English dropdown-ico

Manual Saleen S281SC

12 pages 1.93 mb
Download

Go to site of 12

Summary
  • Saleen S281SC - page 1

    = SALEEN SPEEDLAB S281SC REAR WING KIT INSTALLATION MANUAL: 2005 Mustang P/N: 10-8002-C11998B Saleen Performance, Inc. 76 Fairbanks Irvine, CA 92618 949-597-4900 www.saleen.com ...

  • Saleen S281SC - page 2

    2 ...

  • Saleen S281SC - page 3

    3 IF YOU ARE NOT EXPERIENCED IN THE AREA OF AUTOMOTIVE MECHANICS, WE STRONGLY URGE THAT YOU REFER THIS INSTALLATION TO A CERTIFIED INSTALLER OR TECHNICIAN ...

  • Saleen S281SC - page 4

    4 Saleen Speedlab S281SC Rear Wing Kit Installation Guide for 2005 Mustang Thank you for buying the Saleen Speedlab S281SC Rear Wing Kit for the 2005 Mustang. We appreciate your business, and we hope you enjoy your product. For your benefit, please read the following instructions co mpletely and thoroughly before attempting to install the S281SC Re ...

  • Saleen S281SC - page 5

    5 Please Check That All of The Follo wing Parts, In Their Specified Quantities, Are In The Box You Received From Saleen: OBTAIN THE FOLLOWING TOOLS: • Drill • 1/8” bit • 5/16” bit • Torque seal • Center punch • Electric dremel • Carbide dremel bit • 7/16” angled gear wrench • ¼” drive ratchet • ¼” drive 7/16” socke ...

  • Saleen S281SC - page 6

    6 Order of Operations: 1. The two boxes in Figure 1 show the location of the holes that will be drilled in the deck lid to mount the rear wing. 2. Figure 2 shows the wing as it is shipped, with the studs installed. The studs will go into the holes you will drill in the deck lid. 3. Figure 3 is a close-up of the passenger side of the wing. You will ...

  • Saleen S281SC - page 7

    7 Figure 5 1 ¼” Figure 6 7/8” 1 ½” 7/8” Front of car Front of car Figure 7 Studs Holes in deck lid 5. Mark each rearward, outboard hole location for the wing studs with a center punch. Mark the passenger side hole (hole “B” in Figure 4) 1 ¼” in from the passenger side outboard edge of the deck lid, and 7/8” forward from the outbo ...

  • Saleen S281SC - page 8

    8 Figure 8 10. Secure the deck lid in an open position so it is a few inches above the tail light assemblies – this is to p rotect all trunk innards during hole dr illing. (Figure 8) 11. Drill 1/8” pilot holes at the marked locations in the deck lid, then open the holes up to 5/16”. 12. Using the electric dremel with a carbide tip, open up th ...

  • Saleen S281SC - page 9

    9 14. Using paint thinner, clean around the bottom side of the wing in the raised portion around the studs (clean the area indicated by the dotted line in Figure 13). 15. Apply automotive adhesion promoter (3M# 06396) around the base of the studs; follow the dotted line in Figu re 13. 16. Cut sections of tape to form a perimeter around the studs. D ...

  • Saleen S281SC - page 10

    10 Figure 17 Figure 16 Figure 18 Studs Holes in deck lid 18. Before installing the wing, make sure the number of studs in the wing equals the number of holes drilled in the deck lid. Do a test fit to m ake sure all the holes li ne up. (Figure 16) 19. Apply adhesive promoter to the top of the deck lid around both sets of four holes. Follow the patte ...

  • Saleen S281SC - page 11

    11 Figure 19 Figure 20 SC Wing Driver side Acorn nuts Deck lid 22. With the deck lid just partially open (so the wing doesn’t fall out), secure four outboard studs of wing (two per side) with one washer (00- 9004-C11804*) and one acorn hex nut (00-9003-C11802*; use red Loctite). (Driver side nuts shown in Figure 20). Torque the nuts to 5 lb-ft. 2 ...

  • Saleen S281SC - page 12

    12 Fi g ure 24 Figure 23 Tighten nut in here 26. Place one washer (00-9004- C11804*) and one hex nut (00- 9003-C11803*; use red Loctite) over each (2 total) of the furthest inboard studs (those that are not easily visible) and tighten with an angled ratcheting 7/16” wrench (Figure 23 is a close-up of Figure 22; Figure 24 is a view of the inside o ...

Manufacturer Saleen Category Automobile Parts

Documents that we receive from a manufacturer of a Saleen S281SC can be divided into several groups. They are, among others:
- Saleen technical drawings
- S281SC manuals
- Saleen product data sheets
- information booklets
- or energy labels Saleen S281SC
All of them are important, but the most important information from the point of view of use of the device are in the user manual Saleen S281SC.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Saleen S281SC, service manual, brief instructions and user manuals Saleen S281SC. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Saleen S281SC.

Similar manuals

A complete manual for the device Saleen S281SC, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Saleen S281SC by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Saleen S281SC.

A complete Saleen manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Saleen S281SC - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Saleen S281SC, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Saleen S281SC, that we can find in the current document
3. Tips how to use the basic functions of the device Saleen S281SC - which should help us in our first steps of using Saleen S281SC
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Saleen S281SC
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Saleen S281SC in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Saleen S281SC?

Use the form below

If you did not solve your problem by using a manual Saleen S281SC, ask a question using the form below. If a user had a similar problem with Saleen S281SC it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)