go to site of 19

Summary
  • Gigabyte GA-6BA - page 1

    6BA 1 TABLE OF CONTENTS 1. INTRODUCTION 1.1. PREFACE ......................................................................................................... 1- 1 1.2. KEY FEATURES .............................................................................................. 1- 1 1.3. PERFORMANCE LIST .............................................. ...

  • Gigabyte GA-6BA - page 2

    Table Of Contents 2 4. BIOS CONFIGURATION 4.1. ENTERING SETUP ......................................................................................... 4-1 4.2. CONTROL KEYS ............................................................................................. 4-1 4.3. GETTING HELP ............................................................ ...

  • Gigabyte GA-6BA - page 3

    6BA 1- 1 1. INTRODUCTION 1.1. PREFACE Welcome to use the 6BA motherboard. It is a Pentium  II / III / Celeron  Processor based PC / AT compatible system with AGP / PCI / ISA Bus, and has been designed to be the fastest PC / AT system. There are some new features allow you to operate the system with just the performance you want. This manual a ...

  • Gigabyte GA-6BA - page 4

    Introduction 1- 2 1.3. PERFORMANCE LIST The following performance data list is the testing results of some popular benchmark testing programs. These data are just referred by users, and there is no responsibility for different testing data values gotten by users. (The different Hardware & Software configuration will result in different benchmar ...

  • Gigabyte GA-6BA - page 5

    6BA 1- 3 3.3V EDO/SDRAM DIMM Sockets Floppy Port 1.4. BLOCK DIAGRAM 66MHz Ultra DMA/33 IDE Ports 24MHz 14.318MHz 33MHz 33MHz 33MHz 66MHz 66MHz IDE Bus PCI Bus ISA Bus AGP Bus LPT Port Keyboard COM Ports DRAM Bus PS/2 Mouse USB Bus USB Ports 14.318MHz 48MHz 14.318MHz I/O CHIPSET 83977EF 66MHz AGP SLOT Host Bus PAC 82443BX CHIPSET Clock Gen PIIX4 CHI ...

  • Gigabyte GA-6BA - page 6

    Introduction 1- 4 1.5. INTRODUCE THE Pentium  II / III Processor Figure 1: Universal Retention Mechanism & attach Mount Figure 2:OEM Pentium  II Processor ...

  • Gigabyte GA-6BA - page 7

    6BA 1- 5 Figure 3: OEM Pentium  III Processor 1.6 What is AGP ? The Accelerated Graphics Port (AGP) is a new port on the Host-To-PCI bridge device that supports an AGP port. The main purpose of the AGP port is to provide fast access to system memory. The AGP port can be used either as fast PCI port (32-bits at 66MHz vs. 32- bits at 33MHz) or as ...

  • Gigabyte GA-6BA - page 8

    ...

  • Gigabyte GA-6BA - page 9

    Specification 2- 1 2. SPECIFICATION 2.1. HARDWARE • CPU − Pentium  II / III / Celeron  Processor 233 – 633MHz. − 242 pins 66/100MHz slot1 on board. • SPEED − 66 / 100MHz system speed. − 66 MHz AGP bus speed. (133MHz 2*mode) − 33 MHz PCI-Bus speed. − 8 MHz AT bus speed. • DRAM MEMORY − 4 banks 168 pins DIMM module sockets ...

  • Gigabyte GA-6BA - page 10

    6BA 2 -2 • GREEN FUNCTION − Suspend mode support. − Green switch & ACPI LED support. − IDE & Display power down support. − Monitor all IRQ / DMA / Display / I/O events. • BIOS − 2M bits FLASH RAM. − Supports Plug & Play, DMI Function. • DIMENSION − BABY AT Form Factor, 4 layers PCB. 2.2. SOFTWARE • DRIVER − Bus M ...

  • Gigabyte GA-6BA - page 11

    Hardware Installation 3- 1 3. HARDWARE INSTALLATION 3.1. UNPACKING The main board package should contain the following: • Th e 6BA main board. • Universal Retention Mechanism & Attach Mount • USER'S MANUAL for main board. • Cable set for IDE, Floppy & I/O devices. • CD for main board Utilities. The main board contains sensiti ...

  • Gigabyte GA-6BA - page 12

    6BA 3- 2 3.2. MAINBOARD LAYOUT PCB Ver : 2.9 82443LX 6BA 1 PIIX4 82443BX Winbond 83977-EF BIOS ISA 1 ISA 2 PCI 1 PCI 2 PCI 3 PCI 4 USB AGP LPT COM B COM A PS/2 MOUSE K.B JP1 SLOT 1 JP8 J11 JP10 JP9 U14 J20 BAT1 IR PWR SPK TD TB RST GD GN HD SOFT PWR J9 J19 J6 J21 POWER PCB Ver : 3.0 82443LX 6BA 1 PIIX4 82443BX Winbond 83977-EF BIOS ISA 1 ISA 2 PCI ...

  • Gigabyte GA-6BA - page 13

    Hardware Installation 3- 3 3.3. QUICK REFERENCE FOR JUMPERS & CONNECTORS t I/O Ports Connector USB USB port. IDE1 For Primary IDE port. IDE2 For Secondary IDE port. KB For Keyboard port. PS/2 For PS/2 Mouse port. FLOPPY For Floppy port COMB For Serial port2 (COM B). COMA For Serial port1 (COM A). POWER For AT Power Connector. ATX POWER For ATX ...

  • Gigabyte GA-6BA - page 14

    6BA 3- 4 t TD : Turbo LED Connector Pin Function 1 LED anode (+) 2 LED cathode ( − ) t RST : RESET Switch Open Normal operation Close Reset system t GD : Green LED Connector Pin Function 1 LED anode (+) 2 LED cathode ( − ) t GN : GN-SW Open Normal operation Close Enter Green Mode t HD : Hard Disk active LED (HD-LED) Pin Function 1 LED anode (+) ...

  • Gigabyte GA-6BA - page 15

    Hardware Installation 3- 5 t JP10 : CASE OPEN (Optional) Pin Function 1 Signal 2 GND t JP9 : Clear CMOS Pin Function 1-2 Clear CMOS. 2-3 Normal t J19 : Internal Modem Card Ring PWR On Pin Function 1 Signal 2 GND t J21 : Power FAN Pin Function 1 GND. 2 +12V 3 Signal t JP1 : Keyboard Power On Selection Pin Function 1-2 Enabled Keyboard power on. 2-3 ...

  • Gigabyte GA-6BA - page 16

    6BA 3- 6 t JP11&JP12(This function is support in PCB version 3.0 and above) Pin No. Function Open Normal Close For Voodoo3 VGA card 3.4. DRAM INSTALLATION The main board can be installed with 16 / 32 / 64 / 128 / 256 MB 168 pins DIMM module DRAM. When system bus speed is set to 100MHz, 100MHz SDRAM is required. The DRAM memory system on main bo ...

  • Gigabyte GA-6BA - page 17

    Hardware Installation 3- 7 Set system speed to Auto: JP8 pin 2-3 short will detect system speed 66/100MHz FSB automatically. DIP SWITCH FREQ. RATIO 1 2 3 4 X 3 ON OFF ON ON X 3.5 OFF OFF ON ON X 4 ON ON OFF ON X 4.5 OFF ON OFF ON X 5 ON OFF OFF ON X 5.5 OFF OFF OFF ON X 6 ON ON ON OFF X 6.5 OFF ON ON OFF X 7 ON OFF ON OFF X 7.5 OFF OFF ON OFF X 8 O ...

  • Gigabyte GA-6BA - page 18

    6BA 3- 8 3.6. CMOS RTC & ISA CFG CMOS SRAM There're RTC & CMOS SRAM on board; they have a power supply from external battery to keep the DATA inviolate & effective. The RTC is a REAL- TIME CLOCK device, which provides the DATE & TIME to system. The CMOS SRAM is used for keeping the information of system configuration, so the sy ...

  • Gigabyte GA-6BA - page 19

    Hardware Installation 3- 9 3.10. IDE & ATAPI DEVICE INSTALLATION There are two-Enhanced PCI IDE ports ( IDE1, IDE2 ) on board, which following ATAPI standard SPEC. Any one IDE port can connected to two ATAPI devices (IDE Hard Disk, CD-ROM & Tape Driver), so total four ATAPI devices can exist in a system. The HD is the active LED port for AT ...

Manufacturer Gigabyte Category Motherboard

Documents that we receive from a manufacturer of a Gigabyte GA-6BA can be divided into several groups. They are, among others:
- Gigabyte technical drawings
- GA-6BA manuals
- Gigabyte product data sheets
- information booklets
- or energy labels Gigabyte GA-6BA
All of them are important, but the most important information from the point of view of use of the device are in the user manual Gigabyte GA-6BA.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Gigabyte GA-6BA, service manual, brief instructions and user manuals Gigabyte GA-6BA. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Gigabyte GA-6BA.

Similar manuals

A complete manual for the device Gigabyte GA-6BA, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Gigabyte GA-6BA by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Gigabyte GA-6BA.

A complete Gigabyte manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Gigabyte GA-6BA - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Gigabyte GA-6BA, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Gigabyte GA-6BA, that we can find in the current document
3. Tips how to use the basic functions of the device Gigabyte GA-6BA - which should help us in our first steps of using Gigabyte GA-6BA
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Gigabyte GA-6BA
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Gigabyte GA-6BA in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Gigabyte GA-6BA?

Use the form below

If you did not solve your problem by using a manual Gigabyte GA-6BA, ask a question using the form below. If a user had a similar problem with Gigabyte GA-6BA it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)