Manual Desa CD36M(-1)(-2)

19 pages 3.2 mb
Download

Go to site of 19

Summary
  • Desa CD36M(-1)(-2) - page 1

    This fireplace is manufactured for Stylecrest Inc. under the Coleman brand nam e by DESA International Inc. DESA INTERNATIONAL 2701 INDUSTRIAL DRIVE P/N 109194-01 P.O. BOX 90024 REV D BOWLING GREEN, KY 42101-9004 10/02 www.desatech.com SAVE THIS BOOK This book is valuable. In addition to inst ructing you on how to install and ma intain y our applia ...

  • Desa CD36M(-1)(-2) - page 2

    - 1 - For more information, visit www.desatech.com CONTENTS 1. INTRODUCTION ------------------------------------------------------------ PG. 2 2. SELECTING LOCATION ------------------------------------------------------------- PG. 2 3. MINIMUM CLEARANCES ------------------------------------------------------------- PG. 3 4. VENT PIPE AND TERM. C LE ...

  • Desa CD36M(-1)(-2) - page 3

    -2 - For more information, visit www.desatech.com INTRODUCTION Models CD32M series, CD36M seri es and CD42M are heat circulating gravity direct vent gas fireplaces with sealed combustion chamber. These fireplaces use millivolt gas control valve and millivolt ignition system. These fireplaces are convertible with the standard setup as natural gas. C ...

  • Desa CD36M(-1)(-2) - page 4

    -3 - For more information, visit www.desatech.com In selecting a location, the following precautions m ust be observed:  Do not connect this appli a nce to a chimney system used for solid fuel burning fireplace.  Due to high temperat ures, do not locate this ap pliance in high traffic areas or near furniture and draperies.  Never obstruct ...

  • Desa CD36M(-1)(-2) - page 5

    -4 - For more information, visit www.desatech.com VENT PIPE AND TERMINATION CLEARANCES The final position of your appl iance depends on the location of th e term ination in relation to the clearances that must be obse rved. A= 12” (305mm ) clearance above grade, veranda, porch, deck or balcony. *** B= 9” (229mm) clearance in U.S. and 12” (305 ...

  • Desa CD36M(-1)(-2) - page 6

    -5 - For more information, visit www.desatech.com VENT INSTALLATION INSTRUCTIONS 1. Install pipe to fireplace collar adapter located on back of unit at a 45 deg. Angle. Connect our starting pipe to a 45 deg. Starting section by sliding it over the collar adapter on the fireplace. Twist-lock for proper installation check t o insure proper connection ...

  • Desa CD36M(-1)(-2) - page 7

    -6 - For more information, visit www.desatech.com Refer to the following table fo r clearance between roof and termination. FRAMING Once the final location has been determ ined (observing clearances for vent terminati on), you may construct framing using dimensi ons shown in figures 8 and 9, depending on the particular installation. If the applianc ...

  • Desa CD36M(-1)(-2) - page 8

    -7 - For more information, visit www.desatech.com The remote control receiver is factory wired and connected to the convertible gas valve as shown in figure 11. GAS SUPPLY TESTING NOTE : This section is intended as a guide for quali fied technicians installing g as to the appliance. The appliance and its indivi dual shut-off valve must be disconnec ...

  • Desa CD36M(-1)(-2) - page 9

    -8 - For more information, visit www.desatech.com Install a sediment trap between the incoming gas line and the gas control box (see figure 15). The sedim ent trap should extend down a mini mum of 3 i nches (76 mm) bey ond the center of the pipe. When routing gas line through conduit sl eeve, make sure to repack insulation to fill gaps between gas ...

  • Desa CD36M(-1)(-2) - page 10

    - 9 - For more information, visit www.desatech.com GLASS PANEL REMOVAL Before proceeding, make sure gas control valve is in the “OFF” position. 1. To remove louvers, pull both spri ng latches (located in each end of louver) towards center of appliance simultaneously until diseng aged from locating holes. Repeat for bottom end spring latches and ...

  • Desa CD36M(-1)(-2) - page 11

    - 10 - For more information, visit www.desatech.com • Place log #6 (left log) onto le ft pin of front log (#2) and the smooth surface of rear log (#3). Make sure it is seated properly. • Place log #7 onto right pin of top log (#5). Make sure it is seated properly. NOTICE : Do not put lava rock on or under the burner. Placing lava rock on burner ...

  • Desa CD36M(-1)(-2) - page 12

    - 11 - For more information, visit www.desatech.com ...

  • Desa CD36M(-1)(-2) - page 13

    - 12 - For more information, visit www.desatech.com CONVERSION KIT This conversion kit is packaged wit h the unit. Please check the contents before beginning t his conversion. • Before proceeding, make sure the gas control valve is in the “OFF” position and all electrical power to the appliance is turned off. • Wait five minutes to clear ou ...

  • Desa CD36M(-1)(-2) - page 14

    - 13 - For more information, visit www.desatech.com • Install the identification label enclosed with th e gas valve regulator to the valve body where i t can easily be seen (see figure 23). FACE EXTENSION (FOR MODEL CD32M ONLY) Model CD32M comes equipped with a front face extension. The front face extension would a dd 3- ½” to the width and ¾ ...

  • Desa CD36M(-1)(-2) - page 15

    - 14 - For more information, visit www.desatech.com OBSERVED PROBLEM POSSIBLE CAUSE REMEDY • Pilot will not stay lit after carefully following ligh ting instructions. • Pilot lit but no flame on the burner. • Frequent pilot outage problem . • Defective pilot generator (thermocouple). • Remote or wires defective. • Thermopile/ Thermocoup ...

  • Desa CD36M(-1)(-2) - page 16

    - 15 - For more information, visit www.desatech.com ILLUSTRATED PARTS BREAKDOWN MODELS CD32M AND CD36M SERIES ...

  • Desa CD36M(-1)(-2) - page 17

    - 16 - For more information, visit www.desatech.com ILLUSTRATED PARTS BREAKDOWN MODEL CD42M ...

  • Desa CD36M(-1)(-2) - page 18

    - 17 - For more information, visit www.desatech.com ILLUSTRATED PARTS LIST ITEM DESCRIPTION Q TY. CD32M CD36M CD42M 1 108878-01 108008-01 108326-01 FIREBOX ASSEMBLY 1 2 108874-01 108009-01 108327-01 FACE W ELDMENT 1 3 108892-01 108010-01 1083 28-01 DOOR ASSEMBLY 1 4 108903-01 108011-01 108331-01 PANEL ASSEMBLY LOUVER, FAC E TOP 1 5 108903-02 108011 ...

  • Desa CD36M(-1)(-2) - page 19

    - 18 - For more information, visit www.desatech.com ACCESSORY AND REPLACEMENT PARTS ...

Manufacturer Desa Category Indoor Fireplace

Documents that we receive from a manufacturer of a Desa CD36M(-1)(-2) can be divided into several groups. They are, among others:
- Desa technical drawings
- CD36M(-1)(-2) manuals
- Desa product data sheets
- information booklets
- or energy labels Desa CD36M(-1)(-2)
All of them are important, but the most important information from the point of view of use of the device are in the user manual Desa CD36M(-1)(-2).

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Desa CD36M(-1)(-2), service manual, brief instructions and user manuals Desa CD36M(-1)(-2). Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Desa CD36M(-1)(-2).

A complete manual for the device Desa CD36M(-1)(-2), how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Desa CD36M(-1)(-2) by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Desa CD36M(-1)(-2).

A complete Desa manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Desa CD36M(-1)(-2) - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Desa CD36M(-1)(-2), FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Desa CD36M(-1)(-2), that we can find in the current document
3. Tips how to use the basic functions of the device Desa CD36M(-1)(-2) - which should help us in our first steps of using Desa CD36M(-1)(-2)
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Desa CD36M(-1)(-2)
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Desa CD36M(-1)(-2) in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Desa CD36M(-1)(-2)?

Use the form below

If you did not solve your problem by using a manual Desa CD36M(-1)(-2), ask a question using the form below. If a user had a similar problem with Desa CD36M(-1)(-2) it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)