English dropdown-ico

Manual Yamaha EMX640

16 pages 0.45 mb
Download

Go to site of 16

Summary
  • Yamaha EMX640 - page 1

    POWERED MIXER E Owner’ s Manual Contents Front and rear panel ............................................ 2 Control panel .......................................................... 2 Input/output panel .................................................. 6 Rear panel .............................................................. 7 Connections .... ...

  • Yamaha EMX640 - page 2

    2 Front and rear panel EMX640—Owner’s Manual Front and rear panel Control panel ■ Channel section In this section, y ou can adjust equalization (fre- quency response), volume level, effect and moni- tor output levels for the input signal of each channel. 1 Equalizer controls (HIGH, MID, LOW) This is a 3-band equalizer that adjusts the high fr ...

  • Yamaha EMX640 - page 3

    Control panel 3 EMX640—Owner’s Manual ■ DIGIT AL EFFECT section This section allows y ou to turn the built-in digital effect on/off and to select the effect ty pe. 6 Effect select switch Select the effect ty pe for the built-in digital effect. 7 DIGIT AL EFFECT ON switch W hen this switch is on (pressed), the digital effect built into the EMX ...

  • Yamaha EMX640 - page 4

    4 Front and rear panel EMX640—Owner’s Manual ■ MONITOR section This section allows y ou to adjust the t one and volume of the MONITOR bus, and specify the mix level of the built-in effect. 9 Graphic equalizer This is a 7-band graphic equalizer that allows you to adjust the frequency r esponse of the MONI- T OR bus signal, pr oviding a maximum ...

  • Yamaha EMX640 - page 5

    Control panel 5 EMX640—Owner’s Manual ■ POWER AMP section This section allows y ou to select the signals that will be output from the built-in two-channel powe r amplifier , and t o select the BRIDGE mode. I LIMITER indicator This indicator lights up when the level of the sig- nal output from the po wer amp section re aches the maximum and t ...

  • Yamaha EMX640 - page 6

    6 Front and rear panel EMX640—Owner’s Manual Input/output panel 1 Channel input jacks (Hi-Z, Lo-Z) 1~4 These are the input jacks for channels 1~4. By using the P AD switches (c ontrol panel 5 ) you can connect an y of the jacks to a w ide range of sources fr om mics to line lev el dev ices (synthesiz- ers or rhythm bo x es etc.). The Lo-Z jacks ...

  • Yamaha EMX640 - page 7

    Rear panel 7 EMX640—Owner’s Manual The nominal input level and impedance ar e – 10 dB/600 Ω for the A UX IN jack, and –10 dB V/ 600 Ω for the T APE IN jacks. 6 External output jacks (REC OUT/MONI- TOR/MAIN) These are output jacks which send line lev el sig- nals from the EMX640 t o external devices. A ste- reo rec ording device such as ...

  • Yamaha EMX640 - page 8

    8 Connections EMX640—Owner’s Manual Connections W hen connecting various devices, be sur e to use cables and plugs of the appropriate standar d. ■ Speaker connection There ar e three wa ys in which speakers can be c onnected t o the EMX640; a single speaker each can be c on- nected to either the A or the B jack of POWER AMP 1 and of POWER AMP ...

  • Yamaha EMX640 - page 9

    Basic Operation 9 EMX640—Owner’s Manual Basic Operation This section explains basic operation of the EMX640. Connecting microphones and instruments 1 Before connecting mics or instruments, make sure that the power of all equip- ment (where applicable) is turned off. Also make sure that the level controls of each channel of the EMX640 and the MA ...

  • Yamaha EMX640 - page 10

    10 Example setups EMX640—Owner’s Manual Example setups This section pro vides some ways in which the EMX640 can be used, and explains c onnections and operation. As a conference P A system/installed sound system Her e is an example of using the EMX640 as a conference P A system or as an installed sound system. Connections • Connect mics t o c ...

  • Yamaha EMX640 - page 11

    As a band PA 11 EMX640—Owner’s Manual As a band P A Her e is an example of using the EMX640 as a small P A for a band. In this example, the monitor speakers are being sent a mix that is independent of the MAIN speaker mix. An ext ernal effect such as delay or r everb is also being used. Connections • Connect mics or instruments, such as k eyb ...

  • Yamaha EMX640 - page 12

    12 Example setups EMX640—Owner’s Manual Sending an independent mix to the monitor speakers 1 Set the MONITOR section MASTER con- trol to the √ √ √ √ position. 2 Raise the MONI controls for the channels that you wish to hear from the monitor speakers. 3 Use the graphic equalizers and MASTER controls of the MAIN/MONITOR sections to adjust ...

  • Yamaha EMX640 - page 13

    Specifications 13 EMX640—Owner’s Manual Specifications ■ General specifications Maximum output po wer 200 W/4 Ω @0.5% THD at 1 kHz Frequency response 20 Hz~20 kHz +1 dB, –3 dB @1 W output into 8 Ω (POWER AMP OUT) 20 Hz~20 kHz +1 dB, –3 dB @+4 dB output into 10 k Ω (MAIN OUT , MONIT OR OUT , EFFECT SEND) T otal harmonic distortion ...

  • Yamaha EMX640 - page 14

    14 Specifications EMX640—Owner’s Manual ■ Input specifications ■ Output specifications • All output jacks are unbalanced. • 0 dB=0.775 Vrms, 0 dBV=1 Vrms. Specifications are subject to c hange without pr ior notice. 1. Sensitivity is the lo west lev el that can produce an output of +4 dB (1.23 V) or the nominal output level when the ...

  • Yamaha EMX640 - page 15

    Dimensions 15 EMX640—Owner’s Manual ■ Dimensions ■ Block and Level diagram 470 W: 480 260 H: 275 D: 275 Unit: mm Clipping level EFFECT OUT REC OUT MAIN, MONITOR POWER AMP BRIDGE 30 dB MAIN BRIDGE MAIN MAIN MAIN MONITOR ADD SUM DIGITAL EFFECT TAPE IN AUX IN LINE HI-Z PAD:ON MIC Lo-Z PAD:ON HI-Z PAD:OFF EFFECT RTN EFFECT RTN Lo-Z PAD:OFF EFFE ...

  • Yamaha EMX640 - page 16

    Y AMAHA CORPORA TION VY66080 R2 1 IP 16 Pro Audio Division, #18/3 P .O. Box 3, Hamamatsu, 430-8651, Japan NP Printed in T aiwan FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by ...

Manufacturer Yamaha Category Musical Instrument

Documents that we receive from a manufacturer of a Yamaha EMX640 can be divided into several groups. They are, among others:
- Yamaha technical drawings
- EMX640 manuals
- Yamaha product data sheets
- information booklets
- or energy labels Yamaha EMX640
All of them are important, but the most important information from the point of view of use of the device are in the user manual Yamaha EMX640.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Yamaha EMX640, service manual, brief instructions and user manuals Yamaha EMX640. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Yamaha EMX640.

Similar manuals

A complete manual for the device Yamaha EMX640, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Yamaha EMX640 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Yamaha EMX640.

A complete Yamaha manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Yamaha EMX640 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Yamaha EMX640, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Yamaha EMX640, that we can find in the current document
3. Tips how to use the basic functions of the device Yamaha EMX640 - which should help us in our first steps of using Yamaha EMX640
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Yamaha EMX640
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Yamaha EMX640 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Yamaha EMX640?

Use the form below

If you did not solve your problem by using a manual Yamaha EMX640, ask a question using the form below. If a user had a similar problem with Yamaha EMX640 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)