English dropdown-ico

Manual Primera Signature, Inscripta rinter Autoloader

18 pages 0.37 mb
Download

Go to site of 18

Summary
  • Primera Signature, Inscripta rinter Autoloader - page 1

    Operator’s Manual For Use With the Signature ® III CD Color Printer or Inscripta™ Thermal CD Printer Two Carlson Parkway North • Plymouth, MN 55447-4446 U.S.A. Phone: 1-800-797- 2772 • 763-475-6676 • FAX: 763-475-6677 Internet: www.primeratechnology.com ...

  • Primera Signature, Inscripta rinter Autoloader - page 2

    2 ...

  • Primera Signature, Inscripta rinter Autoloader - page 3

    3 © 2000 All rights reserved. Notices: The information in this document is subject to change without notice. NO WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. No liability is assumed for errors contained herein or for incident ...

  • Primera Signature, Inscripta rinter Autoloader - page 4

    4 For Users in Canada: This digital apparatus does not exceed the Class B limits for radio noise for digital apparatus set out on the Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la clas ...

  • Primera Signature, Inscripta rinter Autoloader - page 5

    5 Table of Contents SECTION 1: GETTING STARTED A. Introduction ........................................................................................................... 6 B. Choosing a Good Location ....................................................................................... 6 C. Unpacking and Inspection ............................... ...

  • Primera Signature, Inscripta rinter Autoloader - page 6

    6 SECTION 1 : GETTING STARTED A. Introduction Thank you . . . . . . for purchasing a Conductor Printer Autoloader. This device automates the transport of up to 50 optical discs (CD-R, DVD-R, etc.) per batch into and out of a Primera Technology Signature III CD Color Printer or Inscripta Thermal CD Printer. Designed for reliable, unattended operatio ...

  • Primera Signature, Inscripta rinter Autoloader - page 7

    7 Front Panel and Top Ink Jet CD Printer Robotic Arm Input Bin LED Status Light Pick Button Sequence Button Pause Button Control Panel Output Bin CD Printer Tray Figure 1: Conductor and Signature III CD Color Printer Thermal CD Printer Robotic Arm Input Bin LED Status Light Pick Button Sequence Button Pause Button Control Panel Output Bin CD Printe ...

  • Primera Signature, Inscripta rinter Autoloader - page 8

    8 Rear Panel This illustration shows the input ports found on the rear panel of Conductor: Power Input Por t Printer Control Por t Control Port SCSI Por t Figure 3: Rear Panel of Conductor Please note that the SCSI port is not installed on your Conductor. Instead, a metal blank-off plate has been put in its place. The Control Port is installed but ...

  • Primera Signature, Inscripta rinter Autoloader - page 9

    9 SECTION 2: HARDWARE AND CABLE SET-UP A. Connecting the Parts and Interface Cables Follow these steps to integrate your autoloader and printer: 1. In the Conductor shipping box you will find the Input and Output Bins. Place the Bins in their correct places as shown in Figure 1. Depending upon which printer you are using, you’ll see that the loca ...

  • Primera Signature, Inscripta rinter Autoloader - page 10

    10 1 2 Figure 6: Attaching the Printer Stand Make sure that the Printer Control Cable is routed neatly out the back of the Printer Stand so that it can be connected to your printer. If you are using the Inscripta Thermal CD Printer, you will also need to install a Tray Support Bracket to the top cabinet of the Conductor. Follow the instructions pac ...

  • Primera Signature, Inscripta rinter Autoloader - page 11

    11 6. Connect the other end of the Printer Control Cable to the printer’s rear-panel 6-pin mini-DIN port. Figure 9: Connecting the Printer Control Cable 7. Connect both ends of the Parallel Cable. One end is connected to the Parallel Input Port on the rear panel of the printer. The other end is connected to your PC’s Parallel Printer Output Por ...

  • Primera Signature, Inscripta rinter Autoloader - page 12

    12 B. Hardware Test 1. Load the Input Bin with at least 4-5 CDs and place the output bin in the proper location. Figure 12 : Loading CDs 2. Press the Sequence Button on Conductor’s front panel. The Robotic Arm will swing over to and above the Input Bin. 3. Press the Pick Button. The Robotic Arm will pick up a CD. 4. Press the Sequence Button agai ...

  • Primera Signature, Inscripta rinter Autoloader - page 13

    13 NOTE TO USERS OF SIGNATURE AND SIGNATURE II CD COLOR PRINTERS: Due to a slight difference in CD Tray length between these earlier models, the instructions for adjusting the printer on the Printer Stand may not lead you to a perfect alignment. As an alternative to the procedure explained in the printer stand instruction sheet, simply remove the a ...

  • Primera Signature, Inscripta rinter Autoloader - page 14

    14 SECTION 3: INTERPRETING THE LED STATUS LIGHTS The LED Status Lights, located on Conductor’s front panel, can tell you a lot about what is happening at any given moment with the operation of the autoloader. To accurately interpret what is meant when the lights are on, off or flashing, refer to the following chart: A. Power LED Status Condition ...

  • Primera Signature, Inscripta rinter Autoloader - page 15

    15 SECTION 4: MAINTENANCE AND TROUBLESHOOTING Conductor is designed to operate for extended periods of time with very little attention. In fact, no regular maintenance is recommended other than cleaning the outside case. IMPORTANT: Do NOT attempt to oil or grease the Duplicator’s Robotic Arm shaft or other components. You will likely cause more h ...

  • Primera Signature, Inscripta rinter Autoloader - page 16

    16 SECTION 5: TECHNICAL SPECIFICATIONS Model Conductor Printer Au toloader Robotics Controlled by Primera Technology Signature, Signature II or Signature III CD Color Printers or Inscripta Thermal CD Printer Minimum System Pentium II/III or Celeron Processor (or equivalent) at 233 MHz or higher, 32MB RAM, one free ECP parallel printer port, 2MB ava ...

  • Primera Signature, Inscripta rinter Autoloader - page 17

    17 INDEX Bins Input ..................................................................................................................... 7, 9 , 12, 13 Output ................................................................................................................... 7, 9, 12, 13 Buttons Pause ................................................ ...

  • Primera Signature, Inscripta rinter Autoloader - page 18

    18 Tech Support ............................................................................................................................. 15 Tray Support Bracket .................................................................................................................. 10 Unpacking ........................................................ ...

Manufacturer Primera Category Printer

Documents that we receive from a manufacturer of a Primera Signature, Inscripta rinter Autoloader can be divided into several groups. They are, among others:
- Primera technical drawings
- Signature, Inscripta rinter Autoloader manuals
- Primera product data sheets
- information booklets
- or energy labels Primera Signature, Inscripta rinter Autoloader
All of them are important, but the most important information from the point of view of use of the device are in the user manual Primera Signature, Inscripta rinter Autoloader.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Primera Signature, Inscripta rinter Autoloader, service manual, brief instructions and user manuals Primera Signature, Inscripta rinter Autoloader. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Primera Signature, Inscripta rinter Autoloader.

Similar manuals

A complete manual for the device Primera Signature, Inscripta rinter Autoloader, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Primera Signature, Inscripta rinter Autoloader by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Primera Signature, Inscripta rinter Autoloader.

A complete Primera manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Primera Signature, Inscripta rinter Autoloader - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Primera Signature, Inscripta rinter Autoloader, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Primera Signature, Inscripta rinter Autoloader, that we can find in the current document
3. Tips how to use the basic functions of the device Primera Signature, Inscripta rinter Autoloader - which should help us in our first steps of using Primera Signature, Inscripta rinter Autoloader
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Primera Signature, Inscripta rinter Autoloader
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Primera Signature, Inscripta rinter Autoloader in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Primera Signature, Inscripta rinter Autoloader?

Use the form below

If you did not solve your problem by using a manual Primera Signature, Inscripta rinter Autoloader, ask a question using the form below. If a user had a similar problem with Primera Signature, Inscripta rinter Autoloader it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)